Operation Manual

10
Operating sequence
Before using your tumble dryer for the first time, we
recommend to place a few damp cloths inside the
appliance and dry for 30 minutes.
There may be dust inside a brand new tumble dryer.
Drying
1. Connect the appliance.
2. Open the door (see picture).
3. Load the items one at a time, shaking them out
loosely.
4. Close the door. Please check the laundry does
not get caught between the door and filter.
5. Select the drying programme or time. The lights
“Drogen” (“Drying”), “Afkoelen”(“Cooling”) and
“Einde” (“End”)come on. The light of the
START/PAUZE button flashes and the display
shows the duration of the programme.
6. If required, press the “Lage temp” (“Low
temperature”) button and/or the “Zoemer Uit”
(“Buzzer OFF”) button or the “Kort” (“Quick
drying”) button.
7. Select the “Startuitstel” (DELAYED START) if
required.
8. Press the Start button START/PAUSE: the
corresponding light stops flashing and drying
starts. Only the light “Drogen” remains lit.
If the programme selector dial is turned to
another position, when the machine is running,
the buzzer will sound and the programme phase
indicator lights will flash.
The drum turns alternately in both directions
during drying.
All drying programmes end with a 10 minute
cooling phase (light “Afkoelen” is on).
You may remove the laundry after this phase.
The lights “Einde”, “Pluizenfilters” and
“Reservoir”illuminate and the buzzer sounds to
inform you the end of the cycle.
P1108
P1149
9. If the laundry is not removed at the end of the
cycle, the dryer performs an anti-creasing
phase (duration: 30 minutes maximum).
If you do not remove the laundry, the dryer will stop
automatically at the end of the anti-creasing phase.
The lights “Einde”, “Pluizenfilters” and
“Reservoir” remain lit and the buzzer sounds for
2 minutes.
10 Turn the programme selector dial to “RESET”; all
the lights go out. The appliance is switched off.
Remove the laundry.
If you open and then close the door before
turning the selector dial to “RESET” all the
lights corresponding to the phases making up
the performed programme come on..
After each use
• Clean the filters (see page 12).
• Empty the water reservoir (see page 13).
Important!
If the drying programme has to be stopped before it
reaches the end, we recommend that you turn the
programme selector dial to position “Afkoelen” and
wait until the end of this cooling phase before
removing the laundry. This will avoid a build-up of
heat inside the appliance.To do this first turn the dial
to “RESET” and then to “Afkoelen” and depress
Start button START/PAUSE.
Modifying the programme
To change a programme which is running, first
cancel it by turning the programme selector dial to
“RESET”. Select the new programme and press the
Start button START/PAUSE.
125981111 gb.qxp 2005-03-07 08:39 Page 10