INSTRUCTION BOOKLET DISHWASHER ZT 415
CONTENTS Warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page 3 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page 4 Positioning, levelling, water supply connections, water outlet connection . . . . . . . . . . . . . . . . . . . . . . . .page 4 The electrical connections . . . . . . . . . . . . .
WARNINGS It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is left with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant warnings. These warnings are provided in the interest of safety.
INSTALLATION Remove all packaging before positioning the machine. To make this easier, the hose itself may be turned to the left or the right. In either case, be sure to incorporate the strainer (A) supplied with the machine into the joint. See picture. Positioning If possible, position the machine next to a water tap and a drain. The dishwasher features fill and drain hoses which can be turned either to the left or the right to suit the installation .
A replacement cover/carrier must be obtained from your local Zanussi Service Force Centre whose address is listed in the Customer Care Booklet which accompanies your instruction manual. The electrical connections WARNING: THIS APPLIANCE MUST BE EARTHED. The manufacturer declines any liability should this safety measure not be observed. This appliance complies with the following E.E.C. Directives: - 73/23 of 19.2.
USE Control panel THE CONTROLS 1. ON/OFF Pushbutton In this fully integrated appliance the controls are located on the top of the door. When selecting a programme, the door needs to be partially opened. Depress this pushbutton to switch the dishwasher on. The ON/OFF indicator light (3) illuminates indicating that the washing programme can be selected and started. Depress again this button to switch the appliance off.
- Press the programme button corresponding to the required level. The Water Softener Water contains varying amounts of lime and mineral salts depending on the area in which you live: these are deposited on the dishes leaving white marks. - 5 seconds after having last pressed any of the programme buttons, the dishwasher memorises the level selected and returns to the programme setting mode. The higher the content of these salts, the harder your water will be.
To open the dispenser lid, pull the catch (D). This will open it. Rinse Aid The use of this liquid ensures thorough rinsing, spot and streak free drying, making the water run quickly off the dishes for sparkling results. It is automatically added during the hot rinse. The dispenser, which is positioned inside the door, holds about 110 ml of rinse aid, which is sufficient for 16-40 dishwashing programmes, depending upon the dosage setting.
The two rear rows of prongs on the lower basket can be easily lowered to allow you to load pots, pans and bowls. To lower the prongs: slightly pull them upward and let them drop down (see picture); to bring them back to the standing position, just pull them up again. Loading your Machine Before placing dishes in the machine, remove any scraps of food from the plates (small bones, toothpicks, fish bones, scraps of meat and vegetables, fruit skins etc.
Adjusting the Height of the Upper Basket If washing very large plates (over 27 cm and up to 31 cm in diameter) you can load them in the lower basket after moving the upper basket to the higher position as follows: A Move the front runner stops (A) of the upper basket outward and slide the basket out. Refit the basket in the higher position and replace the stops (A) in their original position.
WASHING PROGRAMMES Recommended quantity of detergent Programme Type of load and degree of soil RINSE & HOLD in the dispenser Required pushbuttons ON OFF RINSE & HOLD — on the dispenser lid — Cycle description Cold rinse to prevent food scraps from drying up and sticking to the dishes INTENSIVE 70°c Heavily soiled crockery, pots, pans and cutlery ON OFF INTENSIVE 70°c 1 heaped dessert spoonful (15 g) 1 level dessert spoonful (10 g) Prewash at 55°C Main wash at 70°C 2 cold rinses 1 hot rin
OPERATING INSTRUCTIONS 1 Check that the filters are clean 7 Start the programme (see cleaning instructions) Open the water supply. Close the dishwasher door. An audible signal of about 1 second advises you that the programme has started. The indicator light which corresponds to the programme under way is now permanently on. 2 Switch on the appliance at the mains supply.
MAINTENANCE AND CLEANING Check that the spray arm nozzles are not obstructed. To remove the bottom spray arm, release it from its securing catches and pull it out. Cleaning the Central Filters (After each wash) Inspect the central filters (B) and (C) and remove any scraps of food with a brush, under running water. Clean the external surfaces of the machine and control panel with a soft damp cloth. If necessary use only neutral detergents.
SERVICING Certain problems are often due to lack of simple maintenance or oversights and can be solved easily without having to call out an engineer. If the indicator light of the QUICK programme is flashing If the machine will not start The dishwasher does not empty out water ■ The door has not been properly closed. ■ The plug is not properly inserted in the power socket. ■ There is no current at the socket. Check the fuse.
The dishes are not quite dry ■ The dishes have been left too long inside the machine. The door is difficult to close ■ The dishwasher is not level or is not properly built-in. If, after the above checks, the fault persists, call your local Zanussi Service Centre, whose address can be found in the accompanying Customer Care Booklet, and can also be found in your local telephone directory under «Z». Please make sure you give the model and serial number of the appliance.
BUILDING-IN Mounting of decor panel onto the door Building-in features The height of the panel depends on the height of the plinth of adjacent kitchen units (see kitchen plinth adjustment). This dishwasher is designed to be fitted under a kitchen counter or sink. In either case, it is essential that the recess dimensions indicated in the picture are followed. No further openings for venting of the dishwasher are required, but only to let the water fill and drain hoses and power supply cable pass through.
Securing under a counter Levelling Secure the dishwasher to the counter on the front part by means of two 4,2x13 screws provided (see fig. - point A). A Make sure that the dishwasher door closes properly, without rubbing on sides. Otherwise level the machine by slightly screwing or unscrewing the two front feet until perfect closure of the door is reached. Kitchen plinth adjustment To allow correct opening of the door it is sometimes necessary to cut the kitchen plinth. Refer to the cutting table below.
PEACE OF MIND FOR TWENTY FOUR MONTHS Zanussi guarantee conditions Exclusions This guarantee is in addition to your statutory and other legal rights. This guarantee does not cover: We, Zanussi Ltd.
Total Chlorine free 152995 81/0 GB Printed in Italy 0/1096