Operation Manual

Hold the door trim (B) on the top edge of the door

at the two sides and push inwards to release the

clip seal. Pull the door trim to the front to remove it.

Hold the door glass panel by its top edge and

carefully pull it out. Make sure the glass slides out

of the supports completely.

Clean the glass panel with water and soap. Dry the

glass panel carefully.

When the cleaning is completed, install the glass

panel and the oven door. Do the above steps in the

opposite sequence.

The screen-printing zone must face the inner side

of the door. Make sure that after the installation the

surface of the glass panel frame on the screen-

printing zones is not rough when you touch it.

Make sure that you install the internal glass panel in

the seats correctly.

REPLACING THE LAMP

Put a cloth on the bottom of the interior of the

appliance. It prevents damage to the lamp glass

cover and the cavity.

WARNING! Danger of electrocution!

Disconnect the fuse before you

replace the lamp.

The lamp and the lamp glass cover

can be hot.

CAUTION! Always hold the halogen

lamp with a cloth to prevent grease

residue from burning on the lamp.

1. Deactivate the appliance.

2. Remove the fuses from the fuse box or

deactivate the circuit breaker.

The back lamp

1. