EN User manual Washing Machine ZWI 1125
Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 Product description _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 Control panel _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 Washing Programmes _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 7 Helpful hints and tips _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 9 First use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 10 Daily use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 11 Care and cleaning _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ What to do if… _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Technica
• If the machine is situated on a carpeted floor, please adjust the feet in order to allow air to circulate freely under the appliance. • Always be sure, that there is no water leakage from hoses and their connections after the installation. • If the appliance is installed in a location subject to frost, please read the “dangers of freezing” chapter. • Any plumbing work required to install this appliance should be carried out by a qualified plumber or competent person.
Product description 1 Detergent dispenser drawer 2 Control panel 1 2 3 Door opening handle 4 Rating plate 5 Drain pump 6 Adjustable feet 3 4 5 6 Detergent dispenser drawer Compartment for detergent used for prewash and soak phase or for stain remover used during the stain action phase (if available). The prewash and soak detergent is added at the beginning of the wash programme. The stain remover is added during the stain action phase. Compartment for powder or liquid detergent used for main wash.
1 2 3 4 5 6 7 A B C 1 Programme selector dial 2 SPIN reduction button 5 START/PAUSE button 6 DELAY START button 3 OPTIONS button 4 EXTRA RINSE button 7 Indicator pilot lights Table of symbols Programme selector dial Cottons Wool (Handwash) Economy programme Delicates Cold wash Rinses Synthetics Drain Easy Iron Spin Buttons Lights Spin Rinse Hold Options Prewash Extra Rinse Super Quick Start/Pause Delay start Phase lights / Prewashing or Washing + Rinsing or spinning End 5
Programme selector dial, spin speed button and available options Programme Selector Dial It allows you to switch the appliance on/off and/or to select a programme. Available options: Spin By pressing this button you can change the spin speed of the selected programme or to select Rinse Hold option. Rinse hold By selecting this function the water of the last rinse is not emptied out to prevent the fabrics from creasing. Before opening the door it will be necessary to empty out the water.
Washing Programmes Programme Maximum and Minimum Temperature Cycle Description Maximum Spin Speed Maximum Fabrics Load Type of Laundry Options COTTONS 90° - 60° Main wash - Rinses Maximum spin speed at 1200 rpm Max. load 6 kg - Reduced load 3 kg 1) White cotton (heavily or normally soiled items). SPIN REDUCTION RINSE HOLD PREWASH 2) SUPER QUICK EXTRA RINSE COTTON + ECO 60° Main wash - Rinses Maximum spin speed at 1200 rpm Max. load 6 kg STANDARD PROGRAMME for the Energy Label consumption values.
Programme Maximum and Minimum Temperature Cycle Description Maximum Spin Speed Maximum Fabrics Load Type of Laundry Options SYNTHETICS 60° - 40° - 30° - Cold Main wash - Rinses Maximum spin speed at 900 rpm Max. load 3 kg - Reduced load 1.5 kg 1) Synthetic or mixed fabrics: underwear, coloured garments, non-shrink shirts, blouses. SPIN REDUCTION RINSE HOLD PREWASH 2) SUPER QUICK EXTRA RINSE EASY IRON 40° Main wash - Rinses Maximum spin speed at 900 rpm Max.
Programme Maximum and Minimum Temperature Cycle Description Maximum Spin Speed Maximum Fabrics Load Type of Laundry Options Detergent Compartment DRAIN Draining of water Max. load 6 kg For emptying out the water of the last rinse in programmes with the Rinse Hold option set. SPIN Drain and long spin Maximum spin speed at 1200 rpm Max. load 6 kg Separate spin for hand washed cotton garments and after programmes with the Rinse Hold option selected.
Grass: soap lightly and treat with bleach (whites and fast coloureds only). Ball point pen and glue: moisten with acetone1), lay the garment on a soft cloth and dab the stain. Lipstick: moisten with acetone as above, then treat stains with methylated spirits. Treat any residual marks with bleach. Red wine: soak in water and detergent, rinse and treat with acetic or citric acid, then rinse. Treat any residual marks with bleach.
Daily use Load the laundry Open the door by carefully pulling the door handle outwards. Place the laundry in the drum, one item at a time, shaking them out as much as possible. Close the door. Make sure that no laundry stays between the seal and the door. There is a risk of water leakage or damage to the laundry. Measure out the detergent and the fabric softener corresponding button. The green pilot light of the button 5 starts to flash.
