User manual

Downloaded from www.vandenborre.be
Remove the screw from
the lamp cover.
Remove the lamp cover
(refer to the illustration).
Replace the used lamp
with a new lamp of the
same power and specifi-
cally designed for house-
hold appliances (the maxi-
mum power is shown on
the lamp cover).
Install the lamp cover.
Tighten the screw to the
lamp cover.
Connect the plug to the
mains socket.
Open the door. Make sure
that the light comes on.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets.
Contact the Service Center.
Technical data
ZRT724X ZRT724W
Dimension
Height 1404 mm 1404 mm
Width 545 mm 545 mm
Depth 604 mm 604 mm
Rising Time 19 h 19 h
Voltage 230 V 230 V
Frequency 50 Hz 50 Hz
The technical information are situated in the rating plate
on the internal left side of the appliance and in the energy
label.
Installation
Caution! Read the "Safety Information" carefully for
your safety and correct operation of the appliance
before installing the appliance.
Positioning
This appliance can be installed in a dry, well ventilated in-
door (garage or cellar) also, but for optimum performance
install this appliance at a location where the ambient tem-
perature corresponds to the climate class indicated on the
rating plate of the appliance:
34