User Manual GETTING STARTED? EASY.
SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference. CHILDREN AND VULNERABLE PEOPLE SAFETY WARNING! Risk of suffocation, injury or permanent disability.
by clients in hotels, motels, bed & breakfast and other residential type environments; – areas for communal use in blocks of flats or in launderettes. The appliance shall be installed as a freestanding product or below the kitchen worktop if space margins permit. Do not install the appliance behind a lockable door, a sliding door or a door with a hinge on the opposite side, that would prevent the appliance door from being fully open.
• • • • • • • • • • • Items that have been soiled with substances such as vegetable or mineral oil, acetone, alcohol, petrol, kerosene, spot removers, turpentine, waxes and wax removers should be washed separately with an extra amount of detergent before being dried in the washer dryer. Do not use the appliance if items have been soiled with industrial chemicals. Do not dry unwashed items in the wash dryer.
• • • • • • • The floor area on which the appliance is to be installed must be flat, stable, heat resistant and clean. Keep the transit bolts in a safe place. If the appliance is to be moved in the future they must be reattached to lock the drum to prevent an internal damage. Always take care when moving the appliance as it is heavy. Always use safety gloves and enclosed footwear. Do not install or use a damaged appliance. Do not install the appliance where the appliance door cannot be fully opened.
PRODUCT DESCRIPTION APPLIANCE OVERVIEW 1 2 1 Worktop 2 Detergent dispenser 3 3 Control panel 4 Door handle 4 5 Rating plate 6 Drain pump filter 5 7 Feet for levelling the appliance 6 7 INSTALLATION ON SUSPENDED FLOORING Suspended wooden floors are particularly susceptible to vibration. To limit vibration we recommend placing a waterproof wooden panel, at least 15 mm thick, under the appliance. It should be screwed to at least 2 floor beams and should extend beyond the front feet.
CONTROL PANEL CONTROL PANEL DESCRIPTION 1 2 3 4 Cotton Cotton Dry 5 Synthetics Dry Synthetics Wool Dry 60° 90° Economy 30° 20° 1400 1200 40° Drying Time Prewash Temp. 800 6 7 Wool Spin Rinse Auto Dry Extra Rinse 400 Delicates Spin 8 Mix 20° Start/Pause Drain Super ECO 11 1 Programme knob 2 Spin reduction 3 Temperature 4 Display 5 Drying time 6 Prewash phase 10 7 Additional rinse (Spin) 9 (Extra Rinse) 8 Automatic drying level (Temp.
Time area : Programme duration : Selected drying time : Delay start : Alarm codes A : Message of error : The programme is completed.
Programme Temperature range Maximum load Reference spin speed Programme description (Type of load and soil level) 1,5 kg 1200 rpm Machine washable wool, hand washable wool and other fabrics with «hand washing» care symbol3). 3,5 kg 1200 rpm Delicate fabrics such as acrylics, viscose and mixed fabrics requiring gentler washing. Normal soil. Mix 20° 20°C 3 kg 1200 rpm Special programme for cotton, synthetic and mixed fabrics lightly soiled. Select this programme to reduce the energy consumption.
Programme Temperature range 30°C Miniprogramme Maximum load Reference spin speed Programme description (Type of load and soil level) 1,5 kg 800 rpm A short cycle for synthetic and delicate items with light soil level or for items to freshen up. 1) Cottons energy saving programme. This programme at 60ºC with a load of 7 kg is the reference programme for data entered in the energy label, in compliance with 96/60/EC Directive.
Programme ■ ■ ■ ■ ■2) ■ ■ ■ ■ ■ ■ 1) Only the QUICK option is available. 2) Available only if the last spin speed step is lower than 800 rpm.
Suggested duration (mins) Type of fabric Cupboard Dry For items to be stored Synthetics and mixed fabrics (jumpers, blouses, underwear, household and bed linen) 2 1200 95 - 110 1 1200 45 - 55 Iron Dry Suitable for ironing Cottons and Linen (sheets, tablecloths, shirts, etc) 4 1400 110 - 125 2 1400 65 - 75 1 1400 40 - 50 1 1200 80 - 100 Wool dry Wool (woollen jumpers) Load (kg) Spin speed (rpm) Dryness Level CONSUMPTION VALUES Stated values are obtained in laboratory conditions w
Programmes Load (kg) Energy conApproximate proWater consumption gramme duration (misumption (litre) (kWh) nutes) Synthetics 40°C 3,5 0.47 50 171 Delicates 40°C 3,5 0.53 62 121 Wool/Handwash 30°C 1,5 0.25 45 58 1) «Cotton Energy Saving programme » at 60°C with a load of 7kg is the reference programme for the data entered in the energy label, in compliance with 96/60/EC Directive. OPTIONS TEMP. Set this option to change the default temperature. Indicator = cold water.
TIME SAVE Press Time Save to decrease the programme time. You can select: • • Some programmes accept only one of these options. QUICK: to wash items with daily soil. SUPER QUICK: to wash quickly items with almost no soil. SETTINGS CHILD LOCK With this option you can prevent that the children play with the control panel. • To activate/deactivate this option, press and at the same time until the indicator comes on/goes off.
