Replacing the light bulb Disconnect the appliance from the mains supply. Remove the screw to release the lamp cover, the lamp bulb is located in the lamp holder, unscrew the lamp in an anti-clockwise direction until the lamp comes out of the lamp holder. Screw a new lamp bulb (15 Watt & E14 Base) into the lamp holder in a clockwise direction until tight. Replace the lamp cover and screw back into place. Reconnect the appliance to The mains supply.
Defrosting The freezer compartment, however, will become progressively covered with frost. This should be removed with the special plastic scraper provided, whenever the thickness of the frost exceeds 4mm. During this operation it is not necessary to switch off the power supply or to remove the foodstuffs.
on the inner liner, complete defrosting should be carried out as follows: 1. Pull out the plug from the wall socket ; 2. Remove any stored food, wrap it in several layers and put it in a cool place; 3.
Fix the stopper in the middle of the condenser, rotate the stopper 90 degrees and fixed the position. 4. Remove the stopper which is under the bottom door trim with a screwdriver, then install it to the left symmetrical. 1 2 1.Door Stop 2.Door Stop Screw 5. Rotate the bolt which is used to fix the middle hinge with screwdriver, remove the middle hinge, then carefully remove fridge door. 1. Tilt the refrigerator back to set at an angle. 2.