EN User manual Washing Machine ZWH 7120 P ZWH 7140 P ZWH 7160 P
Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 Frost precaution _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 Environment concerns _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 Product description _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 5 Technical data _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 5 Installation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 6 First use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 10 Personalisation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Daily use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Wash
• • • • • • • • • • • not pressing the electrical supply cable against the wall. Install the appliance on a flat hard floor. Never place cardboard, wood or similar materials under the appliance to compensate for any unevenness in the floor. If the appliance is situated on a carpeted floor, please adjust the feet in order to allow air to circulate freely under the appliance. Check that the appliance does not touch the wall or other kitchen units.
To activate this device, rotate the button (without pressing it) inside the door clockwise until the groove is horizontal. If necessary use a coin. To disable this device and restore the possibility of closing the door, rotate the button anti-clockwise until the groove is vertical. Frost precaution If the appliance is installed in a place where the temperature could drop below 0°C, proceed as follows to remove any water remaining inside the appliance: 1. unplug the appliance; 2. turn off the water tap; 3.
>PP<=polypropylene This means that they can be recycled by disposing of them properly in appropriate collection containers. Ecological hints To save water, energy and to help protect the environment, we recommend that you follow these tips: • Normally soiled laundry may be washed without prewashing in order to save detergent, water and time (the environment is protected too!). • The machine works more economically if it is fully loaded.
Electrical connection Information on the electrical connection is given on the rating plate, on the inner edge of the appliance door. Water supply pressure Minimum Maximum 0,05 MPa 0,8 MPa Maximum Load Cotton 7 kg Spin Speed Maximum 1200 rpm (ZWH 7120 P) 1400 rpm (ZWH 7140 P) 1600 rpm (ZWH 7160 P) Installation Unpacking • Remove the external film. Use a cutter, if necessary. Warning! • Read carefully the "Safety information" chapter before installing the appliance.
• Return appliance to it's upright position. • Open the door and remove the plastic hose guide, the bag containing the instruction booklet and the plastic plug caps from the drum. • Unscrew the three bolts (A) and remove the hose holders (C). • Slide out the relevant plastic spacers (B). Warning! Do not remove the drain hose from the rear support. Remove this hose only if it is necessary to drain the water. Refer to "Frost precaution" and "What to do if".
Positioning and levelling 35° 45° Loosen the ring nut to angle the hose to the left or right depending on the position of your water tap. Do not place the inlet hose downwards. After positioning the inlet hose, be sure to tighten the ring nut again to prevent leaks. Water drainage x4 Level the appliance by raising or lowering the feet. The appliance MUST be level and stable on a flat hard floor. If necessary, check the setting with a spirit level. Any necessary adjustment can be made with a spanner.
If your drain hose looks like this (see beside) you do not require the “U” piece”. Just push the hose firmly in to the standpipe. Push the drain hose onto the spigot and secure with a clip, ensure a loop is formed in the drain hose to prevent waste from the sink entering the appliance. • Directly to a built-in drain pipe in the room wall. If the outlet spigot has not been used before, remove any blanking plug that may be in place.
In the interest of the environment Electrical connection The appliance should be connected to the FOUL drainage system, the water will then be taken to a sewage works for treatment before being discharged safely into a river. It is essential that these appliances are not connected to the surface water drainage system as this water is discharged directly into a river or stream and may cause pollution. If you require any further advice please contact your local water authority.
By pressing these 2 buttons again, the acoustic signal is reactivated. Child safety lock This device permits you to leave the appliance unattended so you do not need to worry that children might be injured by or cause damage to the appliance. This function remains enabled also when the appliance is not working. There are two different ways to set this option: 1. Before pressing button 9: it will be impossible to start the appliance. 2.
Open the door by carefully pulling the door handle outwards Load the laundry Place the laundry in the drum, one item at a time, shaking them out as much as possible. Maximum Loads Recommended loads are indicated in the «Washing Programmes». General rules: • Cotton, linen: drum full but not too tightly packed; • Synthetics: drum no more than half full; • Delicate fabrics and woollens: drum no more than one third full.
SH • Rotate the flap downwards. • Carefully put the drawer back. PU RE TO MOV CL E EA N SH DOWN - Flap position if using LIQUID detergent during main wash PU RE TO MOV CL E EA N UP- Flap position if using POWDER detergent • Measure out the detergent. If the flap is not in the desired position: For the quantity of detergent, refer always to what is written on the product packing and ensure that the detergent can be poured in the drawer.
Set your washing programme The control panel permits to select a washing programmes and different options. When an option button is selected, the corresponding pilot light is on. Otherwise it is off. Err. For compatibility among washing programmes and options, see the "Washing Programmes".
2 Temperature button Push the temperature button to select the most suitable temperature for washing your laundry. Cold: Cold wash. 3 Spin reduction By selecting a programme, the appliance proposes automatically the maximum spin speed provided for that programme. Press this button repeatedly to change the spin speed, if you want your laundry to be spun at a different speed. The relevant light illuminates. 4 Rinse Hold By pressing this button the corresponding pilot light illuminates.
