EN User Manual Washing Machine ZWF 81463WH
Contents Safety information Safety Instructions Product description Control panel Programme Chart Consumption values Options 2 3 4 5 6 7 8 Settings Before first use Daily use Hints and tips Care and cleaning Troubleshooting Technical Data 9 9 10 13 13 15 17 Subject to change without notice. Safety information Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages.
• • • • • • The ventilation openings in the base (if applicable) must not be obstructed by a carpet. The appliance is to be connected to the water mains using the new supplied hose-sets. Old hose sets must not be reused. If the supply cord is damaged, it must be replaced by the manufacturer, its Authorised Service Centre or similarly qualified persons in order to avoid a hazard. Before maintenance, deactivate the appliance and disconnect the mains plug from the mains socket.
Use WARNING! Risk of injury, electrical shock, fire, burns or damage to the appliance. • • • • • Use this appliance in a household only. Obey the safety instructions on the detergent packaging. Do not put flammable products or items that are wet with flammable products in, near or on the appliance. Make sure that you remove all metal objects from the laundry. Do not put a container to collect possible water leakage under the appliance.
Control panel Control panel description Katoen Katoen ECO Synthetica Fijne Was Wol/Handwas Dekbed Mix 20° 90° 1400 Snel 60° 1200 Intensief 40° 800 Anti-kreuk Klaar Over Spoelen Pompen & Centrifugeren 30° P Aan/Uit 1 1 On / Off button 2 3 4 5 6 7 8 9 6 Start/Pause touchpad (Aan/Uit) 2 Programme selection touchpad 3 Temperature touchpad 7 Finish in touchpad 8 Display (Klaar Over) 9 Door locked indicator 4 Spin selection touchpad 5 Options selection touchpad Display A) The time
Programme Chart Programme Temperature range Maximum load Maximum spin speed Programme description (Type of load and soil level) 30' @ 30° 30 °C 3 kg 800 rpm A short cycle for synthetics and delicate items with light soil level or for items to freshen up. Katoen 90 °C - Cold 8 kg 1400 rpm White cotton and coloured cotton. Normal soil and light soil. Katoen 8 kg 1400 rpm White cotton and colour-fast cotton. Normal soil.
Programme Snel1) Intensief Synthetica ■ ■ ■ ■ ■ Fijne Was ■ ■ ■ ■ ■ Wol/ Handwas ■ ■ ■ ■ ■ ■ Spoelen ■ ■ Dekbed Mix 20° Antikreuk ■ Pompen & Centrifugeren ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ 1) When you set this option, we recommend that you decrease the quantity of the laundry. It is possible to keep the full load but the washing results can be unsatisfactory. Recommended load: cotton: 4 kg, synthetics and delicates: 1,5 kg.
Programmes Load (kg) Energy consumption (kWh) Water consumption (litre) Approximate programme duration (minutes) Remaining moisture (%) 1) Standard 60 °C cotton 4 0,73 40 210 53 Standard 40 °C cotton 4 0,62 41 196 53 1) At the end of spin phase. Off Mode (W) Left On Mode (W) 0,05 0,05 The information given in the chart above are in compliance with the EU Commission regulation 1015/2010 implementing directive 2009/125/EC.
The related indicator comes on. Klaar Over Spoelen With this option you can set the number of hours in which you would like your washing programme to be completed. With this option you can perform only a last rinse of a selected washing programme. If you set also the Extra Rinse function ( appliance adds two or more rinses. ) the The related indicator comes on. Pompen & Centrifugeren With this option you can the spin and drain cycle. The spin phase is suitable to the washing programme you set.
Daily use WARNING! Compartment for liquid additives (fabric conditioner, starch). Refer to Safety chapters. Loading the laundry CAUTION! Do not exceed the MAX level. Open the water tap. Connect the mains plug to the mains socket. 1. Pull the door handle to open the appliance door. 2. Put the laundry in the drum, one item at a time. 3. Shake the items before you put them in the appliance. Make sure not to put too much laundry in the drum. Refer to max. loads indicated in "Programme chart". 4.
When the flap is in position B and you want to use powder detergent: 1. Remove the drawer. 2. Adjust the flap in position A. 3. Put back the drawer in the recess. A • • • Measure out the detergent and the fabric conditioner. Put the detergent and the fabric conditioner into the compartments. Carefully close the detergent drawer. Activating the appliance Press and hold for a couple of seconds the button to activate or deactivate the appliance. A tune sounds when the appliance is activated.
Cancelling a programme • 1. Press the button for some seconds to cancel the programme and to deactivate the appliance. 2. Press the same button again to activate the appliance. Now, you can set a new washing programme. The appliance does not drain the water. The water left in a drum can be used for the next washing cycle. The drum turns regularly to prevent the creases in the laundry. • The indicator drain the water. • The door lock indicator • indicator of button flashes. The door stays locked.
Hints and tips The laundry load • • • • • • • • • • • • Divide the laundry in: white, coloured, synthetics, delicates and wool. Obey the washing instructions that are on the laundry care labels. Do not wash together white and coloured items. Some coloured items can discolour with the first wash. We recommend that you wash them separately for the first times. Button up pillowcases, close zippers, hooks and poppers. Tie up belts. Empty the pockets and unfold the items.
CAUTION! Do not use alcohol, solvents or chemical products. 3 4 5 6 Descaling If the water hardness in your area is high or moderate, we recommend that you use a water softener for washing machines. Regularly examine the drum to prevent limescale and rust particles. To remove rust particles use only special products for washing machine. Do this separately from the laundry wash. Always obey the instructions that you find on the packaging of the product.
3. Remove the drain hose from the rear support and unhook it from sink or spigot. 4. Put the ends of the drain and inlet hose in a container. Let the water flow out of the hoses. 5. When no more water flows, install the inlet hose and the drain hose again. WARNING! Make sure that the temperature is more than 0 °C before you use the appliance again. The manufacturer is not responsible for damages caused by low temperatures. Troubleshooting WARNING! • Refer to Safety chapters. water.
Problem The appliance does not fill with water properly. Possible solution • • • • • • The appliance does not drain the water. • • • • • • The spin phase does not operate or the washing cycle lasts longer than usually. • • • • There is water on the floor. • • • Make sure that the sink spigot is not clogged. Make sure that the drain hose has no kinks or bends. Make sure that the connection of the drain hose is correct. Set the drain option if you set a programme without drain phase.
Problem The washing results are not satisfactory. You cannot set an option. Possible solution • • • • Increase the detergent quantity or use a different detergent. Use special products to remove the stubborn stains before you wash the laundry. Make sure that you set the correct temperature. Decrease the laundry load. • Make sure that you press only the wanted touch button(s). Service After the check, activate the appliance. The programme continues from the point of interruption.
www.zanussi.
www.zanussi.
192975420-A-012014 www.zanussi.