User manual

ManualsBrandsZanussi ManualsMobile PhonesZWI71000WA

When the degree of hardness is soft, readjust the quantity

of the detergent.

First use

• Ensure that the electrical and water connections

comply with the installation instructions.

• Remove the polystyrene block and any material

from the drum.

• Pour 2 litres of water into the main wash com-

partment

of the detergent drawer in order to

activate the ECO valve. Then run a cotton cycle at

the highest temperature without any laundry in

the machine, to remove any manufacturing resi-

due from the drum and tub. Pour 1/2 a measure

of detergent into the main wash compartment and

start the machine.

Daily use

Load the laundry

Open the door by carefully

pulling the door handle

outwards. Place the laun-

dry in the drum, one item

at a time, shaking them

out as much as possible.

Close the door.

Make sure that no laundry

stays between the seal and

the door. There is a risk of

water leakage or damage

to the laundry.

Measure out the detergent and the fabric softener

Pull out the dispenser drawer until it stops. Measure

out the amount of detergent required, pour it into the

main wash compartment

or in the appropriate com-

partment if the selected programme/option it requires

(see more details in "Detergent dispenser drawer").

If required, pour fabric softener into the compartment

marked

(the amount used must not exceed the

«MAX» mark in the drawer). Close the drawer gently.

Select the required programme by turning the

programme selector dial (1)

Turn the programme selector dial to the required pro-

gramme. The washing machine will automatically select

the maximum spin value provided for the programme you

have chosen. You can change this value by pressing the

corresponding button. The green pilot light of the button 5

starts to flash.

The selector dial can be turned either clockwise or coun-

terclockwise. Turn to position

to reset programme/

Switching the machine off.

At the end of the programme the selector dial must be

turned to position

, to switch the machine off.

Caution! If you turn the programme selector dial to

another programme when the machine is working,

the red pilot light of button 5 will blink 3 times to indicate

a wrong selection. The machine will not perform the new

selected programme.

Select the spin speed or Rinse Hold option by

pressing button 2

The relevant light will light up.