User Manual GETTING STARTED? EASY.
SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference. CHILDREN AND VULNERABLE PEOPLE SAFETY WARNING! Risk of suffocation, injury or permanent disability.
• • • • • • • • • • • • • • Connect the mains plug to the mains socket only at the end of the installation process. Make sure that the mains plug is accessible after installation.. The ventilation opening in the base (if applicable) must not be covered by a carpet, mat, or any floor covering. Ensure good air ventilation in the located room to avoid the back flow of gases into the room from appliances burning gas or other fuels, including open fires.
• • • • • • • Fabric softeners, or similar products, should only be used as specified by the product manufacturer’s instructions. Remove all objects from items that could be a source of fire ignition such as lighters or matches. Never stop the washer dryer before the end of the drying cycle unless all items are quickly removed and separated so that residual heat can dissipate.
• • Before connection to new pipes, pipes not used for a long time, where repair work has been carried out or new devices fitted (water meters, etc.), let the water flow until it is clean and clear. Ensure that there are no visible water leaks during and after the first use of the appliance. • WARNING! Risk of injury or damage to the appliance. USE WARNING! Risk of injury, electrical shock, fire, burns or damage to the appliance. • • • • • • • This appliance is for household use only.
least 2 floor beams and should extend beyond the front feet. If possible, install the appliance where the floor is more stable. FIXING PLATE KIT (4055171146) Available from your authorised dealer. If you install the appliance on a plinth, secure the appliance in the fixing plates. Read carefully the instructions supplied with the accessory. HOW TO ACTIVATE THE CHILD SAFETY DEVICE This device prevents children or pets from being closed in the drum. Turn the device clockwise, until the groove is horizontal.
DISPLAY G F Time area A B E D C : Programme duration : Selected drying time : Delay start : Alarm codes A : Message of error : The programme is completed.
PROGRAMMES PROGRAMME CHART Programme Temperature range Maximum load Maximum spin speed Programme description (Type of load and soil level) Washing programmes 7 kg 1600 rpm White cotton and coloured cotton. Normal soil and light soil. 7 kg 1600 rpm White cotton and fast-coloured cotton. Normal soil. The energy consumption decreases and the time of the washing programme is extended. 3,5 kg 1200 rpm Synthetic items or mixed fabric items. Normal soil.
Programme Temperature range Cotton Dry 30°C Miniprogramme Maximum load Maximum spin speed Programme description (Type of load and soil level) 4 kg Drying programme for cotton items. 1,5 kg 800 rpm A short cycle for synthetic and delicate items with light soil level or for items to freshen up. 1) The washing programme Economy at 60ºC with a load of 7 kg and the drying programme Cotton Dry are the reference programmes for the data entered in the energy label, in compliance with EEC 92/75 standards.
Programme ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■2) ■ ■ ■ ■ ■ ■ 1) Only the QUICK option is available. 2) Available only if the last spin speed step is lower than 800 rpm.
Dryness Level Type of fabric Cupboard Dry For items to be stored Cottons and Linen (bathrobes, bath towels, etc) Cupboard Dry For items to be stored Synthetics and mixed fabrics (jumpers, blouses, underwear, household linen) Iron Dry Suitable for ironing Cottons and Linen (sheets, tablecloths, shirts, etc) Wool dry Wool (woollen jumpers) Load (kg) Spin speed (rpm) Suggested duration (mins) 4 1600 155 - 170 2 1600 80 - 90 1 1600 50 - 60 2 1200 90 - 105 1 1200 40 - 50 4 1600 110
Programmes Load (kg) Energy conApproximate proWater consumption gramme duration (misumption (litre) (kWh) nutes) Synthetics 40°C 3,5 0.50 66 110 Delicates 40°C 3,5 0.53 50 100 Wool/Handwash 30°C 1,5 0.25 45 56 1) «Cotton Energy Saving programme » at 60°C with a load of 7 kg is the reference programme for the data entered in the energy label, in compliance with EEC 92/75 standards. OPTIONS TEMP. Set this option to change the default temperature. Indicator = cold water.
TIME SAVE Press Time Save to decrease the programme time. You can select: • • Some programmes accept only one of these options. QUICK: to wash items with daily soil. SUPER QUICK: to wash quickly items with almost no soil. SETTINGS CHILD LOCK With this option you can prevent that the children play with the control panel. • To activate/deactivate this option, press and at the same time until the indicator comes on/goes off.
USING DETERGENT AND ADDITIVES B 1. Measure out the detergent and the fabric conditioner. 2. Put the detergent and the fabric conditioner into the compartments. 3. Carefully close the detergent drawer. 4. Position B for liquid detergent. 5. Close the detergent dispenser. DETERGENT COMPARTMENTS Detergent compartment for prewash phase. Detergent compartment for washing phase. Compartment for liquid additives (fabric conditioner, starch).
