User Manual GETTING STARTED? EASY.
SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference.
• • • • • • • • • Do not exceed the maximum load of 8 kg (refer to the "Programme chart" chapter). The operating water pressure at the water entry point from the outlet connection must be between 0.5 bar (0.05 MPa) and 8 bar (0.8 MPa). The ventilation opening in the base must not be covered by a carpet, mat, or any floor covering. The appliance must be connected to the water mains using the new supplied hose sets, or other new hose sets supplied by the Authorised Service Centre.
ELECTRICAL CONNECTION WARNING! Risk of fire and electric shock. • • • • • • • • • • The appliance must be earthed. Always use a correctly installed shockproof socket. Make sure that the parameters on the rating plate are compatible with the electrical ratings of the mains power supply. Do not use multi-plug adapters and extension cables. Make sure not to cause damage to the mains plug and to the mains cable.
PRODUCT DESCRIPTION APPLIANCE OVERVIEW 1 2 1 Worktop 2 Detergent dispenser 3 3 Control panel 4 Door handle 5 Rating plate 6 Feet for levelling the appliance 4 5 6 INSTALLATION ON SUSPENDED FLOORING Suspended wooden floors are particularly susceptible to vibration. To limit vibration we recommend placing a waterproof wooden panel, at least 15 mm thick, under the appliance. It should be screwed to at least 2 floor beams and should extend beyond the front feet.
CONTROL PANEL DESCRIPTION Cottons Cotton ECO Synthetics Delicates Wool/Handwash Duvets Mix 20° 90° 1400 Quick 60° 1200 Intensive 40° 800 Easy Iron Finish In Rinse Only 30° Drain & Spin P On/Off 1 2 3 4 5 6 7 8 1 On/Off button 6 Start/Pause touchpad 2 Programme selection touchpad 7 Finish In touchpad 8 Display 3 Temperature selection touchpad 4 Spin selection touchpad 9 9 Door locked indicator 5 Options selection touchpad DISPLAY A.
PROGRAMME CHART Programme Temperature range Maximum load Reference spin speed Programme description (Type of load and soil level) 30'@30° 30°C 1 kg 800 rpm A short cycle for synthetic and delicate items with light soil level or for items to freshen up. Cottons 90°C - Cold 8 kg 1400 rpm White cotton and coloured cotton. Normal, heavy and light soil. Cotton 8 kg 1400 rpm White cotton and fast-coloured cotton. Normal soil.
■ 30'@30° ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ Cotton ECO ■ ■ ■ ■ Synthetics ■ ■ ■ ■ ■ Delicates ■ ■ ■ ■ ■ Wool/Handwash ■ ■ ■ Drain & Spin ■ ■ ■ Duvets Rinse Only ■ Cottons Mix 20° Easy Iron Programme Intensive Quick1) Programme options compatibility ■ ■ ■ ■ ■ 1) When you set this option, we recommend that you decrease the quantity of the laundry.
Programmes Load (kg) Energy consumption (kWh) Water consumption (litre) Approximate Remaining programme duration (mi- moisture (%)1) nutes) Cottons 60°C 8 1,35 70 159 52 Cottons 40°C 8 0,87 69 158 52 Synthetics 40°C 3 0,60 56 103 35 Delicates 40°C 3 0,55 59 81 35 1,5 0,45 62 75 30 8 0,96 52 244 52 4 0,73 40 210 52 4 0,62 41 196 52 Wool/Handwash 30°C 2) Standard cotton programmes Standard 60°C cotton Standard 60°C cotton Standard 40°C cotton 1) At the end of
• • The drum turns regularly to prevent the laundry creases. The door stays locked. You must drain the water to unlock the door. To drain the water refer to ‘At the end of the programme’. QUICK With this option you can decrease the programme duration. Use this option for items with light soil or items to refresh. The related indicator comes on. INTENSIVE With this option you can wash very soiled laundry. The washing cycle lasts longer with this option. The related indicator comes on.
