FREEZER ZV 47 RM INSTRUCTION BOOKLET 2222691-65
Contents Instructions for the installer Instructions for the user Important Safety Instructions 3 Technical specifications 13 Description of the Appliance 4 Installation 13 Operation 5 Positioning Door Reversal Before use Start your appliance Temperature control Warning light (red) Freezing fresh food Frozen food storage Cold accumulator Thawing Ice making Normal Operating Sound 5 5 5 5 5 6 7 7 7 7 Health and safety guidelines 8 Defrosting 8 Maintenance and Cleaning 9 Internal cleaning E
Important Safety Instructions These warnings are provided in the interests of your safety. Ensure that you understand them all before installing or using this appliance. Your safety is of paramount importance. If you are unsure about any of the meanings of these warnings contact the Customer Care Departement. Prior to Installation ■ Check the appliance for transport damage. Under no circumstance should a damaged appliance be installed. In the event of damage please contact your retailer.
Description of the Appliance 6 5 4 A 1 2 3 B D C A - Freezer controls B - Freezer calendar (recommended storage times for frozen foods) C - Freezer food storage D - Freezing fresh food 4
Operation Before use Remove all securing tapes. Wash inside the appliance with lukewarm water and bicarbonate of soda (5 ml to 0.5 litre of water). Do not use soap or detergent as the smell may linger. Dry thoroughly. Freezer controls 6 5 4 1 2 3 A B CDE A - Thermostat control B - Fast freeze switch C - Fast freeze light (yellow) D - Warning light (red) E - Mains-on light (green) Start your appliance Insert the plug into the wall socket.
In order to make use of the appliance's full volume, remove the two centre drawers marked "x" (see. figure), so creating more space inside the freezer. Once the food is completely frozen (which could take up to 24 hours) return the fast freeze switch to the «OFF» position; the yellow light (C) goes off. Distribute the frozen food packages in the other compartments, so that the two top compartments can be used for a further freezing operation.
Cold accumulator The freezer contains one cold accumulator which can be found in the top compartment. The cold accumulator increases storage times in the event of a power cut or breakdown. It must be placed on top of the food. Removal of this unit will increase the capacity of the fast freezing compartment but will reduce storage times in the event of a power cut or breakdown.
Health and Safety Guidelines Because of consumer demand, preservatives have been removed from many pre-prepared food. This together with the changes in shopping habits to a once-a-week shop, mean that safe handling and storage of food is even more important than ever. The following tips should help you to ensure that the food in your home is in as perfect condition as possible. ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ Keep the freezer door closed as much as possible.
Turn the thermostat control to a medium setting between 2 and 4 and, after letting the appliance run for at least two hours in the «fast freeze» mode, replace the previously removed food into the compartments. Important In the event of a power failure causing the temperature within your freezer to rise, do not re-freeze the food without checking its condition. The following guidelines should assist you: Ice-cream: once thawed should be discarded. Fruits & Vegetables: if soft should be cooked and used up.
Something not Working? Important: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation a charge will be made, even if the appliance is under guarantee. Before contacting your local Service Force Centre check the following points. Symptom Solution No power to appliance - Check there is power at the socket. - Check there is not a power cut by checking the household lights. - Check the fuse has not blown.
Service and Spare Parts In the event of your appliance requiring service, or if you wish to purchase spare parts please contact your local Zanussi Service Force Centre by telephoning: Before calling out an engineer, please ensure you have read the details under the heading ‘Something Not Working?’ When you contact the Service Centre you will need to give the following details. 08705 929929 1. Your name, address and post code 2. Your telephone number 3.
Guarantee Conditions Standard guarantee conditions We, Zanussi Limited, undertake that if within 12 months of the date of purchase this Zanussi appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour, materials or carriage on condition that: ■ The appliance has been correctly installed and used only on the electricity supply stated on the rating plate.
Technical specifications DIMENSIONS Height Width Depth POWER SUPPLY VOLTAGE AND FREQUENCY TOTAL POWER ABSORBED AVERAGE DAILY UNITS ELECTRICITY(*) 220-240 V / 50 Hz 110 W 0,70 kWh GROSS CAPACITY 110 l NET CAPACITY 85 59,5 60 cm cm cm 96 l STAR RATING (*)This figure is based on standard test results in accordance with European Standard EN153. Actual consumption will depend on how the appliance is used and where it is located).
Door Reversal Before carrying out the operations described below, pull out the mains plug from the wall socket. To carry out this reversal go through the following steps: 1. Gently lay the appliance on its back with the top held away from the floor by 5-8 cm (2-3 inches) of packing. 2. Remove the bottom door hinge (5). 3. Remove the door (4) by opening it and pulling it gently downwards to remove it from the top hinge pin (2). 4.
Electrical Connection This appliance complies with the E.E.C. Directive No. 87/308 of 2.6.87 relative to radio interference suppression. This appliance complies with the following E.E.C. Directive: WARNING: THIS APPLIANCE MUST BE EARTHED. The manufacturer declines any liability should this safety measure not be observed. - 73/23 EEC of 19.2.73 (Low Voltage Directive) and subsequent amendments. - 89/336 EEC of 3.5.89 (Electromagnetic - Compatibility Directive) and subsequent amendments.
