DISHWASHER ZT 6810 COP04 152988 48/2 INSTRUCTION BOOKLET en
Contents For the user For the installer Important safety information 3 Description of the appliance 4 The control panel 5 Before use Setting the water softener Rinse aid Use of detergent 7 7 9 10 Using your appliance Loading your appliance Adjusting the height of the upper basket 12 12 14 Hints and tips 15 Washing programmes 16 Operating sequence 17 Maintenance and cleaning Internal cleaning Cleaning the central filter Cleaning the large filter External cleaning Prolonged periods of non-op
Important safety information It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is left with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant safety information. This information has been provided in the interest of your safety.
Description of the appliance 1 13 2 12 3 4 11 5 10 6 9 8 7 IN84 1 Levelling spacers 9. Rinse aid dispenser 2. Upper basket stop 10. Central filter 3. Upper spray arm 11. Lower spray arm 4. Salt container 12. Upper basket 5. Large filter 13. SID (Super Intensity Dispenser) 6. Detergent dispenser 7. Control panel 8.
The control panel 1 2 3 4 5 6 7 In this fully integrated appliance the controls are located on the top of the door. When selecting a programme, the door needs to be partially opened. Audible signals have been introduced to help indicate which operations the dishwasher is performing. 8 9 10 Press both "Programme selector" and "Economy dry" buttons together for about 3 seconds (until you hear an intermittent audible signal lasting about 3 seconds).
2. Rinse aid refill indicator light 8. "Economy drying" pushbutton This light illuminates when the rinse aid has run out, and requires refilling. By pressing this button you can opt to shorten (ECO DRY) or completely omit the drying cycle (NO DRY). The indicator light corresponding to the option selected will illuminate. With programme 1 (rinse and hold) and programme 10 (Plate warmer) this pushbutton is automatically deactivated.
Before use Before using your dishwasher for the first time: 1. ensure that the electrical and water connections comply with the installation instructions 2. remove all packaging from inside the appliance 3. set the water softener 4. fill the salt container 5. fill the rinse aid dispenser 6. run a rinse and hold programme after installation before carrying out a wash programme for the first time.
Filling with salt If your water is "level 0" it is already soft and therefore there is no need to use salt. Salt must be used from "level 1" upward. Only use salt specifically designed for use in dishwashers. All other types of salt not specifically designed for use in dishwasher, especially table salt, will damage the water softener. Only fill with salt just before starting one of the complete washing programmes (not the Rinse and Hold programme).
Rinse aid Rinse aid is automatically added during the last rinse, ensuring thorough rinsing, spot and streak free drying. The dispenser, which is positioned inside the door, holds about 110 ml of rinse aid, which is sufficient for 16 - 40 dishwashing programmes, depending upon the dosage setting. Filling with rinse aid: 1. Open the container by turning the lid (A) anticlockwise. A 2. Add the rinse aid until the container is completely full (approx. 110 ml). The indicator (B) will be completely dark.
Use of detergent Only use detergents specifically designed for use in dishwashers. We recommend the use of Finish detergents which are available in the following options: Finish Double Action Tablets. Each tablet has the exact amount of detergent required, simply place in the dispenser. Finish Powder recommended for every day use. Finish Liquid Gel ideal for every day use. As the gel is extra gentle is it recommended for fine bone china. To fill the dishwasher with detergent proceed as follows: 1.
Compact detergents with enzymes In these compact powders the environmently unfriendly components have been replaced by natural enzymes and other more biodegradable substances. The enzymes deploy their full dirt dissolving power at a temperature as low as 50°C. By choosing the "Bio" programmes you can therefore achieve the same cleaning results that would otherwise be achievable only with 65°C programmes and conventional detergents.
Using your appliance Loading your appliance Before placing dishes in the machine, remove any scraps of food, to avoid clogging the filters and consequently reducing the performance. Do not load very small items which can fall through the baskets. Open the door and slide out the baskets to load the dishes. The lower basket The lower basket is designed to take saucepans, lids, plates (up to 27 cm in diameter), salad bowls, cutlery etc.
The cutlery basket Long bladed knives stored in an upright position are a potential hazard. Long and/or sharp items of cutlery such as carving knives must be positioned horizontally in the upper basket. Take care when loading or unloading sharp items such as knives. Cutlery should be placed in the removable cutlery basket with the handles facing downwards. If the handles protrude from the bottom of the basket, obstructing the lower spray arm, load the cutlery with the handles facing upwards.
The upper basket The upper basket is designed for plates (dessert plates, saucers, dinner plates of up to 24 cm in diameter), salad bowls, cups and glasses; Glasses with long stems can be placed upside down in the raised cup racks. Light items (plastic bowls etc.) should be loaded in the upper basket and arranged so they do not move. US58 Before closing the door, ensure that the spray arms can rotate freely. After loading or unloading your machine always close the door, as an open door can be a hazard.
Hints and tips To save energy Items not suitable for dishwashers: Place dishes in the machine immediately after every meal and wait until the dishwasher is full before washing. The following items should not be washed in the dishwasher (unless they are sold as dishwasher proof): If necessary run the Rinse and Hold programme (see "Washing Programmes" chart on the following page), so that any food scraps do not become caked on the dishes while you are waiting to run the complete wash programme.
