INSTRUCTION BOOKLET WASHING MACHINE ZT 102 124978190
CONTENTS Important information . . . . . . . . . . . . . . . . . Page 3 Installation . . . . . . . . . . . . . . . . . . . . . Page 4 ■ Unpacking . . . . . . . . . . . . . . . . . . . . . . Page 4 ■ Positioning . . . . . . . . . . . . . . . . . . . . . . Page 5 ■ Water inlet . . . . . . . . . . . . . . . . . . . . . . Page 5 ■ Water drainage . . . . . . . . . . . . . . . .
IMPORTANT INFORMATION It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant warnings. These warnings have been provided in the interest of safety.
INSTALLATION Unpacking Before starting the machine up, the packing must be removed as follows. You are advised to keep all the packaging for reuse in case the machine is to be transported again. Using a spanner unscrew and remove the rear right bolt. Lay the machine gently on its back, making sure that the hoses are not squashed. P0255 Remove the polystyrene base and take off the bottom panel by unscrewing the central screw. Carefully slide out the right polythene bag.
Positioning Your new washing machine has been designed to be permanently plumbed in to your home’s water supply and drainage system. However, if this is not possible, it may be connected to suitable existing taps with the drain hose discharging into a sink. The appliance has two inlet hoses, hot and cold, with female 3/4” BSP thread connectors.
Water drainage This appliance is designed to be permanently plumbed into your home’s water supply and drainage system. Hook the end of the drain hose into a standpipe installed for the purpose. The standpipe must have an internal diameter of at least 40 mm (1 1/2") in order that there is an air gap between the drain hose and the standpipe. Make sure, that it is designed in such a way, that the end of the drain hose cannot be covered with water. The drain hose may be extended to a maximum of 4 metres.
Warning The machine should NOT be placed on deep pile carpeting. Note Please ensure that when the appliance is installed it is easily accessible for the engineer in the event of a breakdown. All plumbing and electrical work required to install this appliance must be carried out by competent persons or qualified plumbers or electricians.
Electrical connections WARNING: THIS APPLIANCE MUST BE EARTHED. The manufacturer declines any liability should this safety measure not be observed. If the plug that is fitted to your appliance is not suitable for your socket outlet, it must be cut off and the appropriate plug fitted. Remove the fuse from the cut off plug. The cut off plug should then be disposed of to prevent the hazard of shocks in case it should be plugged into a 13 Amp socket in another part of your home.
Building-in 600 596 600 min. 120 416 818 176,5 515 820 min This appliance has been designed to be built into the kitchen furniture. The recess should have the dimensions shown in picture A. 1 54 195 160 8 165 90 0 49 P0965 A Preparation and assembly of the door The machine is originally pre-arranged for the assembly of a door opening from right to left.
d) Counter-magnet (6) The appliance is pre-arranged for a magnetic closure of the door. To enable a correct operation of this device, it is necessary to screw the countermagnet (6) (steel disk + rubber ring) into the inner side of the door. Its position must correspond to the magnet (4) on the appliance (see picture D). 6 4 8 D P0984 If the door has to be opened from left to right, invert the position of the plates (7), the magnet (4) and the rubber cap (5) (Fig. B and E).
i DESCRIPTION OF THE APPLIANCE 1 1 2 3 4 5 6 7 8 9 Detergent dispenser drawer Programme chart Mains-on light ON/OFF button Half load button Programme selector dial Door handle Drain filter Adjustable feet 3 45 6 2 7 8 1 Detergent dispenser drawer Symbols Prewash 9 Wash Fabric softener P0239 i TECHNICAL SPECIFICATIONS DIMENSIONS Height Width Depth POWER SUPPLY VOLTAGE TOTAL POWER ABSORBED 82 cm (32.3”) 60 cm (23.6”) 54 cm (21.