– the machine starts its hourly countdown. – The programme will start after the selected delay has expired. Cancelling the delayed start after having started the programme: 1. Set the washing machine to PAUSE by pressing button 5. 2. Press button 6 once, the light relevant to the selected delay goes off 3. Press button 5 again to start the programme. The Delay Start can not be selected with DRAIN programme. Important! The selected delay can be changed only after selecting the washing programme again.
Care and cleaning Warning! You must DISCONNECT the appliance from the electricity supply, before you can carry out any cleaning or maintenance work. Replace the drawer and run the rinse programme without any clothes in the drum. Descaling Cleaning the pump The water we use normally contains lime. It is a good idea to periodically use a water softening powder in the machine. Do this separately from any laundry washing, and according to the softening powder manufacturer's instructions.
Remove foreign bodies and fluff from the filter seat and from the pump impeller. Check carefully whether the pump impeller rotates (it rotates jerkily). If it doesn’t rotate, please contact your Service Centre. Put the cap back on the emergency emptying hose and place the latter back in its seat. Replace the filter into the pump by inserting it correctly into the special guides. Screw the pump cover firmly by turning it clockwise.
• if necessary, wait until the water has cooled down; • open the pump door; • place a bowl on the floor and place the end of the emergency emptying hose into the bowl. Remove its cap. The water should drain by gravity into the bowl. When the bowl is full, put the cap back on the hose. Empty the bowl.
Problem Possible cause/Solution The machine does not fill: The water tap is closed (the button 5 red light blinks). • Open the water tap. The inlet hose is squashed or kinked (the button 5 red light blinks). • Check the inlet hose connection. The filter in the inlet hose or the inlet valve filter are blocked (the button 5 red light blinks). • Clean the water inlet filters. (See "Cleaning the water inlet filters" for more details). The door is not properly closed (the button 5 red light blinks).
Problem Possible cause/Solution The door will not open: The programme is still running. • Wait the end of washing cycle. The door lock has not been released. • Wait a few minutes before opening the door. There is water in the drum. • Select drain or spin programme to empty out the water. The machine vibrates is noisy: The transit bolts and packing have not been removed. • Check the correct installation of the appliance.
Technical data Dimensions Width / Height / Depth 60 / 85 / 54 mm Electrical connection Voltage Overall power Fuse Frequency 230 V 2200 W 10 A 50 Hz Water supply pressure Minimum Maximum 0,5 bar (0,05 MPa) 8 bar (0,8 MPa) Level of protection against ingress of solid particles and moisture IPX4 Water supply 1) Cold water Maximum Load Cotton 6 kg Spin Speed Maximum 1200 rpm 1) Connect the water inlet hose to a water tap with a 3/4'' thread.
After removing all the packaging, carefully lay machine on it's back to remove the polystyrene base from the bottom. Level the washing machine by raising or lowering the feet. The feet may be tight to adjust as they incorporate a self locking nut, but the machine MUST be level and stable. If necessary, check the setting with a spirit level. Remove the power supply cable and the hoses from the hose holders on the rear of the appliance. Any necessary adjustment can be made with a spanner.
Connect the hose to a tap with a 3/4” thread. Always use the hose supplied with the appliance. Hooked over the edge of a sink using the plastic hose guide supplied with the machine. In this case, make sure the end cannot come unhooked when the machine is emptying. This could be done by tying it to the tap with a piece of string or attaching it to the wall. 35° 45° The other end of the inlet hose which connects to the appliance can be turned as showed in the picture.
35 Ø 12,5-14 depth 16-22 600 min. 560 596 555 min. 820 C 416 176,5 416 75 60 818 22±1,5 170 100 A C When installing the appliance into the kitchen furniture ensure, if possible, the hoses are placed in either of the two recesses on the back of the appliance. This will help to prevent the hoses from becoming kinked or trapped.
6 4 6 4 5 8 1 7 3 D E Caution! Do not remove the screw 8 ! d) Counter-magnet (6) The appliance is prearranged for a magnetic closure of the door. To enable a correct operation of this device, it is necessary to screw the counter-magnet (6) (steel disk + rubber ring) into the inner side of the door. Its position must correspond to the magnet (4) on the appliance (see picture D).
• Measure out detergent according to the water hardness, the degree of soiling and the quantity of laundry being washed.
132928210-A-462011 www.zanussi.