7 Display 7.1 7.2 7.3 The display shows the following information: 7.1 Delay Start icon 7.2 Child safety lock This device permits you to leave the appliance unattended during it's functioning. 7.3 • Duration of the selected programme After selecting a programme, the duration is displayed in hours and mi). The duration is calculated automatically on nutes (for example the basis of the maximum recommended load for each type of fabric.
Cancelling the Delay Start after having started the programme: • Set the appliance to PAUSE by pressing button 9. • Press button 8 once. On the display will appear '. • Press button 9 again to start the programme. • The selected delay can be changed only after selecting the washing programme again. • The door will be locked throughout the delay time. If you need to open the door, you must first set the appliance to PAUSE by pressing button 9 and wait a few minutes before opening the door.
At the end of the programme The appliance stops automatically. The pilot light of the button 9 and the pilot light 10 go off. The display shows . If a programme or an option that ends with water left in the tub has been selected, the pilot light 10 remains on and the door is locked to indicate that the water must be emptied out before opening the door. Follow the below instructions to empty out the water: • Turn the programme selector dial to . • Select the draining or spinning programme.
Programme - Maximum and Minimum Temperature - Cycle Description - Maximum Spin Speed - Maximum Fabrics Load - Type of Laundry Options COTTONS ECONOMY 60° - 40° Main wash - Rinses - Maximum spin speed at: 1200 rpm for model ZWH 7120 P; 1400 rpm for model ZWH 7140 P; 1600 rpm for model ZWH 7160 P Max. load 7 kg White and coloured cotton. This programme can be selected for slightly or normally soiled cotton items. The temperature will decrease and the washing time will be extended.
Programme - Maximum and Minimum Temperature - Cycle Description - Maximum Spin Speed - Maximum Fabrics Load - Type of Laundry Options WOOL / HANDWASH 40°- Cold Main wash - Rinses - Maximum spin speed at: 1200 rpm for model ZWH 7120 P; 900 rpm for model ZWH 7140 P and for model ZWH 7160 P Max. load 2 kg Machine washable wool, hand washable woollens and delicate fabrics with «hand washing» care symbol. Note: A single or bulky item may cause imbalance.
Programme - Maximum and Minimum Temperature - Cycle Description - Maximum Spin Speed - Maximum Fabrics Load - Type of Laundry Options BLANKET 30° Main wash - Rinses - Maximum spin speed at 700 rpm Special programme for one sleeping bag, one duvet or two pillow cases or washable coats padded with synthetic filling or dawns. The Extra Rinse option is activated automatically. DELAY START MINI 30 30° Main wash - Rinses - Maximum spin speed at 700 rpm Max. load 3 kg Synthetics and delicates.
They agree with EN60456. The actual water temperature may differ from the declared cycle temperature. Care and cleaning Warning! Switch the appliance off and remove the mains plug from the socket before any cleaning action. Maintenance Wash With the use of low temperature washes it is possible to get a build up of residues inside the drum. We recommend that a maintenance wash be performed on a regular basis. To run a maintenance wash: • The drum should be empty of laundry.
• turn the drum and align the filter cover (FILTER) with the arrow on the door seal; • open the filter cover by pressing the special hook and by rotating the cover upwards; Warning! Keep the filter cover open until the filter removal. • before removing the filter, remove any fluff or small objects from around the filter; The filter is inserted correctly when the indicator on its top is visible and blocked. • close the filter cover; • insert the mains plug again.
• Screw the hose back onto the tap. Make sure the connection is tight. • Unscrew the hose from the appliance. Keep a towel nearby because some water may flow. • Clean the filter in the valve with a stiff brush or with the piece of cloth. • Screw the hose back to the appliance and make sure the connection is tight. • Turn on the water tap. What to do if… The appliance does not start or stops during operation.
Fault code and malfunction Possible cause / Solution The drain hose is squashed or kinked. • Check the drain hose connection. The drain filter is clogged.
Malfunction Possible cause / Solution The appliance does not start: The plug is not properly inserted in the power socket. • Insert the plug into the power socket. There is no power at the socket. • Please check your domestic electrical installation. The main fuse has blown. • Replace the fuse. The programme selector dial is not correctly positioned and the button 9 has not been pressed. • Please turn the selector dial and press the button 9 again. The delay start has been selected.
Malfunction The appliance vibrates noisily: Possible cause / Solution The transit bolts and packing have not been removed. • Check the correct installation of the appliance. The appliance is not levelled correctly. • Adjust the feet. The laundry is not evenly distributed in the drum. • Redistribute the laundry. Maybe there is very little laundry in the drum. • Load more laundry. The electronic unbalance detection device has cut in because the laundry is not evenly distributed in the drum.
Mod Prod . ... . No. ... ... ... ... .. Ser. No. ... ... ... The necessary data for the service centre is on the rating plate. We recommend that you write the data here: Mod. ... ... ... Prod. No. ... ... ... Ser. No. ... ... ... Model description (MOD.) ............................... Product number (PNC) ............................... Serial number (S.N.) ...............................
192987380-A-092011 www.zanussi.