EN User Manual Washing Machine ZWF 81263WT
Contents Safety information Safety instructions Product description Control panel Programme Chart Consumption values Options 2 3 4 5 6 7 8 Settings Before first use Daily use Hints and tips Care and cleaning Troubleshooting Technical Data 9 9 9 12 13 15 17 Subject to change without notice. Safety information Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages.
• • • • • • • The operating water pressure (minimum and maximum) must be between 0,5 bar (0,05 MPa) and 8 bar (0,8 MPa). The ventilation openings in the base (if applicable) must not be obstructed by a carpet. The appliance is to be connected to the water mains using the new supplied hose-sets. Old hose sets must not be reused. If the supply cord is damaged, it must be replaced by the manufacturer, its Authorised Service Centre or similarly qualified persons in order to avoid a hazard.
• • Before you connect the appliance to new pipes or pipes not used for a long time, let the water flow until it is clean. The first time you use the appliance, make sure that there is no leakage. Use • • Disposal WARNING! WARNING! Risk of injury, electrical shock, fire, burns or damage to the appliance. • • • • Do not put a container to collect possible water leakage under the appliance. Contact the Authorised Service Centre to ensure which accessories can be used.
Control panel Control panel description Cottons Cotton ECO Synthetics Delicates Wool/Handwash Duvets Mix 20° 1200 Quick 60° 1000 Intensive 40° 800 Easy Iron Finish In Rinse Only 30° Drain & Spin P On/Off 1 1 On / Off button 90° 2 3 4 5 6 7 8 9 6 Start/Pause touchpad (On/Off) 2 Programme selection touchpad 3 Temperature touchpad 7 Finish in touchpad 8 Display (Finish In) 9 Door locked indicator 4 Spin selection touchpad 5 Options selection touchpad Display A) The time area:
Programme Chart Programme Temperature range Maximum load Maximum spin speed Programme description (Type of load and soil level) 30' @ 30° 30 °C 3 kg 800 rpm A short cycle for synthetics and delicate items with light soil level or for items to freshen up. Cottons 90 °C - Cold 8 kg 1200 rpm White cotton and coloured cotton. Normal soil and light soil. Cotton Eco1) 60 °C - 40 °C 8 kg 1200 rpm White cotton and colour-fast cotton. Normal soil.
Programme Quick1) Intensive ■ ■ Easy Iron Rinse Only Drain & Spin ■ ■ ■ Delicates ■ ■ ■ Wool/Handwash ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ Duvets Mix 20° ■ ■ ■ ■ 1) When you set this option, we recommend that you decrease the quantity of the laundry. It is possible to keep the full load but the washing results can be unsatisfactory. Recommended load: cotton: 4 kg, synthetics and delicates: 1,5 kg. Consumption values The data of this table are approximate.
Off Mode (W) Left On Mode (W) 0,48 0,48 The information given in the chart above are in compliance with the EU Commission regulation 1015/2010 implementing directive 2009/125/EC. Options Temperature Intensive With this option you can change the default temperature. With this option you can wash very soiled laundry. Indicator = cold water. The indicator of the set temperature comes on. Spin With this option you can change the default spin speed. The indicator of the set speed comes on.
The display shows the number of hours and the indicator above the button is on. Extra Rinse Use this option for persons allergic to detergents and in areas where the water is soft. The related indicator comes on.1 With this option you can add some rinses to a washing programme. Settings Extra Rinse With this option you can permanently have an extra rinse when you set a new programme. • To activate/deactivate this option touch the buttons the indicator and at the same time until comes on/goes off.
Make sure not to put too much laundry in the drum. Refer to max. loads indicated in "Programme chart". 4. Close the door. Liquid or powder detergent A The default position of the flap is A (powder detergent). CAUTION! Make sure that no laundry stays between the seal and the door. There is a risk of water leakage or damage to the laundry. To use liquid detergent: 1. Remove the drawer. Push the drawer edge in the place with the arrow (PUSH) to remove the drawer easily. Using detergent and additives 1.
A tune sounds when the appliance is activated. The appliance performs a start up animation. The animation quickly shows each washing programme and the default temperature and spin settings. The display shows the word On. Setting a programme 1. Touch the programme button programme: and set the • • The indicator of the button flashes. The display shows the programme duration. 2. If necessary, change the temperature and the spin speed or add available options.
• CAUTION! If the temperature and level of the water in the drum are too high, you cannot open the door. 1. To drain the water. To open the door during the first minutes of the cycle (or when the 1. Touch the button appliance. goes off. 4. Close the door and touch the button again. The programme (or the continues. ) At the end of the programme • • The appliance stops automatically. The acoustic signal operates (if it is activated). comes on.
• • • • • Remove hard stains. Wash with a special detergent heavy soil stains. Be careful with the curtains. Remove the hooks or put the curtains in a washing bag or pillowcase. Do not wash in the appliance laundry without hems or with cuts. Use a washing bag to wash small and/or delicate items (e.g. underwired bras, belts, tights, etc. ). A very small load can cause balance problems with the spin phase. If this occurs, adjust manually the items in the tub and start the spin phase again.
Maintenance wash With the low temperature programmes it is possible that some detergent stays in the drum. Make regularly a maintenance wash. To do this: • • Cleaning the inlet hose and the valve filter 1 Remove the laundry from the drum. Set the cotton programme with the highest temperature with a small quantity of detergent. 1 2 2 3 Door seal Regularly examine the seal and remove all objects from the inner part.
WARNING! Make sure that the temperature is more than 0 °C before you use the appliance again. The manufacturer is not responsible for damages caused by low temperatures. Troubleshooting WARNING! • Refer to Safety chapters. water. - The appliance does not drain the • - The appliance door is open or not closed correctly. Please check the door! The start of the appliance does not occur or it stops during operation. • - The mains supply is unstable. Wait until the mains supply is stable.
Problem The appliance does not drain the water. Possible solution • • • • • • The spin phase does not operate or the washing cycle lasts longer than usually. • • • • There is water on the floor. • • • Make sure that the sink spigot is not clogged. Make sure that the drain hose has no kinks or bends. Make sure that the connection of the drain hose is correct. Set the drain option if you set a programme without drain phase. Set the drain option if you set an option which ends with water in the drum.
When contacting the Authorised Service Centre, make sure that these data are available. You can find the information on the rating plate: model (Mod.), PNC (Prod.No.), Serial number (Ser.No.). If the display shows other alarm codes. Deactivate and activate the appliance. If the problem continues, contact the Authorised Service Centre. Service We recommend the use of original spare parts.
www.zanussi.
www.zanussi.
192971670-A-322014 www.zanussi.