User Manual GETTING STARTED? EASY.
SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference.
• • • Clean the appliance with a moist soft cloth. Only use neutral detergents. Do not use abrasive products, abrasive cleaning pads, solvents or metal objects. Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance. If the supply cord is damaged, it must be replaced by the manufacturer, its Authorised Service Centre or similarly qualified persons in order to avoid a hazard.
• • • • Do not touch the compressor or the condenser. They are hot. Do not remove or touch items from the freezer compartment if your hands are wet or damp. Do not freeze again food that has been thawed. Obey the storage instructions on the packaging of frozen food. INTERNAL LIGHT • The type of lamp used for this appliance is not suitable for household room illumination CARE AND CLEANING WARNING! Risk of injury or damage to the appliance.
DAILY USE WARNING! Refer to Safety chapters. FREEZING FRESH FOOD The freezer compartment is suitable for freezing fresh food and storing frozen and deep-frozen food for a long time. To freeze fresh foods it is not necessary to change the medium setting. However, for a faster freezing operation, turn the temperature regulator toward higher settings to obtain the maximum coldness. Small pieces may even be cooked still frozen, directly from the freezer: in this case, cooking will take longer.
HINTS FOR ENERGY SAVING • Do not open the door frequently or leave it open longer than absolutely necessary. • If the ambient temperature is high and the Temperature Regulator is set to low temperature and the appliance is fully loaded, the compressor may run continuously, causing frost or ice on the evaporator. If this happens, set the Temperature Regulator toward warmer settings to allow automatic defrosting and so a saving in electricity consumption.
This appliance contains hydrocarbons in its cooling unit; maintenance and recharging must therefore only be carried out by authorized technicians. The accessories and parts of the appliance are not suitable for washing in a dishwasher. PERIODIC CLEANING CAUTION! Do not pull, move or damage any pipes and/or cables inside the cabinet. CAUTION! Take care of not to damage the cooling system. CAUTION! When moving the cabinet, lift it by the front edge to avoid scratching the floor.
WARNING! If the cabinet will be kept on, ask somebody to check it once in a while to prevent the food inside from spoiling in case of a power failure. TROUBLESHOOTING WARNING! Refer to Safety chapters. WHAT TO DO IF... Problem Possible cause The appliance does not operate. The appliance is switched off. Switch on the appliance. The mains plug is not connected to the mains socket correctly. Connect the mains plug to the mains socket correctly. There is no voltage in the mains socket.
Problem Possible cause Solution Water flows on the rear plate of the refrigerator. During the automatic defrosting process, frost melts on the rear plate. This is correct. Water flows inside the refrigerator. The water outlet is clogged. Clean the water outlet. Food products prevent that water flows into the water collector. Make sure that food products do not touch the rear plate. Water flows on the floor. The melting water outlet is not connected to the evaporative tray above the compressor.
CLOSING THE DOOR 1. Clean the door gaskets. 2. If necessary, adjust the door. Refer to "Installation". 3. If necessary, replace the defective door gaskets. Contact the Authorised Service Centre. INSTALLATION WARNING! Refer to Safety chapters.
10. Tighten the hinge. 2. Push back the top and lift it. 11. 12. 13. 14. Put the top in position. Push front the top. Screw both screws on the rear side. Remove and install the handle on the opposite side. 1 3. Unscrew the left foot. 4. Unscrew the screws of the door bottom hinge. Remove the hinge. Put over the pin in the direction of the arrow. 5. Unscrew and install the screw on the opposite side. 6. Install the hinge on the opposite side. 7. Screw the right foot. 8.
REVERSIBILITY OF THE FREEZER DOOR 180˚ ELECTRICAL CONNECTION CAUTION! Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. A WARNING! This appliance must be earthed. The manufacturer declines any liability should these safety measures not be observed.
2. Connect the wire coloured blue to the terminal either marked with the letter “N“ or coloured black. 3. Connect the wire coloured brown to the terminal either marked with the “L“ or coloured red. 4. Check that no cut, or stray strands of wire is present and the cord clamp (E) is secure over the outer sheath. Make sure the electricity supply voltage is the same as that indicated on the appliance rating plate. 5. Switch on the appliance. The appliance is supplied with a 13 amp fuse (B).
212000985-B-242016 WWW.ZANUSSI.
