User Manual GETTING STARTED? EASY.
SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference.
• • • • • • The appliance must be connected to the water mains using the new supplied hose sets, or other new hose sets supplied by the Authorised Service Centre. Old hose sets must not be reused. If the mains power supply cable is damaged, it must be replaced by the manufacturer, its Authorised Service Centre or similarly qualified persons to avoid an electrical hazard. Before any maintenance operation, deactivate the appliance and disconnect the mains plug from the socket.
• • This appliance complies with the E.E.C. Directives. WATER CONNECTION • Do not cause damage to the water hoses. • Before connection to new pipes, pipes not used for a long time, where repair work has been carried out or new devices fitted (water meters, etc.), let the water flow until it is clean and clear. • Ensure that there are no visible water leaks during and after the first use of the appliance. • Do not use an extension hose if the inlet hose is too short.
INSTALLATION ON SUSPENDED FLOORING Suspended wooden floors are particularly susceptible to vibration. To limit vibration we recommend placing a waterproof wooden panel, at least 15 mm thick, under the appliance. It should be screwed to at least 2 floor beams and should extend beyond the front feet. If possible, install the appliance where the floor is more stable.
Programme Temperature range Maximum load Maximum spin speed Programme description (Type of load and soil level) 10 kg 1200 rpm White cotton and fast-coloured cotton. Normal soil. The energy consumption decreases and the time of the washing programme is extended. Synthetics 60°C - Cold 4 kg 1200 rpm Synthetic items or mixed fabric items. Normal soil. Delicates 40°C - Cold 4 kg 1200 rpm Delicate fabrics such as acrylics, viscose and mixed fabrics requiring gentler washing. Normal soil.
Delicates ■ ■ ■ Wool/Handwash ■ ■ ■ Duvet ■ ■ ■ Mix 20° ■ ■ ■ ■ ■ ■ Extra Rinse Delay Start Drain & Spin Rinse Easy Iron Intensive Quick1) Programme ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ 1) When you set this option, we recommend that you decrease the quantity of the laundry. It is possible to keep the full load but the washing results can be unsatisfactory. Recommended load: cotton: 5 kg, synthetics and delicates: 2,5 kg.
Programmes Load (kg) Energy consumption (kWh) Water consumption (litre) Approximate Remaining programme duration (mi- moisture (%)1) nutes) Synthetics 40°C 4 0,80 61 140 35 Delicates 40°C 4 0,56 75 95 35 1,5 0,42 62 75 30 10 0.93 57 246 53 5 0,70 45 206 53 5 0,65 46 203 53 Wool/Handwash2) 30°C Standard cotton programmes Standard 60°C cotton Standard 60°C cotton Standard 40°C cotton 1) At the end of spin phase. 2) Not available for some models.
If you set also the Extra Rinse function ( appliance adds two or more rinses. The related indicator comes on. To drain the water refer to ‘At the end of the programme’. QUICK With this option you can decrease the programme duration. Use this option for items with light soil or items to refresh. The related indicator comes on. ) the DRAIN & SPIN With this option you can perform the spin and drain cycle. The spin phase is suitable to the washing programme you set.
BEFORE FIRST USE 1. Connect the mains plug to the mains socket. 2. Open the water tap. 3. Put a small quantity of detergent in the compartment for washing phase. 4. Set and start a programme for cotton at the highest temperature without laundry. This removes all possible dirt from the drum and the tub. DAILY USE WARNING! Refer to Safety chapters. LOADING THE LAUNDRY Open the water tap. Connect the mains plug to the mains socket. 1. Pull the door handle to open the appliance door. 2.
A 1. 2. 3. • • • The default position of the flap is A (powder detergent). Remove the drawer. Adjust the flap in position A. Put back the drawer in the recess. Measure out the detergent and the fabric conditioner. Put the detergent and the fabric conditioner into the compartments. Carefully close the detergent drawer. ACTIVATING THE APPLIANCE Press and hold for a couple of seconds the On/Off button to activate or deactivate the appliance. A tune sounds when the appliance is activated.
You can cancel or change the set of the delay start before you touch the button . After touching the button you can only cancel the delay. To cancel the delay start: 1. Touch the button to set the appliance to pause. 2. Touch the button Delay Start until the indicator of the set delay goes off. Touch the button again to start the programme immediately. 1. Touch . The indicator of this button flashes. 2. Change the options. 3. Touch again. The programme continues. CANCELLING A PROGRAMME 1.
• Press the button to activate the appliance again. After 5 minutes from the end of the washing programme. Press the button again. Touch the button cycle. if you want to set a new to activate the appliance HINTS AND TIPS THE LAUNDRY LOAD • Divide the laundry in: white, coloured, synthetics, delicates and wool. • Obey the washing instructions that are on the laundry care labels. • Do not wash white and coloured items together. • Some coloured items can discolour with the first wash.
CARE AND CLEANING WARNING! Refer to Safety chapters. EXTERNAL CLEANING Clean the appliance with soap and warm water only. Fully dry all the surfaces. CAUTION! Do not use alcohol, solvents or chemical products. Always obey the instructions that you find on the packaging of the product. MAINTENANCE WASH With the low temperature programmes it is possible that some detergent stays in the drum. Perform a maintenance wash regularly. To do this: • Remove all laundry from the drum.
CLEANING THE INLET HOSE AND THE VALVE FILTER 1. 1 FROST PRECAUTIONS If the appliance is installed in an area where the temperature can be less than 0 °C, remove the remaining water from the inlet hose and the drain pump. Do this procedure also when you want to do the emergency drain. 2 3 2. 1. Disconnect the mains plug from the mains socket. 2. Remove the water inlet hose. 3. Remove the drain hose from the rear support and unhook it from sink or spigot. 4.
If the appliance is overloaded, remove some items from the drum and/or keep pressed the door and push the button at the same time until the indicator stops flashing (see the picture below). • The indicator of button flashes in red 11 times and 1 (or 2 or 3) time(s) in yellow: The mains supply is unstable. Wait until the mains supply is stable. WARNING! Deactivate the appliance before you do the checks. POSSIBLE FAILURES Problem The programme does not start.
Problem There is water on the floor. Possible solution • • • Make sure that the couplings of the water hoses are tight and there is not water leakages. Make sure that the water inlet hose and the drain hose have no damages. Make sure you use the correct detergent and the correct quantity of it. You cannot open the appliance door. • • • Make sure that the washing programme is finished. Set the drain or the spin option if there is water in the drum. Do the emergency drain procedure.
Level of protection against ingress of solid particles and moisture ensured by the protective cover, except where the low voltage equipment has no protection against moisture IPX4 Water supply pressure 0,5 bar (0,05 MPa) 8 bar (0,8 MPa) 1) Minimum Maximum Cold water Water supply 2) Maximum Load Cotton 10 kg Energy Efficiency Class Spin Speed A+++ -20% Maximum 1200 rpm 1) The appliance works correctly if the water pressure is not lower than 0.05 MPa (0.5 bar).
192938880-A-472017 WWW.ZANUSSI.