If you deactivate the acoustic signals, they continue operate when the appliance has a malfunction. BEFORE FIRST USE During installation or before first use you may observe some water in the appliance. This is residual water left in the appliance after a full functional test in the factory to ensure the appliance is delivered to customers in perfect working order and is no cause for concern. 1. Connect the mains plug to the mains socket. 2. Open the water tap. 3.
LIQUID OR POWDER DETERGENT The default position of the flap is A (powder deA tergent). To use liquid detergent: 1. Remove the drawer. Push the drawer edge in the place with the arrow (PUSH) to remove the drawer easily. SETTING A PROGRAMME 1. Touch the programme button programme: • The indicator of the button flashes. • The display shows the programme duration. 2. If necessary, change the temperature and the spin speed or add available options.
a. Touch the button to set the appliance to pause. The indicator of button flashes. AT THE END OF THE PROGRAMME • The appliance stops automatically. • The acoustic signal operates (if it is activated). b. Touch the button until the indicator above this button goes off. • In the display • The indicator of the button Touch the button again to start the programme immediately. • • • The door lock indicator goes off. You can open the door. Remove the laundry from the appliance.
• You do not use the appliance for 5 minutes • before you touch the . Press the button On/Off to activate the appliance again. After 5 minutes from the end of the washing programme. Press the button On/Off to activate the appliance again. The display shows the end of the last set programme. Touch the buttonPrograms if you want to set a new cycle. HINTS AND TIPS THE LAUNDRY LOAD • Divide the laundry in: white, coloured, synthetics, delicates and wool.
CARE AND CLEANING WARNING! Refer to Safety chapters. EXTERNAL CLEANING Clean the appliance with soap and warm water only. Fully dry all the surfaces. CAUTION! Do not use alcohol, solvents or chemical products. DESCALING If the water hardness in your area is high or moderate, we recommend that you use a water descaling product for washing machines. Regularly examine the drum to prevent limescale and rust particles. To remove rust particles use only special products for washing machines.
CLEANING THE INLET HOSE AND THE VALVE FILTER 1 1 2 3 4 2 45° 3 20° FROST PRECAUTIONS If the appliance is installed in an area where the temperature can be less than 0 °C, remove the remaining water from the inlet hose and the drain pump. Do this procedure also when you want to do the emergency drain. 1. Disconnect the mains plug from the mains socket. 2. Remove the water inlet hose. 3. Remove the drain hose from the rear support and unhook it from sink or spigot. 4.
early. If the alarm code appears again, contact the Authorised Service Centre. WARNING! Deactivate the appliance before you do the checks. POSSIBLE FAILURES Problem The programme does not start. Possible solution • • • • • • The appliance does not fill with water properly. • • • • • • The appliance does not drain the water. • • • • • • The spin phase does not operate or the washing cycle lasts longer than usually. • • • • There is water on the floor. • • • You cannot open the appliance door.
Problem The appliance makes an unusual noise. Possible solution • • • Make sure the levelling of the appliance is correct. Refer to 'Installation instruction'. Make sure that the packaging and/or the transit bolts are removed. Refer to 'Installation instruction'. Add more laundry in the drum. The load may be too small. The appliance fills with water and drain immediately. • Make sure that the drain hose is in the correct position. The end of the hose may be too low. Refer to 'Installation instruction'.
Spin Speed Maximum spin speed 1351 rpm 1) The appliance works correctly if the water pressure is not lower than 0.05 MPa (0.5 bar). If you cannot connect the water inlet hose to the cold water tap of the primary hydraulic system, connect it to your domestic cold water storage system. Make sure not to exceed a distance of 5.02 m (16.5 ft) between the appliance inlet hose and the bottom of the water storage tank. 2) Connect the water inlet hose to a water tap with a 3/4'' thread.
Programme time of the standard 60°C cotton programme at partial load in minutes 210 Programme time of the "standard 40°C cotton programme at partial load in minutes 196 Duration of the left on mode in minutes 5 Airborne acoustical noise emission in db(A) washing 58 Airborne acoustical noise emission in db(A) spinning 78 Built in appliance Y/N No The information given in the chart above is compliant with the EU Commission regulation 1015/2010 implementing directive 2009/125/EC .
192974282-A-312018 WWW.ZANUSSI.
