User Manual GETTING STARTED? EASY.
SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference.
• • • • • Old hose sets must not be reused. If the mains power supply cable is damaged, it must be replaced by the manufacturer, its Authorised Service Centre or similarly qualified persons to avoid an electrical hazard. Before any maintenance operation, deactivate the appliance and disconnect the mains plug from the socket. Do not use high pressure water sprays and/or steam to clean the appliance. Clean the appliance with a moist cloth. Use only neutral detergents.
• • Do not put a container to collect possible water leakage under the appliance. Contact the Authorised Service Centre to ensure which accessories can be used. Do not touch the glass door while a programme is in operation. The glass can get hot. SERVICE • To repair the appliance contact an Authorised Service Centre. • Use original spare parts only. • • • • Disconnect the appliance from the mains electrical and water supplies. Cut off the mains electrical cable close to the appliance and dispose of it.
EASY START CONTROL PANEL DESCRIPTION Cottons Cotton ECO Synthetics Delicates Wool/Handwash Refresh 20min Mixed Fabrics Quick Intensive Easy Iron Rinse Only Options Drain & Spin Temp. Spin Finish At 3 4 5 On/Off 1 1 On / Off button 2 6 8 7 6 Start/Pause touchpad (On/Off) 2 Programme selection touchpad 7 Options selection touchpad 8 Display 3 Temperature touchpad 4 Spin selection touchpad 5 Finish at touchpad (Finish At) DISPLAY A B C D G A.
: Cold water indicator B. : The permanent extra rinse indicator C. The spin area: • : The spin speed indicator • : The No Spin indicator • E. : The Rinse Hold indicator : The programme duration • : The alarm codes • : The message of error • : Programme is completed. • • • : The Extra Silent indicator D. The time area: • • : The time of cycle finish (when the : The door locked indicator You cannot open the appliance door when the symbol is on.
Programme Temperature range Mixed Fabrics 60°C - Cold Maximum load Maximum spin speed Programme description (Type of load and soil level) 2 kg 1200 rpm Special programme for cotton, synthetic and mixed fabrics with light soil. In case of setting cold wash cycle make sure to use the detergent designed for low temperatures. 1) Standard programmes for the Energy Label consumption values.
CONSUMPTION VALUES The data in this table are approximate. Different variables can affect the data: the quantity and type of laundry, the water and ambient temperature. At the start of the programme, the display shows the programme duration for the maximum load capacity. During the washing phase the programme duration is automatically calculated and can be greatly reduced if the laundry load is lower than the maximum load capacity (e.g.
OPTIONS TEMPERATURE With this option you can change the default temperature. Use this option for items with light soil or items to refresh. The related indicator comes on. = cold water. Indicator The indicator of the set temperature comes on. INTENSIVE With this option you can wash very soiled laundry. The washing cycle lasts longer with this option. The related indicator comes on. SPIN With this option you can decrease the default spin speed. The display shows the indicator of the set speed.
Use this option for persons allergic to detergents and in areas where the water is soft. The related indicator comes on.1) SETTINGS PERMANENT EXTRA RINSE With this option you can permanently have an extra rinse when you set a new programme. • To activate/deactivate this option touch the buttons indicator and at the same time until the comes on/goes off. CHILD LOCK With this option you can prevent that the children play with the control panel.
DAILY USE Compartment for liquid additives (fabric conditioner, starch). WARNING! Refer to Safety chapters. LOADING THE LAUNDRY Open the water tap. Connect the mains plug to the mains socket. 1. Pull the door handle to open the appliance door. 2. Put the laundry in the drum, one item at a time. 3. Shake the items before you put them in the appliance. Make sure not to put too much laundry in the drum. Refer to max. loads indicated in "Programme chart". 4. Close the door.
When the flap is in position B and you want to use powder detergent: 1. Remove the drawer. 2. Adjust the flap in position A. 3. Put back the drawer in the recess. A • • • Measure out the detergent and the fabric conditioner. Put the detergent and the fabric conditioner into the compartments. Carefully close the detergent drawer. ACTIVATING THE APPLIANCE Press and hold for a couple of seconds the On/Off button to activate or deactivate the appliance. A tune sounds when the appliance is activated.
If you change any option the will be disabled. option (if set) 3. Touch again. The programme continues. CANCELLING A PROGRAMME 1. Press the button for some seconds to cancel the programme and to deactivate the appliance. 2. Press the same button again to activate the appliance. Now, you can set a new washing programme. The washing programme is completed, but there is water in the drum: • The drum turns regularly to prevent the creases in the laundry. The indicator the water.
HINTS AND TIPS THE LAUNDRY LOAD • Divide the laundry in: white, coloured, synthetics, delicates and wool. • Obey the washing instructions that are on the laundry care labels. • Do not wash white and coloured items together. • Some coloured items can discolour with the first wash. We recommend that you wash them separately for the first times. • Button up pillowcases, close zippers, hooks and poppers. Tie up belts. • Empty the pockets and unfold the items.
Regularly examine the drum to prevent limescale and rust particles. To remove rust particles use only special products for washing machines. Do this separately from the laundry wash. • Select the cotton programme with the highest temperature with a small quantity of detergent. DOOR SEAL Regularly examine the seal and remove all objects from the inner part. Always obey the instructions that you find on the packaging of the product.
3. Remove the drain hose from the rear support and unhook it from sink or spigot. 4. Put the ends of the drain and inlet hose in a container. Let the water flow out of the hoses. 5. When no more water flows, install the inlet hose and the drain hose again. WARNING! Make sure that the temperature is more than 0 °C before you use the appliance again. The manufacturer is not responsible for damages caused by low temperatures. TROUBLESHOOTING WARNING! Refer to Safety chapters.
POSSIBLE FAILURES Problem The programme does not start. Possible solution • • • • • • The appliance does not fill with water properly. • • • • • • The appliance does not drain the water. • • • • • • The spin phase does not operate or the washing cycle lasts longer than usually. • • • • • There is water on the floor. • • • Make sure that the mains plug is connected to the mains socket. Make sure that the appliance door is closed. Make sure that there is not a damaged fuse in the fuse box.
Problem Possible solution The appliance fills with water and drain immediately. • Make sure that the drain hose is in the correct position. The end of the hose may be too low. Refer to 'Installation instruction'. The cycle is shorter than the time displayed. • The appliance calculates a new time according to the laundry load. See the ‘Consumption Values’ chapter. The cycle is longer than the time displayed. • An unbalanced laundry load increases the duration time.
ENVIRONMENTAL CONCERNS the symbol with the household waste. Return the product to your local recycling facility or contact your municipal office. Recycle the materials with the symbol . Put the packaging in applicable containers to recycle it. Help protect the environment and human health and to recycle waste of electrical and electronic appliances.
192957960-A-072016 WWW.ZANUSSI.