User manual

Altering an option or a running programme
It is possible to change some options before the pro-
gramme carries them out.
Before you make any change, you must pause the washing
machine by pressing button 7 .
Changing a running programme is possible only by re-
setting it. Turn the programme selector dial to
and
then to the new programme position. Start the new pro-
gramme by pressing button 7 again.
The washing water in the tub will be not emptied out.
Interrupting a programme
Press the button 7 to interrupt a programme which is
running, the corresponding pilot light starts blinking.
Press the button again to restart the programme.
Cancelling a programme
Turn the selector dial to to cancel a programme which
is running. Now you can select a new programme.
Opening the door after the programme has started
First set the machine to pause by pressing the button 7 .
If the pilot light 9 blinks and after a few minutes goes off,
the door can be opened.
If the pilot light 9 remains lit, this means that the machine
is already heating or that the water level is too high. In
any case, do not try to force the door!
If you cannot open the door but you need to open it, you
have to switch the machine off by turning the selector dial
to
. After a few minutes the door can be opened
(Pay attention to the water level and temperature!).
After closing the door, it is necessary to select the pro-
gramme and options again and to press button 7 .
At the end of the programme
The machine stops automatically. Some acoustic signals
sound and a blinking
appears on the display, the pilot
light of button 7 and the pilot light 9 go off.
If a programme or an option that ends with water left in
the tub has been selected, the pilot light 9 remains on and
the door is locked to indicate that the water must be emp-
tied out before opening the door.
Follow the below instructions to empty out the water:
1.
Turn the programme selector dial to
.
2. Select the draining or spinning programme.
3. Reduce the spin speed if needed, by pressing the
relevant button.
4. Press button 7 .
At the end of the programme, the door is released and can
be opened. Turn the programme selector dial to
to
switch the machine off.
Remove the laundry from the drum and carefully check
that the drum is empty. If you do not intend to carry out
another wash, close the water tap. Leave the door open to
prevent the formation of mildew and unpleasant smells.
Care and cleaning
Warning! You must DISCONNECT the appliance
from the electricity supply, before you can carry out
any cleaning or maintenance work.
Descaling
The water we use normally contains lime. It is a good idea
to periodically use a water softening powder in the ma-
chine. Do this separately from any laundry washing, and
according to the softening powder manufacturer's in-
structions. This will help to prevent the formation of lime
deposits.
External cleaning
Clean the exterior cabinet of the appliance with soap and
water only, and then dry thoroughly.
Cleaning the dispenser drawer
The washing powder and additive dispenser drawer
should be cleaned regularly.
14