EN User manual Washing machine ZWH 6105 2
Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 Product description _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 Control panel _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 Washing Programmes _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 7 Helpful hints and tips _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 9 First use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 10 Personalisation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 11 Daily use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Care and cleaning _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ What to do if ...
• Always be sure, that there is no water leakage from hoses and their connections after the installation. • If the appliance is installed in a location subject to frost, please read the “dangers of freezing” chapter. • Any plumbing work required to install this appliance should be carried out by a qualified plumber or competent person. • Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person.
Product description 1 2 3 4 5 6 Detergent dispenser drawer Control panel Door opening handle Rating plate Drain pump Adjustable feet 1 2 3 4 5 6 Detergent dispenser drawer Compartment for detergent used for prewash and soak phase or for stain remover used during the stain action phase (if available). The prewash and soak detergent is added at the beginning of the wash programme. The stain remover is added during the stain action phase. Compartment for powder or liquid detergent used for main wash.
10 9 1 1 2 3 4 5 Programme selector dial SPIN reduction button OPTION button PREWASH button EASY IRON button 2 3 4 6 7 8 9 10 5 6 7 8 EXTRA RINSE button START/PAUSE button DELAY START button DOOR LOCKED pilot light Display Symbols on the Control Panel Programme selector dial = Cotton = Wool = Cold = Jeans = Synthetics = Soak = Delicates = Rinses = Special = Drain = Handwash = Spin Push buttons and pilot lights = Spin reduction button = Easy Iron = Rinse hold = Extra Rinse = Opt
Programme selector dial, spin speed button and available options Programme Selector Dial Start Pause It allows you to switch the appliance on/off and/or to select a programme. This button allows you to start or to interrupt the selected programme. Spin Reduction Delay Start By pressing this button you can change the spin speed of the selected programme. The programme can be delayed from 30 min - 60 min 90 min, 2 hours and then by 1 hour up to a maximum of 20 hours by means of this button.
• Delayed start The Selected delay set by pressing the relevant button appears on the display for a few seconds, then the duration of the selected programme is displayed again. The delay time value decreases by one unit every hour and then, when 1 hour remains, every minute. • Alarm codes In the event of operating problems, some alarm codes (see paragraph can be displayed, for example «What to do if...»).
Programme Maximum and Minimum Temperature - Cycle Description Maximum Spin Speed - Maximum Fabrics Load - Type of Laundry Options WOOL 40° Main wash - Rinses Maximum spin speed at 1000 rpm Max. load 2 kg Washing programme for machine washable wool as well as for hand washable woollens and delicate fabrics. Note : A single or bulky item may cause imbalance. If the appliance doesn’t perform the final spin phase, add more items, redistribute the load manually and then select the spinning programme.
Programme Maximum and Minimum Temperature - Cycle Description Maximum Spin Speed - Maximum Fabrics Load - Type of Laundry RINSES Rinses Maximum spin speed at 1000 rpm Max. load 7 kg With this programme it is possible to rinse and spin cotton garments which have been washed by hand. The machine performs 3 rinses, followed by a final long spin. The spin speed can be reduced. Options Detergent Compartment SPIN REDUCTION RINSE HOLD EASY IRON EXTRA RINSE DRAIN Draining of water Max.
Removing stains Stubborn stains may not be removed by just water and detergent. It is therefore advisable to treat them prior to washing. Blood: treat fresh stains with cold water. For dried stains, soak overnight in water with a special detergent then rub in the soap and water. Oil based paint: moisten with benzine stain remover, lay the garment on a soft cloth and dab the stain; treat several times.
• Remove the polystyrene block and any material from the drum. • Pour 2 liters of water into the main wash compartment of the detergent drawer in order to activate the ECO valve. Then run a cotton cycle at the highest temperature without any laundry in the machine, to remove any manufacturing residue from the drum and tub. Pour 1/2 a measure of detergent into the main wash compartment and start the machine.
Important! If you turn the programme selector dial to another programme when the machine is working, the red pilot light of button 7 will blink 3 times and the message Err is displayed to indicate a wrong selection. The machine will not perform the new selected programme. Select the spin speed by pressing button 2 When selecting a programme, the appliance proposes automatically the maximum spin speed provided for that programme. (See "Washing programmes" for the maximum allowed spin speed).
If the pilot light 9 blinks and after a few minutes goes off, the door can be opened. If the pilot light 9 remains lit, this means that the machine is already heating or that the water level is too high. In any case, do not try to force the door! If you cannot open the door but you need to open it, you have to switch the machine off by turning the selector dial . After a few minutes the door can be opened to (Pay attention to the water level and temperature!).
Cleaning the drawer recess Having removed the drawer, use a small brush to clean the recess, ensuring that all washing powder residue is removed from the upper and lower part of the recess. Replace the drawer and run the rinse programme without any clothes in the drum. Remove any objects from the pump impeller by rotating it. Put the cap back on the emergency emptying hose and place the latter back in its seat. Screw the pump cover fully in. Close the pump door.
• Screw the water inlet hose back on and reposition the emergency emptying hose after having put the cap on again. • When you intend to start the machine up again, make sure that the room temperature is above 0°C. Emergency emptying out • Unscrew the hose from the machine. Keep a rug nearby because some water may flow. • Clean the filter in the valve with a stiff brush or with the piece of cloth. 35° 45° • Screw the hose back to the machine and make sure the connection is tight. • Turn on the water tap.
Problem Possible cause/Solution The machine does not start: The door has not been closed. • Close the door firmly. The plug is not properly inserted in the power socket. • Insert the plug into the power socket. There is no power at the socket. • Please check your domestic electrical installation. The main fuse has blown. • Replace the fuse. The selector dial is not correctly positioned and the button 7 has not been pressed. • Please turn the selector dial and press the button 7 again.
Problem Possible cause/Solution There is water on the floor: Too much detergent or unsuitable detergent (creates too much foam) has been used. • Reduce the detergent quantity or use another one. Check whether there are any leaks from one of the inlet hose fittings. It is not always easy to see this as the water runs down the hose; check to see if it is damp. • Check the water inlet hose connection. The drain or inlet hose is damaged. • Replace it with a new one.
Problem Possible cause/Solution Spinning starts late or the machine does not spin: The electronic unbalance detection device has cut in because the laundry is not evenly distributed in the drum. The laundry is redistributed by reverse rotation of the drum. This may happen several times before the unbalance disappears and normal spinning can resume. If, after 10 minutes, the laundry is still not evenly distributed in the drum, the machine will not spin.
Consumption values Programme Energy consumption (KWh) Water consumption (litres) White Cottons 90° 2.1 65 Cottons 60° 1.4 60 Cottons + ECONOMY 60° 1.19 59 Cottons 40° 0.77 60 Synthetics 40° 0.6 54 Delicates 40° 0.6 63 Wool/ Handwash 30° 0.25 55 1) Programme duration (Minutes) For the duration of the programmes, please refer to the display on the control panel.
Positioning Install the machine on a flat hard floor. Make sure that air circulation around the machine is not impeded by carpets, rugs etc. Check that the machine does not touch the wall or other kitchen units. Level the washing machine by raising or lowering the feet. The feet may be tight to adjust as they incorporate a self locking nut, but the machine MUST be level and stable. Any necessary adjustment can be made with a spanner.
In a sink drain pipe branch . This branch must be above the trap so that the bend is at least 60 cm above the ground. Directly into a drain pipe at a height of not less than 60 cm and not more than 90 cm. The end of the drain hose must always be ventilated , i.e. the inside diameter of the drain pipe must be larger than the outside diameter of the drain hose. The drain hose must not be kinked.
www.zanussi.