GETTING TO KNOW YOUR MACHINE Control panel PROGRAMMES ON-OFF HALF LOAD ZT • 102 IMPORTANT : PLEASE READ THE INSTRUCTION BOOK BEFORE USING THIS APPLIANCE 1 2 1 Programme chart It will help you to select the suitable programme for your laundry. 2 Mains-on light This light illuminates when the machine starts working and goes out when the ON/OFF button is released. 3 ON/OFF button By depressing this button the machine starts operating. When depressing it again, the machine stops.
i Washing hints Do NOT overload the machine. Weigh the laundry the first few times you use the appliance. The average weights of the most common items are listed below as a guide: ■ Use a good quality detergent suitable for automatic washing machines. ■ Use the correct quantities of detergent. ■ For wool, use gentle detergent only in small quantities. ■ Bleach is very corrosive; it should be used with care and kept out of reach of children. ■ Some stains such as fruit, wine, grass, rust etc.
i Wash Care Symbols Wash care labels inside garments recommend how to launder your clothes with the best results. The care labelling code is in line with care labelling used in the rest of Europe. The symbols used make it easy to select the correct programme on your washing machine. WASHING SYMBOL WASH ACTION 95 Normal (Maximum) White Cotton or Linen without Special Finishes 60 Normal (Maximum) Cotton, Linen or Viscose without Special Finishes Colourfast at 60°C.
Which detergent to use?.... LOW SUDS For most clothes and household textiles, CONVENTIONAL DETERGENTS will give good washing results. Conventional detergents are available in either a biological, such as Ariel, or a non-biological form, such as Fairy, and are particularly suitable for whites. Biological detergents provide improved stain removal, especially at lower temperatures.
Programmes for cotton and linen Recommended load: max. 4.
Programmes for synthetics, delicates and wool Recommended load: max. 2 kg (4.5 lb); wool max. 1 kg (2.
USING YOUR MACHINE Washing 4.5 kg of white cotton at 95°C Suppose you have 4.5 kg of normally dirty laundry to wash. It is white cotton and is suitable for high temperature washing. 1. Load the laundry Open the door by pulling the catch outward. Load the items one at a time and close the door. 2. Measure out the detergent Pull out the detergent dispenser drawer from the control panel. Measure out the amount of detergent required and pour into the main wash compartment.
Washing 2 kg of synthetic fabrics at 50°C Suppose you have 2 kg of synthetic fabrics to wash. They are rather delicate fabrics and should not be washed at a high temperature. 1. Load the laundry Open the door by pulling the catch outward. Load the items one at a time and close the door. 2. Measure out the detergent Pull out the detergent dispenser drawer from the control panel. Measure out the amount of detergent required and pour into the main wash compartment. 3.
MAINTENANCE AND CLEANING Before any maintenance or cleaning is carried out you must DISCONNECT the appliance from the electricity supply. Descaling The water we normally use contains lime. It is a good idea to periodically use a water softening powder in the machine. Do this separately from any laundry washing, and according to the softening powder manufacturer's instructions. This will help to prevent the formation of lime deposits. After each wash Leave the door open for a while.
Cleaning the filter The water drain filter A clean filter is important for the correct functioning of the machine, and should therefore be cleaned after every washing programme. Open the filter door and place a container underneath to catch any spillage. If the filter is blocked and the machine is unable to drain you will need to drain the water manually from the machine at this stage. To do this, unhook the drain hose from the standpipe or sink and hold the end of the hose over a bowl on the floor.
SERVICING Before contacting your local Zanussi Service Centre, please make the following checks: The machine does not start up ■ ■ ■ ■ The ON/OFF button has not been depressed The door is not closed properly No water is entering the machine (see: the machine does not fill) The selector dial is not correctly positioned The machine does not fill ■ ■ ■ ■ ■ ■ The water tap is not turned on The water supply has been disconnected The inlet hose is kinked The water pressure is too low The water inlet filter i
PEACE OF MIND FOR TWENTY-FOUR MONTHS Zanussi standard guarantee conditions This guarantee is in addition to your statutory and other legal rights. We, Zanussi Ltd.
Z
