EN User manual Washing Machine ZWH 6100P ZWH 6120P
Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 Frost precaution _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 Environment concerns _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 Product description _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 5 Technical data _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 6 Installation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 6 Special accessories _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 10 First use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Daily use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Wash
• • • • • • • • • • • not pressing the electrical supply cable against the wall. Install the appliance on a flat hard floor. Never place cardboard, wood or similar materials under the appliance to compensate for any unevenness in the floor. If the appliance is situated on a carpeted floor, please adjust the feet in order to allow air to circulate freely under the appliance. Check that the appliance does not touch the wall or other kitchen units.
To activate this device, rotate the button (without pressing it) inside the door clockwise until the groove is horizontal. If necessary use a coin. To disable this device and restore the possibility of closing the door, rotate the button anti-clockwise until the groove is vertical. Frost precaution If the appliance is installed in a place where the temperature could drop below 0°C, proceed as follows to remove any water remaining inside the appliance: 1. unplug the appliance; 2. turn off the water tap; 3.
>PP<=polypropylene This means that they can be recycled by disposing of them properly in appropriate collection containers. Ecological hints To save water, energy and to help protect the environment, we recommend that you follow these tips: • Normally soiled laundry may be washed without prewashing in order to save detergent, water and time (the environment is protected too!). • The machine works more economically if it is fully loaded.
Technical data Dimensions Width Height Depth 60 cm 85 cm 50 cm Electrical connection Information on the electrical connection is given on the rating plate, on the inner edge of the appliance door. Water supply pressure Minimum Maximum 0,05 MPa 0,8 MPa Maximum Load Cotton 7 kg Spin Speed Maximum 1000 rpm (ZWH 6100P) 1200 rpm (ZWH 6120P) Installation Unpacking • Remove the external film. Use a cutter, if necessary.
• Return appliance to it's upright position. • Open the door and remove the plastic hose guide, the bag containing the instruction booklet and the plastic plug caps from the drum. • Unscrew the three bolts (A) and remove the hose holders (C). • Slide out the relevant plastic spacers (B). Warning! Do not remove the drain hose from the rear support. Remove this hose only if it is necessary to drain the water. Refer to "Frost precaution" and "What to do if".
Positioning and levelling Water inlet Connect the hose to a tap with a 3/4” thread. 35° Level the appliance by raising or lowering the feet. Depending on the model, the appliance can have four adjustable feet, or two front-adjustable feet and two back fixed feet. The appliance MUST be level and stable on a flat hard floor. If necessary, check the setting with a spirit level. Any necessary adjustment can be made with a spanner.
If the outlet spigot has not been used before, remove any blanking plug that may be in place. MAX 100cm • Directly into a drain pipe at a height of not less than 60 cm and not more than 100 cm. Tie the plastic hose guide to the tap with a string to prevent that the drain hose unhooks when the appliance is emptying. • Onto a sink outlet spigot. The end of the drain hose must always be ventilated, i.e. the inside diameter of the drain pipe must be larger than the outside diameter of the drain hose.
Electrical connection • The appliance must be earthed. • Make sure that the electrical information on the rating plate agree with your domestic power supply. • Always use a correctly installed shockproof socket. • Do not use multi-way plugs, connectors and extension cables. There is a risk of fire. • Do not replace or modify the mains cable yourself. Contact the After Sales Service. • Make sure that the mains plug and cable is not squashed or damaged by the back of the appliance.
Mould stains: treat with bleach, rinse well (whites and fast coloureds only). Grass: soap lightly and treat with bleach (whites and fast coloureds only). Ball point pen and glue: moisten with acetone1), lay the garment on a soft cloth and dab the stain. Lipstick: moisten with acetone as above, then treat stains with methylated spirits. Treat any residual marks with bleach. Red wine: soak in water and detergent, rinse and treat with acetic or citric acid, then rinse. Treat any residual marks with bleach.
If the water hardness degree is medium or high we suggest you to add a water softener following always the manufacturer’s instructions. When the degree of hardness is soft, readjust the quantity of the detergent. Open the detergent dispenser drawer Compartment for powder or liquid detergent used for main wash. Compartment for liquid additives (fabric softener, starch). Warning! If you wish to carry out the prewash, pour the detergent among washing items into the drum. • Remove the drawer.
• • • • Warning! Do not use the flap in "DOWN" position with: Gelatinous detergent or thick detergent. Powder detergent. With programmes with prewash. Do not use liquid detergent if the washing programme doesn't start immediately. Measure out the fabric softener Pour fabric softener or any additives into the compart(do not ment marked exceed the «MAX» mark in the drawer). Any additives must be placed in the appropriate compartments of the dispenser drawer just before starting the wash programme.
