User Manual GETTING STARTED? EASY.
SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference.
• • • • • • • • • • – areas for communal use in blocks of flats or in launderettes. Do not exceed the maximum load of 9 kg (refer to the "Programme chart" chapter). The operating water pressure at the water entry point from the outlet connection must be between 0.5 bar (0.05 MPa) and 8 bar (0.8 MPa). The ventilation opening in the base must not be covered by a carpet, mat, or any floor covering.
• • • • • • Make sure that there is air circulation between the appliance and the floor. When the appliance is in its permanent position, check if it is levelled correctly with the aid of a spirit level. If it is not, adjust the feet accordingly. Do not install the appliance directly above a floor drain. Do not spray water on the appliance and do not expose it to excessive humidity. Do not install the appliance where the appliance door cannot be fully opened.
INSTALLATION WARNING! Refer to Safety chapters. UNPACKING 1. Remove the external film. If necessary, use a cutter. 5. Remove the polystyrene protection from the bottom. Put the appliance back into an upright position. 2. Remove the cardboard top and the polystyrene packaging materials. 1 2 6. . Remove the power supply cable and the drain hose from the hose holders. 3. Open the door. Remove all the items from the drum . 4. Put the front polystyrene packaging element on the floor under the appliance.
1. Connect the water inlet hose to the back of the appliance. 45º 20º 8. Put the plastic caps, that you find in the user manual bag, in the holes. We recommend that you keep the packaging and the transit bolts for any transport of the appliance. INFORMATION FOR INSTALLATION Positioning and levelling Adjust the appliance correctly to prevent vibration, noise and movement of the appliance when it operates. 1. Install the appliance on a flat hard floor. The appliance must be levelled and stable.
The end of the drain hose must always be ventilated , i.e. the inner diameter of the drain pipe (min. 38 mm - min. 1.5") must be larger than the external diameter of the drain hose. 5. Without the plastic hose guide, to a sink spigotPut the drain hose in the spigot and tighten it with a clamp. Refer to the illustration. Make sure that the plastic guide cannot move when the appliance drains and the drain hose end is not immersed in the water. There may be a return of dirty water into the appliance. 3.
PRODUCT DESCRIPTION APPLIANCE OVERVIEW 1 2 8 3 9 10 4 5 11 12 6 7 1 Worktop 2 Detergent dispenser 8 Drain hose 9 Inlet hose connection 3 Control panel 4 Door handle 10 Mains cable 11 Transit bolts 12 Hose support 5 Rating plate 6 Drain pump filter 7 Feet for levelling the appliance CONTROL PANEL SPECIAL FEATURES Your new washing machine meets all modern requirements for an effective treatment of laundry with low water, energy and detergent consumption and proper care of fabric.
CONTROL PANEL DESCRIPTION 1 Wool/Silk Denim Outdoor Sport Rapid 14 min 2 3 4 5 6 7 Cotton Flex Cotton Temp. Time Manager Spin Delay Start Synthetics Delicate Delicate Steam Duvet Steam Refresh Rinse Spin/Drain Prewash Stain Extra Rinse Soft Plus Plus Steam 10 9 8 On/Off 13 1 Programme dial 2 Spin touch button 3 Temp.
The Temperature area: Temperature indicator . Cold water indicator. Child safety lock indicator. Door locked indicator. Delay start indicator. The digital indicator can show: • Programme duration (e. g. • Delay time (e. g. • Cycle end ( ). ). ). • Warning code (e.g. • Error indicator ( ). ). Time Manager indicator. Steam phase indicator. Anti-crease phase indicator. Drum clean indicator. This is a recommendation to perform the drum cleaning. The spin area: Spin speed indicator No Spin indicator.
DIAL AND BUTTONS INTRODUCTION fabrics from creasing. The washing programme ends with water in the drum. The options/functions are not available with all washing programmes. Check the compatibility between options/ functions and washing programmes in the "Programme Chart". An option/ function can exclude another one, in this case the appliance doesn't allow you to set incompatible options/ functions. ON/OFF Press this button for a few seconds to activate or deactivate the appliance.
The corresponding indicator above the touch button illuminates. Use this option for laundry with hard stains to remove. When you set this option, put the stain remover into compartment . This option increases the programme duration. This option is not available with a temperature lower than 40 °C. PERMANENT EXTRA RINSE With this option you can add a few rinses according to the selected washing programme. Use this option for people with allergies to detergent residues and with sensitive skin.