Washing programmes Type of load Required pushbuttons Degree of soil 1 RINSE AND HOLD Any. Partial load (to be completed later in the day). 2 INTENSIVE 70°C Heavy soil. Crockery, cutlery, pots and pans 3 NORMAL PLUS WITH PREWASH 65°C Recommended quantity of detergent in the dispenser in the SID / / 1 cold rinse (to avoid food scraps from sticking together).
Operating sequence 1. Check the filters 7. Close the detergent dispenser lid Ensure they are clean and properly positioned (see cleaning instructions). 2. Press the On/Off pushbutton 8. Set the programme Press the programme selector button until the number corresponding to the required programme appears in the display. In the digital display will appear the number of the last programme selected If a programme with prewash has been selected the SID indicator light will come on.
10. At the end of the washing programme The dishwasher will automatically stop, and an intermittent audible signal informs you that the programme has finished (if the delay start has been selected this audible signal will be automatically excluded). In the digital display will appear 3 horizontal lines (---). Switch off the dishwasher by pressing the On/Off pushbutton. When the wash programme has finished, it is recommended that the dishwasher is unplugged and the water tap turned off.
Maintenance and cleaning Internal cleaning Ensure that the seals around the door, the detergent and rinse aid dispensers are cleaned regularly with a damp cloth. We recommend the use of Finish Dishwasher Cleaner every 3 months or run a 65°C wash without dishes using detergent. Regular use of Finish Dishwasher Cleaner cleans inaccessible parts, eliminates unpleasant food odours and helps prevent the build-up of limescale.
Check that the SID is not clogged with detergent residue. If necessary, rinse it under running water after having removed it from the basket by twisting it anticlockwise and pulling it upwards. Fasten it back onto the support by turning it clockwise. Never use your dishwasher without the SID dispenser. Since SID also ensures correct distribution of the water to the upper spray arm, running the dishwasher without it will impair the washing result.
Something not working Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer. Before contacting your local Service Force Centre, please carry out the checks listed below. The dishwasher is fitted with a fault indication system, an alarm will sound and the following codes may be displayed (A1, A2, A3, A4, A5, A6, A7, A8) which can help you to determine the cause of any problems.
Symptom Solution The dishes are not clean (poor wash) ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ The baskets are too full. The dishes have not been arranged properly. The spray arms do not rotate. The spray arms are clogged. The filters are clogged. The filters are not in position. Not enough detergent has been used or it is unsuitable. The detergent is old or has gone hard. The salt container cap is not properly closed. The washing programme selected is too gentle.
If after all these checks, the problem persists, contact your local Service Force Centre, quoting the model and serial number. This information can be found on the rating plate located on the right hand side of the dishwasher door (see picture). Service and spare parts Prod.No. ........ Ser. No. ......... Mod. ........
Guarantee Conditions Standard guarantee conditions We, Zanussi, undertake that if within 24 months of the date of purchase this Zanussi appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour, materials or carriage on condition that: • The appliance has been correctly installed and used only on the electricity supply stated on the rating plate.
Installation instructions Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. Any plumbing work required to install this appliance should be carried out by a qualified plumber or competent person.
Remove all packaging before positioning the machine. If possible, position the machine next to a water tap and a drain. Water supply connections This dishwasher must be plumbed into a cold water supply. The water pressure must be within the limits given in the technical specifications. Your local Water Authority will advise you on the average mains pressure in your area. The dishwasher features fill and drain hoses which can be turned either to the left or the right to suit the installation.
Water outlet hose connection The end of the drain hose can be connected in the following ways: A- To the sink outlet siphon, securing it if necessary with a clip. B- To a wall outlet provided with a vent-hole, minimum internal diameter 4 cm. B min 4 cm C Ø 18 Ø 21 Ø Ø Ensure the hose is not bent or squashed as this could prevent or slow down the discharge of water.
Electrical connection This appliance must be earthed. The manufacturer declines any responsibility should this safety measures not be observed. If the plug that is fitted to your appliance is not suitable for the socket, it must be cut off and the appropriate plug fitted.
This dishwasher is designed to be fitted under a kitchen counter or worksurface. It is essential that the recess dimensions indicated in the diagram are followed. No further openings for venting of the dishwasher are required, but only to let the water fill and drain hose and power supply cable pass through. The recess height may be anywhere between 820 and 880 mm from the floor as the dishwasher incorporates adjustable feet (max 60 mm).
The furniture door 596 max Width: Height: Thickness: Weight: 187 The door on this appliance is designed for the overlay of a panel having the following dimensions: 596 mm 664 - 724 mm max 20 mm max 2 - 7.5 kg max = The panel height should be no more than indicated, otherwise complete opening of the door will no longer be possible as the panel hits against the dishwasher plinth.
Noise protection Adhesive noise protection ensures excellent noise insulation. This should be fitted when the dishwasher has been mounted in the recess and the height adjusted. Apply the protection as shown in the drawing, making sure that the non-adhesive section reaches right down to the floor. II61 Kitchen plinth adjustment To allow correct opening of the door it is sometimes necessary to cut the kitchen plinth. Refer to the cutting table.