1 Programme selector dial Turn the programme selector dial to the required programme. The selector dial can be turned either clockwise or counter-clockwise. The green pilot light of the button 6 starts flashing: the appliance is now switched on. If you turn the programme selector dial to another programme when the appliance is working, the red pilot light of the button 6 will flash 3 times to indicate a wrong selection. The appliance will not perform the new selected programme.
3 Extra Rinse This appliance is designed for saving water. However, for people with very delicate skin (allergic to detergents) it may be necessary to rinse the laundry using an extra quantity of water. Press simultaneously the buttons 3 and 4 for some seconds: the pilot light 7.2 comes on. This function stays permanently on. To remove it press the same buttons again until the pilot light 7.2 goes off. Delay Start The start of the programme can be delayed by 9, 6 or 3 hours by means of this button.
If the door remains locked, this means that the appliance is already heating or that the water level is too high. In any case, do not try to force the door open! If you cannot open the door but you need to open it you have to switch the . After a few minutes the door appliance off by turning the selector dial to can be opened (pay attention to the water level and temperature!). After closing the door, it is necessary to select the programme and options again and to press the button 6.
Washing programmes Programme - Maximum and Minimum Temperature - Cycle Description - Maximum Spin Speed - Maximum Fabrics Load - Type of Laundry Options COTTON (Cold) 95°Main wash - Rinses - Maximum spin speed at: 1000 rpm for model ZWH 6100P; 1200 rpm for model ZWH 6120P Max. load 7 kg - Reduced load 3,5 kg White, coloured cotton and linen. Normally soiled items.
Programme - Maximum and Minimum Temperature - Cycle Description - Maximum Spin Speed - Maximum Fabrics Load - Type of Laundry Options DELICATE (Cold) 40°Main wash - Rinses - Maximum spin speed at 700 rpm Max. load kg 3,5 - Reduced load 2 kg Delicate fabrics: acrylics, viscose, polyester . Normally soiled items.
Programme - Maximum and Minimum Temperature - Cycle Description - Maximum Spin Speed - Maximum Fabrics Load - Type of Laundry Options BLANKET 30° Main wash - Rinses - Maximum spin speed: 700 rpm Special program for one sleeping bag, one duvet or two pillow cases or washable coats padded with synthetic filling or dawns. The Extra Rinse option is activated automatically. AUTOMATIC SPIN REDUCTION, DELAY START MINI 30 30° Main wash - Rinses - Maximum spin speed at 700 rpm Max.
The actual water temperature may differ from the declared cycle temperature. Care and cleaning Warning! Switch the appliance off and remove the mains plug from the socket before any cleaning action. Maintenance Wash With the use of low temperature washes it is possible to get a build up of residues inside the drum. We recommend that a maintenance wash be performed on a regular basis. To run a maintenance wash: • The drum should be empty of laundry. • Select the hottest cotton wash programme.
• turn the drum and align the filter cover (FILTER) with the arrow on the door seal; • open the filter cover by pressing the special hook and by rotating the cover upwards; Warning! Keep the filter cover open until the filter removal. • before removing the filter, remove any fluff or small objects from around the filter; The filter is inserted correctly when the indicator on its top is visible and blocked. • close the filter cover; • insert the mains plug again.
• Screw the hose back onto the tap. Make sure the connection is tight. • Unscrew the hose from the appliance. Keep a towel nearby because some water may flow. • Clean the filter in the valve with a stiff brush or with the piece of cloth. • Screw the hose back to the appliance and make sure the connection is tight. • Turn on the water tap. What to do if… The appliance does not start or stops during operation.
Fault code and malfunction Possible cause / Solution The drain hose is squashed or kinked. • Check the drain hose connection. The drain filter is clogged. If the appliance stops working without discharging the water , first carry out an emergency drain: • turn the programme selector dial to ; • • • • The light of button 6 flashes and the light 7.
Malfunction Possible cause / Solution The appliance does not start: The plug is not properly inserted in the power socket. • Insert the plug into the power socket. There is no power at the socket. • Please check your domestic electrical installation. The main fuse has blown. • Replace the fuse. The programme selector dial is not correctly positioned and the button 6 has not been pressed. • Please turn the selector dial and press the button 6 again. The delay start has been selected.
Malfunction Possible cause / Solution The electronic unbalance detection device has cut in because the laundry is not evenly distributed in the drum. The laundry is redistributed by reverse rotation of the drum. This may happen several times before the unbalance disappears and normal spinning can resume. If, after 10 minutes, the laundry is still not evenly distributed in Spinning starts late or the ap- the drum, the appliance will not spin.
192986240-A-212011 www.zanussi.