Cotton ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ Synthetics Cotton Flex indicator Time Manager with steam programmes When setting a steam programme, this button allows to chose three steam levels and the programme duration is reduced accordingly: • : maximum. • : medium. • : minimum. In some appliances the programme duration is reduced without showing any dashes. START/PAUSE Touch the Start/Pause button to start, pause the appliance or interrupt a running programme.
Programme Reference Default temperaspin speed Maximum ture Spin speed load Temperature range range Steam programmes Programme description (Type of load and soil level) with FreshScent System Steam programmes can be used for reducing wrinkles and odours2) of garments that just need to be refreshed, avoiding washing. The fabric fibres are relaxed and afterwards ironing becomes effortless. When the programme is completed, quickly remove the laundry from the drum3).
Programme Reference Default temperaspin speed Maximum ture Spin speed load Temperature range range Spin/Drain Rinse Programme description (Type of load and soil level) 1400 rpm (1400 400 rpm) 9 kg All fabrics, except woollens and delicate fabrics. To spin the laundry and to drain the water in the drum. 1400 rpm (1400400 rpm) 9 kg All fabrics, except woollens and very delicate fabrics. Programme for rinsing and spinning the laundry. The default spin speed is the one used for cotton programmes.
Programme Reference Default temperaspin speed Maximum ture Spin speed load Temperature range range Outdoor 30 °C 40 °C - Cold 1200 rpm (1200400 rpm) Programme description (Type of load and soil level) 2.5 kg4) 1 kg5) Do not use fabric softener and make sure that there is no softener residue in the detergent dispenser. Synthetic sport items. This programme is designed to gently wash modern outdoor sportswear and is also suitable for gym, cycling or jogging clothes or similar.
Programme Reference Default temperaspin speed Maximum ture Spin speed load Temperature range range Wool/Silk 40 °C 40 °C - Cold 1200 rpm (1200 400 rpm) 1.5 kg Programme description (Type of load and soil level) Machine washable wool, hand washable wool and other fabrics with «hand washing» care symbol6). 1) Standard programme for the "Egyptian" Energy Label consumption values. According to regulation 4100/2006 , the most efficient for washing soiled cotton laundry.
Outdoor ■ ■ ■ Denim ■ ■ ■ Wool/Silk ■ ■ ■ ■ ■ ■ Time Manager Delay Start Plus Steam Soft Plus Extra Rinse Stain 2) Prewash1) No Spin Spin Programme ■ ■ ■ ■ 1) Prewash and Stain cannot be selected together. 2) This option is not available with temperature lower than 40 °C. 3) If you set the No Spin option, the appliance performs draining only.
BEFORE FIRST USE 1. Make sure that the electrical power is available and the water tap is open. 2. Pour 2 litres of water into the detergent . compartment marked by This action activates the drain system. 3. Pour a small quantity of detergent into the compartment marked by 4. Set and start a programme for cotton at the highest temperature without any laundry in the drum. This removes all possible dirt from the drum and the tub. . DAILY USE WARNING! Refer to Safety chapters.
CHECK THE POSITION OF THE DETERGENT FLAP 1. Pull out the detergent dispenser until it stops. SETTING A PROGRAMME 1. Turn the programme dial to select the desired washing programme. The indicator of the Start/Pause button flashes. The display shows an indicative programme duration and the maximum load. 2. To change the temperature and/or the spin speed, touch the related buttons. 3. If desired, set one or more options by touching the related buttons.
When the countdown is completed, the programme starts automatically. despite the overload. In this case, it will be not possible to guarantee the best washing results. 2. Touch the Start/Pause button to pause the appliance. The related indicator flashes. About 20 minutes after the programme start, the programme duration could be adjusted again depending on the capacity of water absorption of the fabrics. 3. Touch the Delay Start until the display shows goes off. button repeatedly and the indicator 4.
OPENING THE DOOR - ADDING GARMENTS If the temperature and level of the water in the drum are too high and/or the drum is still rotating you should not open the door. While a programme or the delay start operates, the appliance door is locked. The display shows the indicator . 1. Touch the Start/Pause button. In the display the related door lock indicator goes off. 2. Open the appliance door. If necessary, add or remove the items. Close the door and touch button.
HINTS AND TIPS WARNING! Refer to Safety chapters. THE LAUNDRY LOAD • Divide the laundry into: white, coloured, synthetics, delicates and wool. • Follow the washing instructions on the laundry care labels. • Do not wash white and coloured items together. • Some coloured items can discolour with the first wash. We recommend that you wash them separately for the first couple of times. • Button up pillowcases, close zippers, hooks and poppers. Tie up belts.
CARE AND CLEANING WARNING! Refer to Safety chapters. EXTERNAL CLEANING Clean the appliance with mild soap and warm water only. Fully dry all the surfaces. CAUTION! Do not use alcohol, solvents or chemical products. CAUTION! Do not clean the metal surfaces with chlorine-based detergent. DESCALING If the water hardness in your area is high or moderate, we recommend that you use a water descaling product for washing machines. Regularly examine the drum to check for limescale.
1. Open the drawer. Press the catch downwards as indicated in the picture and pull it out. without any clothes in the drum. 1 2 2. Remove the top part of the additive compartment to aid cleaning and flush it out under running warm water, to remove any traces of accumulated detergent. After cleaning, put the top part back into position. CLEANING THE DRAIN PUMP WARNING! Disconnect the mains plug from the mains socket. Regularly check the drain pump filter and make sure that it is clean.
4. Turn the filter 180 degrees in anti-clockwise direction to open it, without removing. Let the water flow out. 10. Clean the filter under the water tap. 11. Put the filter back into the special guides by turning it clockwise. Make sure that you tighten the filter correctly to prevent leakages. 2 5. When the bowl is full of water, turn the filter back and empty the container. 6. Repeat the steps 4 and 5 until the water stops to flow out. 7. Turn the filter anti-clockwise to remove it. 1 12.
When you drain the water with the emergency drain procedure, you must activate the drain system again: a. Put 2 litres of water in the main wash compartment of the detergent dispenser. b. Start the programme to drain the water. CLEANING THE INLET HOSE AND THE VALVE FILTER 1 2 3 45° 20° EMERGENCY DRAIN If the appliance cannot drain the water, carry out the same procedure, described in 'Cleaning the drain pump' paragraph. If necessary, clean the pump.
TROUBLESHOOTING WARNING! Refer to Safety chapters. INTRODUCTION The appliance does not start or it stops during operation. First try to find a solution to the problem (refer to the table). If the problem persists, contact the Authorised Service Centre. WARNING! Deactivate the appliance before carrying out any check. In case of major problems, the acoustic signals operate, the display shows an alarm code and the Start/Pause • • • button may flash continuously: - The mains supply is unstable.
POSSIBLE FAILURES Problem The programme does not start. Possible solution • • • Make sure that the mains plug is connected to the mains socket. Make sure that the appliance door is closed. Make sure that there is no damaged fuse in the fuse box. • • Make sure that the Start/Pause has been touched. If the delay start is set, cancel the setting or wait for the end of countdown. Deactivate the Child Lock function if it is on. Check the position of the knob on the selected programme.
Problem Possible solution • The appliance makes an unusual noise and vibrates. • • The programme duration increases or decreases during programme execution. Make sure the levelling of the appliance is correct. Refer to "Installation instruction". Make sure that the packaging and/or the transit bolts are removed. Refer to "Installation instruction". Add more laundry in the drum. The load may be too small.
5. Take out the laundry and then close the appliance door. 6. Close the filter flap. ONSUMPTION VALUES Stated values are obtained in laboratory conditions with relevant standards. Different causes can change the data: the quantity and type of laundry and ambient temperature. Water pressure, the supply voltage and the temperature of inlet water may also affect the washing programme duration. Technical specifications may be changed without prior notice to improve the quality of product.
Off Mode (W) 0.30 Left On Mode (W) 0.30 The information given in the chart above is compliant with the EU Commission regulation 1015/2010 implementing directive 2009/125/EC .
STACKING KIT WARNING! Do not put the tumble dryer under the washing machine. PEDESTAL WITH THE DRAWER The tumble dryer can be stacked on the top of the washing machine only by using the correct stacking kit manufactured and approved by ELECTROLUX. Verify the compatible stacking kit by checking the depth of your appliances. The stacking kit can be used only with the appliances specified in the leaflet provided with the accessory.
QUICK GUIDE DAILY USE 1 2 3 5 4 Connect the mains plug to the mains socket. Open the water tap. Load the laundry. Pour the detergent and other treatment in the proper compartment of the detergent dispenser. 1. Push the On/Off button to turn the appliance on. Turn the programme dial to set the desired programme. 2. Set the desired options by means of the corresponding touch buttons (1). To start the programme, touch the Start/Pause button (2). 3. The appliance starts.
ENVIRONMENTAL CONCERNS with the symbol with the household waste. Return the product to your local recycling facility or contact your municipal office. Recycle materials with the symbol . Put the packaging in relevant containers to recycle it. Help protect the environment and human health by recycling waste of electrical and electronic appliances.
157026050-A-462018 WWW.ZANUSSI.
