EN User Manual Fridge Freezer ZRB34211XA
Contents Safety information Safety instructions Product description Operation Daily use 2 3 5 6 6 Hints and tips Care and cleaning Troubleshooting Installation Technical information 8 9 10 12 13 Subject to change without notice. Safety information Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages.
• • • • • • • Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer. Do not damage the refrigerant circuit. Do not use electrical appliances inside the food storage compartments of the appliance, unless they are of the type recommended by the manufacturer. Do not use water spray and steam to clean the appliance. Clean the appliance with a moist soft cloth. Only use neutral detergents.
Use Care and cleaning WARNING! WARNING! Risk of injury, burns, electrical shock or fire. • • • • • • • • • • • • 4 Do not change the specification of this appliance. Do not put electrical appliances (e.g. ice cream makers) in the appliance unless they are stated applicable by the manufacturer. Be careful not to cause damage to the refrigerant circuit. It contains isobutane (R600a), a natural gas with a high level of environmental compatibility. This gas is flammable.
Product description Product overview 1 2 3 4 8 1 2 3 4 5 Vegetable drawers Cabinet shelves Bottle rack Control panel Door shelves www.zanussi.
Operation Control panel 1 Temperature indicators LED 2 QuickFreeze button 3 Temperature regulator 1 3 2 Switching on Insert the plug into the wall socket. QuickFreeze function You can activate the QuickFreeze function by pressing the QuickFreeze button. The LED corresponding to the symbol QuickFreeze indicator lights up. You can deactivate the QuickFreeze function by pressing the QuickFreeze button again. The QuickFreeze indicator will light off. This function stops automatically after 52 hours.
Initial power on CAUTION! Before inserting the power plug in to the outlet and switching on the cabinet for the first time, leave the appliance standing upright for at least 4 hours. This will assure a sufficient amount of time for the oil to return to the compressor. Otherwise the compressor or electronic components may sustain damage.
Bottle rack Place bottles (with the opening facing front) in the pre-positioned shelf. time of its removal from the freezer, pull the basket towards yourself and, upon reaching the end point, remove the basket by tilting its front upwards. At the time of putting it back, slightly lift the front of the basket to insert it into the freezer. Once you are over the end points, push the baskets back in their position.
• • • • • • • • the maximum quantity of food which can be frozen in 24 hrs. is shown on the rating plate; the freezing process takes 24 hours.
Periods of non-operation WARNING! When the appliance is not in use for long periods, take the following precautions: 1. Disconnect the appliance from electricity supply. 2. Remove all food. 3. Clean the appliance and all accessories. 4. Leave the door/doors open to prevent unpleasant smells. If the cabinet will be kept on, ask somebody to check it once in a while to prevent the food inside from spoiling in case of a power failure. Troubleshooting WARNING! Refer to Safety chapters. What to do if...
Problem Possible cause Solution There is too much frost and ice. The door is not closed correctly or the gasket is deformed/ dirty. Refer to "Closing the door". The compressor does not start immediately after pressing the QuickFreeze, or after changing the temperature. This is normal, no error has occurred. The compressor starts after a period of time. Water flows on the rear plate of the refrigerator. During the automatic defrosting process, frost melts on the rear plate. This is correct.
If the advice does not lead to the desired result, contact the nearest Authorised Service Centre. Closing the door 1. Clean the door gaskets. 2. If necessary, adjust the door. Refer to "Installation". 3. If necessary, replace the defective door gaskets. Contact the Authorised Service Centre. Replacing the lamp The appliance is equipped with a longlife LED interior light. Only service is allowed to replace the lighting device. Contact your Authorised Service Centre.
2. 3. 4. 5. The appliance is supplied with a 13 amp fuse (B). In the event of having to change the fuse in the plug supplied, a 13 amp ASTA approved (BS 1362) fuse must be used. letter “E“ or by the earth symbol or coloured green and yellow. Connect the wire coloured blue to the terminal either marked with the letter “N“ or coloured black. Connect the wire coloured brown to the terminal either marked with the “L“ or coloured red.
www.zanussi.
www.zanussi.
280154172-A-292014 www.zanussi.
