User manual

• Select the hottest cotton wash programme.
• Use a normal measure of detergent, must be
a powder with biological properties.
External cleaning
Clean the exterior cabinet of the appliance with
soap and water only, and then dry thoroughly.
Cleaning the dispenser drawer
The washing powder and additive dispenser
drawer should be cleaned regularly.
If necessary, the
whole detergent
drawer can be taken
out of the machine for
cleaning. You need to
pull it firmly outwards,
so that it comes free
of retaining stop.
To remove the siphon
at the inside edge of
the drawer for clean-
ing, you need to
press it inwards and
pull it upwards at the
same time. Flush it
out under a tap, to re-
move any traces of
accumulated powder.
When you put it back, press it downwards until
you hear a distinct click.
Cleaning the drawer recess
Having removed the
drawer, use a small
brush to clean the re-
cess, ensuring that all
washing powder resi-
due is removed from
the upper and lower
part of the recess.
Replace the drawer and run the rinse pro-
gramme without any clothes in the drum.
Cleaning the water inlet filter
If your water is very hard or contains traces of
lime deposit, the water inlet filter may become
clogged. It is therefore a good idea to clean it
from time to time.
Turn off the water
tap. Unscrew the wa-
ter inlet hose. Clean
the filter using a hard
bristle brush. Tighten
up the inlet hose.
The dangers of freezing
If the machine is exposed to temperatures be-
low 0°C, certain precautions should be taken.
• Turn off the water supply.
• Unscrew the inlet hose from the supply tap.
• Select a wash programme, start the machine
and let the programme run for a short time.
• Interrupt the programme by turning the pro-
gramme selector to
position.
• Place the end of inlet and drain hoses down
low, into the waste gully (floor drain) set into
the floor. Make sure that the end of the hose
does not go below the water level in the gul-
ly's (drain's) water tap.
• Select the programme "Drain" and let it run
until it is finished.
•
Turn the programme selector to
position.
When you intend to start the machine up
again, make sure that the room temperature
is above 0 °C.
The appliance is only to be used and stored in-
doors at normal room temperature. The manu-
facturer is not responsible for any frost damage.
What to do if…
Certain problems are due to lack of simple
maintenance or oversights, which can be
15
www.zanussi.com