Contents Installation Unpacking Positioning & leveling ‘Water connection Electrical connection Operation Controls description Loading the clothes Filling with washing powder Use of additives ‘Which powder? Selection of washing programmer Starting ‘Wash cycle Stopping Care and cleaning Cleaning the machine Cleaning the drain filter Hints for care of washing powder dispenser Helpful tips for washing Servicing Page Page Page Page Page Page Page Page Page Page Page 9 Page Page 12 Page 12 Page 13 Pageant Page 14
Installation Unpacking After removing outer carton, reinforcing angles and polythene wrapping, proceed as follows: 1. Undo and remove the four screws from the back of the appliance (fig. 1). 2. Insert a screwdriver into the free holes theft after removing the four screws, and 4]t it as required to cause the four cardboard spacers to fall down. 3. Lift the machine and remove the polystyrene base packing. 4.
To steady the machine, return the lever back to its original position (fig. 4). Then level the appliance very carefully by instigating the leveling feet located at the front of the base {fig. 5). It is recommended to perform this work very accurately to avoid any vibration, noise or shifting of the appliance during aeration. Also make sure that the washing machine does not touch walls, furniture, ete. while working. Water connection The machine may either be plumbed in or connected to existing taps.
Coil fig.6 B 2383800 Algol, ensure that the drain hoses not chocked or placed in such a way as to obstruct the normal water flow. If the drain hose is to be hooked over the sink, ensure that the sink is empty and that the sink plug is not blocking the plug hole. If an extension is required, its inner diameter must be the same as that of the original hose of the washer and its length must not exceed 2 meters (6 {t). Plumbed installation 1t is important that work is carried out by & qualified plumber.
If you find that the supply water contains foreign matters, such as sand or limestone deposits, we suggest that you install supplementary mechanical strainers which should be fitted on the drain hoses of the washing machine. Mind you that in some cases foreign matters in the supply water can even cause a breakdown of the machine’s electric valves. As for the various types of mechanical strainers available, check with your local plumber.
Operating instructions Controls description 1 Cold wash push button pressing in this push button prior fo selecting a weigh cycle, the programmer will be carried out with cold water only. A cold water program is particularly suitable to wash very delicate synthetic fabrics, curating & drapes. 2 Spin push button «500-1000»: if pressed in af the beginning of an energetic wash cycle, this push button provides the final spin at 1000 pram. instead of 500 rpm.
Loading the clothes Lift the lid on the machine and turn the drum by hand until the loading door appears (fig. Push safety lever A {fig. 8) to the right and press it down until flap door C {fig. 8) disengages. Fasten drum flap door B into the special slits I provided for the purpose, and then place the clothes in the drum taking care to spread them out evenly. Close the loading door by overlapping flap C on flap B, making sure that safety lever A returns o its original position.
‘Which powder? Do not use ordinary powders like Radiant, Day efe. in your new washing machine. The reason for this is very simple, these powders produce so much lather that clothes are prevented from tumbling {leery and cannot get properly clean. Do use the right powder. To get the best results, we recommend Persia Automatic or Ariel Automatic. Like all modern automatic machines the ZT 989 works at peak efficiency with a low lather product.
Energetic wash cycle For Cotton, Linen and Hemp Fabrics Recommended wash load: 10 1bs (4,5 Kgs) max. Wash cycle Position of Dispenser compartments Wash cycle description programmer t0 bused for selector washing fabric powder conditioner, if any Rewash 30 moos. in water at 40°C high level) followed by a soaking pas a laundry is left soaking in water), To drain the waver, turn the program knob to cycle «V» {drain with & gentle spin} or oZ» {drain). Universal wash A ! Pro wash in water 2t 40°C (normal lovely.
Gentle wash cycles For Delicate, Synthetics, Mixed Fabrics and Woolens Recommended wash load: max. 35 Ibs. (1,52 Kafka; wool max. 2 Ibs {1 Kg). Important: There is no water draining in the last rinse of the gentle wash cycles L-MN-P to prevent the clothes from creasing if they are left in the machine at the and of the wash cycle. To drain the water, turn the program selector fo cycle «V» (draining & gentle spinning) or cycle «Z» {draining without spinning).
Stopping ‘When the programmer is completed the machine stops automatically (pilot lamp goes out). You should now press in the program control knob, and wait for about 1-2 minutes after the wash cycles completed before you open the lid, so as to allow the lid safety device {interlock) to release it. If need be, you may stop the machine at any given moment during the cycle by pushing in the program control knob.
fig. 10 4. Turn the filter knob counterclockwise and pull the filter out. Underneath the filter there is & small ex tractable gutter which makes it easier to collect any residual water that might flow out when the filter is removed. 5, Clean filter thoroughly. 6. Refit the filler into the special guides C trig. 12) and turn the knob clockwise until the red notch reappears.
Helpful tips for washing Here are some practical hints to enable you to obtain the best washing results: Use a low suds washing powder specially made for washing machines. An excessive formation of suds will cause unsatisfactory operation. The quantity of washing powder required depends on the amount of laundry and on how soiled it is. It may therefore be necessary to vary the quantities suggested in this book according to experience. o obtain the best results when washing wool do not wash more than 2 lbs.
Servicing Should servicing be required for this appliance contact your local Service Agent but before requesting service the following simple checks may save you inconvenience and expenses: # The machine won’t start — Check that the plugs firmly in the wall socket and that there is an electricity supply by plugging in another appliance. — Check that the lid of the machine is firmly closed. — Check that the required programmer is correctly selected.
APPLIANCE GUARANTEE GAUSSIAN STANDARD GUARANTEE CONDITIONS This guarantee is in addition te your statutory and Luther legal rights which will nat be excluded or in any way diminished by the retain of the guarantee card. We.