FRIGORIFEROCONGELATORE FRIDGE-FREEZER KÜHLGEFRIERSCHRANK REFRIGERATEURCONGELATEUR ZR 220/2TN LIBRETTO ISTRUZIONI 2222 255-05/2 INSTRUCTION BOOKLET GEBRAUCHSANWEISUNG MODE D’EMPLOI
WARNINGS GB It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings. These warnings are provided in the interest of safety.
CONTENTS Installation 15 ª Positionin 15 ª Cleaning the interior 15 ª Building-in instruction 16 ª Electrical connection 19 Technical specification 19 Use 20 ª Operation 20 ª Temperature regulation 20 ª Fresh food refrigeration 20 ª Movable shelves 21 ª Positioning the door shelves 21 ª Freezing fresh food 22 ª Storage of frozen food 22 ª Thawing 22 ª Ice-cube production 22 ª Defrosting 23 Maintenance 24 ª Periodic cleaning 24 ª Periods of non-operation 24 ª Interior
INSTALLATION GB IIf this appliance featuring magnetic door seals is to replace an older appliance having a spring lock (latch) on the door or lid, be sure to make that spring lock unusable before you discard the old appliance. This will prevent it from becoming a death-trap for a child. Positioning The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc.
Building-in instructions A C 1 2 3 D B D501 Fig. 1 Door reversibility Right opening Remove the pins (A) and (B). 16 Left opening Remove pins (A) and (C) from both sides and the door. Remove the middle hinge and refit it on the opposite side. Refit the door and pin (A) on the left side. Remove pin (D) from the right side.
Housing dimensions Height Depth Width 1225 mm 550 mm 560 mm Fig. 2 50-min. cm 2 200 For appropriate venting, follow indications in Fig. 2. min. cm2 200 D033 Push appliance into the housing until stop strip (A) touches the kitchen unit. Fig. 3 A D015 If after having carried out the previously described operation there is still some space left between the appliance and the kitchen unit, fit the trimming provided together with the appliance on the stop strip (A). Fig. 4 A D265 Fig.
Press in the joint covers between the appliance and the kitchen unit. Fig. 6 D030 Apply covers (B) on joint cover lugs and into hinge holes. Fig. 7 B D013 Position the runners (H) at the top and bottom of the inside of the kitchen unit as shown in Fig. 8 and mark the position of the external holes. After preparing the holes, screw the runners to the kitchen unit door using 3.5x16 mm screws. Fig. 8 H 20m m D094 Fig. 9 Open both the appliance door and that of the kitchen unit to approx. 90°.
Remove the little plates and make the holes with a diam. of 2 mm. Replace the little plates over the runners and screw in the screws provided (3.5x16 mm). For the alignment of the kitchen unit door, if necessary, use the clearance size of the slotted holes. At the end of the procedure, check that the doors of the appliance and the kitchen unit open properly. Fig.
USE Operation Fresh food refrigeration Insert the plug into the wall socket. Open the refrigerator door and turn the thermostat knob, clockwise, beyond the «O» (STOP) position. The appliance will start to operate. To obtain the best performance: Temperature regulation GB do not store warm food or evaporating liquids in the refrigerator; do cover or wrap the food, particularly if it has a strong flavour. Position food so that air can circulate freely round it.
Movable shelves Fig. 11 The walls of the refrigerator are equipped with a series of runners so that the shelves can be positioned as desired. D040 Fig. 12 Positioning the door shelves To permit storage of food packages of various sizes, the door shelves can be adjusted in height. To make these adjustments proceed as follows: Gradually pull the shelf in the direction of the arrows until it comes free, then reposition as required (Fig. 12). D009 Fig.
Freezing fresh food Storage of frozen food The 4-star compartment ( ) is suitable for long term storage of commercially frozen food and for freezing fresh food. To freeze fresh foods it is not necessary to move the thermostat knob from the normal setting. However, for a faster freezing operation, turn the thermostat knob to the coldest setting; but remember that, in this condition, the refrigerator compartment temperature might drop below 0°C. If this occurs reset thermostat knob to a warmer setting.
Defrosting Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor compressor stops, during normal use. The defrost water drains out through a trough (Fig. 14) into a special container on the back of the appliance where it evaporates. Clean periodically the water discharge hole in the centre of the drip collector. Use the special cleaner provided, which you will find already inserted into the discharge hole (Fig. 14).
MAINTENANCE GB Unplug the appliance before carrying out any maintenance operation. Periodic cleaning Clean the inside with warm water and bicarbonate of soda. Rinse and dry thoroughly. Periods of non-operation When the appliance is not in use for long periods, take the following precautions: remove the plug from the wall socket; remove all food; defrost and clean the interior and all accessories; leave the door ajar to allow air to circulate to prevent unpleasant smells. Fig.
