REFRIGERADORCONGELADOR FRIDGE-FREEZER ZPC 428 D ZPC 428 DM LIBRO DE INSTRUCCIONES INSTRUCTION BOOKLET 2222 168-05 This document was created with FrameMaker 4.0.
CONTENTS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Page 11 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Page 12 Location . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Page 12 Electrical connection . . . . . . . . . . . . . . . . . . . . . . . . . . . Page 12 Cleaning the appliance’s interior . . . . . . . . . . . . . . . . . . . . . . . Page 12 Door reversibility . . . . . . . . . . . . . . . . . . . . . . . . . . . .
WARNINGS It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings. These warnings are provided in the interest of safety.
INSTALLATION Location Door reversibility The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. Best performance is obtained with ambient temperature between +18°C and +43°C (class T); +18°C and +38°C (class ST); +16°C and +32°C (class N); +10°C and +32°C (class SN). The class of your appliance is shown on its rating plate. Reversing consists of changing the opening direction of the doors, which may be to the right or to the left.
Left hand door opening Building-in Remove the screws and the upper pivots. Lift off the upper door. Remove the middle hinge (A-Fig. 2) and fix it to the other side, after having removed the little caps which cover the holes and which must be refitted on the opposite side. Replace the upper door and fix the screw and the upper left pivot into place. Straighten the safety washer (4) of the lower right hinge (Fig. 2a). Remove the screw and the pivot (6-Fig. 2a).
USE Starting-up and temperature regulation Insert the plug into the wall socket. Open the refrigerator door and turn the thermostat knob, to be found on the top right hand side of the inner liner, clockwise beyond the «O» position, to start the appliance. Temperature adjustment is obtained by turning the thermostat knob to the required setting. A medium setting is generally the most suitable. However, the thermostat knob setting should be adjusted depending on the temperature required inside the appliance.
Food refrigeration To achieve the best results with the refrigerator compartment, you should follow one or two very simple rules: Do not put warm foods or evaporating liquids in the refrigerator. Cover or wrap foods (particularly if they have a strong smell). Do not cover the shelves (grids) with paper or plastic since this blocks circulation of air in the compartment.
To carry out complete defrosting of the ( freezer compartment proceed as follows: ) Unplug the appliance from the power supply or set the thermostat to position «O». Remove the frozen foods and wrap them in several sheets of newspaper, then keep them in a cool place. Leave the door open. Place a basin on the refrigerator compartment shelf underneath the drainage hole and pull the plug downward (Fig. 10); to reinsert it, just push it up.
MAINTENANCE Prior to undertaking any maintenance operation, be sure to unplug the appliance from the wall socket as a safety precaution. Clean the interior periodically with lukewarm water and some sodium bicarbonate; the cabinet exterior with a silicone wax spray; the condenser and the motor compressor with a brush or a vacuum cleaner.