LIQUID OR POWDER DETERGENT 1. Position A for powder A detergent (factory setting). CAUTION! Make sure that no laundry stays between the seal and the door. There is a risk of water leakage or damage to the laundry. 2. Extract the detergent dispenser. 1 2 Washing heavily oiled, greasy stains could cause damage rubber parts of the washing machine. USING DETERGENT AND ADDITIVES 1. Measure out the detergent and the fabric conditioner. 2. Put the detergent and the fabric conditioner into the compartments. 3.
When you use the liquid detergent: • Do not use gelatinous or thick liquid detergents. • Do not put more liquid then the maximum level. • Do not set the prewash phase. • Do not set the delay start. • The door locks, the display shows the • . indicator When the countdown is completed, the programme starts automatically. You can cancel or change the set of the delay start before you press the . To cancel the delay start: • SETTING A PROGRAMME 1.
1. Press to pause the appliance. 2. Wait until the door lock indicator 3. Open the door. goes off. . 4. Close the door and press again The programme or delay start continues to operate. AT THE END OF THE PROGRAMME • The appliance stops automatically. • The acoustic signal operates (if it is activated). • In the display • The indicator of the • • • The door lock indicator goes off. You can open the door. Remove the laundry from the appliance. Make sure that the drum is empty. Close the water tap.
The display shows a time value, calculated on the default load size. If the amount of your laundry is more or less than the default size, the appliance adjusts automatically the time value during the cycle. 2. Press The display shows the door locked indicator . TIMED DRYING The laundry can also be dried with a manual timed drying: again and again to set the time value 1. Press (see the «Programmes for timed drying» table). • The display shows 10 minutes.
The display shows the indicator . The time value on the display is the duration of the washing + drying cycles, calculated on a default load size. To have a good drying the appliance does not let you set a too low spin speed for the items to be washed and dried. 2. Press to start the programme. In the display the indicator of the set dryness level stays on. The door locked indicator goes on. The display shows regularly a new time value.
• • • • • Remove hard stains with a special detergent. Wash and pre-treat heavy soil stains before putting items in drum Be careful with the curtains. Remove the hooks and put the curtains in a washing bag or pillowcase. Do not wash laundry without hems or with cuts. Use a washing bag to wash small and/or delicate items (e.g. underwired bras, belts, tights, etc. ). A very small load can cause balance problems with the spin phase.
• • type of laundry weight of the load ADDITIONAL DRYING If, at the end of the drying programme, the laundry is still damp, set a short drying cycle again. WARNING! To avoid creasing and shrinkage do not overdry the laundry. Experience will help you to dry the laundry better. Take note of the duration of the cycles done before. To avoid the static charge at the end of the drying cycle: 1. Use fabric conditioner in the washing cycle. 2. Use special fabric conditioner for tumble dryers.
CLEANING THE DRAIN FILTER WARNING! Do not clean the drain filter if the water in the appliance is hot. Repeat the steps 2 and 3 until the water stops flowing out. Regularly check the drain pump filter and make sure that it is clean. 1 2 3 2 4 2 1 180° 1 5 6 7 2 8 1 CLEANING THE INLET HOSE AND THE VALVE FILTER 1 1 2 3 4 2 45° 3 20° EMERGENCY DRAIN Because of a malfunction, the appliance cannot drain the water. If this occurs, do steps (1) through (8) of 'Cleaning the drain filter'.
5. When the drain pump is empty, install the inlet hose again. WARNING! Make sure that the temperature is higher than 0 °C before you use the appliance again. The manufacturer is not responsible for damages caused by low temperatures. TROUBLESHOOTING WARNING! Refer to Safety chapters. INTRODUCTION The appliance does not start or it stops during operation. First try to find a solution to the problem (refer to the table). If the problem persists, contact the Authorised Service Centre.
Problem The appliance does not drain the water. Possible solution • • • • • • • The spin phase does not operate or the washing cycle lasts longer than usually. • • • • • There is water on the floor. • • You cannot open the appliance door. • • • • • Set the spin option. Set the drain option if you set an option which ends with water in the drum. Make sure that the drain filter is not clogged. Clean the filter, if necessary. Refer to 'Care and cleaning'.
Problem The appliance does not dry or does not dry correctly. The laundry is full of different colours fluff. Possible solution • • • • Turn the water tap on. Make sure the drain filter is not clogged. Reduce the laundry load. Make sure you have set the correct cycle. If necessary ,set again a short drying time. The fabrics washed in the previous cycle released fluff of a different colour: • The drying phase helps to eliminate some fluff. • Clean the clothes with a fluff remover.
Electrical connection Voltage Overall power Fuse Frequency 230-240 V 2200 W 13 A 50 Hz Level of protection against ingress of solid particles and moisture ensured by the protective cover, except where the low voltage equipment has no protection against moisture IPX4 Water supply 1) Cold water Water supply pressure 2) Minimum Maximum 0.5 bar (0.05 MPa) 8 bar (0.
157024690-A-372018 WWW.ZANUSSI.