Operation Manual

14
Something not working?
If, after the above checks, there is still a fault, call
your local Service Centre.
Please make sure you give the model and serial
number of the appliance.
Before contacting your local Service Centre, please make the following checks.
Important!
If light “Einde” flashes, the buzzer sounds and an alarm code is displayed, switch the machine off and call the
Service Centre.
Problem Possible cause
• The dryer does not work:
• The door(s) is(are) open.
• The plug is not fitted into the wall socket.
• There is no electricity supply from the wall socket.
• The selector dial is not set correctly.
• The water reservoir is full or not correctly inserted
(light “Reservoir” is on
)
. The programme starts in
any case but it stops after approx. 4 minutes.
• The start button START/PAUSE has not been
depressed.
• The DELAYED START option has been selected.
• The dryer does not dry properly:
• The filters are clogged.
• The condenser is clogged.
• The water reservoir is full.
• The selected cycle is not suitable for the laundry.
• Insufficient drying time.
• The laundry has not been spun properly.
• The low temperature function
“Lage tamp” has
been selected.
• Excessive laundry load.
• The dryer is not correctly installed.
This information can be found on the rating plate
(see picture on page 4).
125981111 gb.qxp 2005-03-07 08:39 Page 14