• The programme starts, the door locks, the • display shows the indicator . The drain pump can operate for a short time when the appliance fills water. After approximately 15 minutes from the start of the programme: • The appliance adjusts automatically the programme duration agree with the laundry load. • The display shows the new value. 2. Turn the programme knob again to activate the appliance. Now, you can set a new washing programme.
1. If necessary, decrease the spin speed. If you set , the appliance only drains. . The appliance drains the water and 2. Press spins. 3. When the programme is completed, and the door lock indicator the door. goes off, you can open 4. Turn the programme knob to position deactivate the appliance. The energy saving status decreases the energy consumption when the appliance is on the stand by. • All indicators and the display go off.
calculates also the duration of the anticrease and the cooling phases. 2. Press to start the programme. • The display shows regularly a new time value. • • The drying indicator starts to flash. The display shows the door locked indicator . If you set only 10 minutes of drying, the appliance performs only a cooling phase. If the laundry is not sufficient dry, set again a short drying time. END OF THE DRYING PROGRAMME The appliance stops automatically. • The acoustic signals operate (if they are active).
shows the final time value , that is the total duration of the washing and drying cycles (washing + drying + anti-crease + cooling phases). If you set only 10 minutes of drying after washing, the appliance calculates also the duration of the anti-crease and the cooling phases. 2. Press to start the programme. In the display the indicator comes on. The door is locked. The display shows regularly a new time value. END OF THE PROGRAMME The appliance stops automatically.
DETERGENTS AND ADDITIVES • Only use detergents and additives specially made for washing machines: – powder detergents for all types of fabric, – powder detergents for delicate fabrics (40 °C max) and woollens, – liquid detergents, preferably for low temperature wash programmes (60 °C max) for all types of fabric, or special for woollens only. • Do not mix different types of detergents. • To help the environment, do not use more than the correct quantity of detergent.
CARE AND CLEANING MAINTENANCE WASH With the low temperature programmes it is possible that some detergent stays in the drum. Perform a maintenance wash regularly. To do this: • Remove all laundry from the drum. • Select the cotton programme with the highest temperature with a small quantity of detergent. WARNING! Refer to Safety chapters. EXTERNAL CLEANING Clean the appliance with soap and warm water only. Fully dry all the surfaces. CAUTION! Do not use alcohol, solvents or chemical products.
5 6 7 8 1 2 1 2 9 CLEANING THE INLET HOSE AND THE VALVE FILTER 1 1 2 3 4 2 45° 3 20° EMERGENCY DRAIN Because of a malfunction, the appliance cannot drain the water. If this occurs, do steps (1) through (9) of 'Cleaning the drain filter'. If necessary, clean the pump. When you drain the water with the emergency drain procedure, you must activate the drain system again: 1. Put 2 litres of water in the main wash compartment of the detergent dispenser. 2. Start the programme to drain the water.
First try to find a solution to the problem (refer to the table). If the problem persists, contact the Authorised Service Centre. With some problems, the acoustic signals operate and the display shows an alarm code: • • • - The appliance does not fill with water properly. • - The mains supply is unstable. Wait until the mains supply is stable. • - No communication between electronic elements of the appliance. Switch off and switch on again. WARNING! Deactivate the appliance before you do the checks.
Problem Possible solution Set the drain programme if you set a programme without drain phase. Set the drain programme if you set an option which ends with water in the tub. The spin phase does not operate or the washing cycle lasts longer than usually. Set the spin programme. Make sure that the drain filter is not clogged. Clean the filter, if necessary. Refer to 'Care and cleaning'. Adjust manually the items in the tub and start the spin phase again. This problem may be caused by balance problems.
Problem The appliance does not dry or does not dry correctly. Possible solution Turn the water tap on. Make sure the drain filter is not clogged. Reduce the laundry load. Make sure you have set the correct cycle. if necessary ,set again a short drying time. The laundry is full of different colours fluff. The fabrics washed in the previous cycle released fluff of a different colour: • The drying phase helps to eliminate some fluff. • Clean the clothes with a fluff remover.
TECHNICAL DATA Dimension Width/ Height/ Depth/ Total depth 600 mm/ 850 mm/ 522 mm/ 555 mm Electrical connection Voltage Overall power Fuse Frequency 230-240 V 2200 W 13 A 50 Hz Level of protection against ingress of solid particles and moisture ensured by the protective cover, except where the low voltage equipment has no protection against moisture IPX4 Water supply pressure 1) Minimum Maximum 0,5 bar (0,05 MPa) 8 bar (0,8 MPa) Maximum wash load Cotton 7 kg Maximum dry load Cotton Synthetics
132948200-A-022016 WWW.ZANUSSI.
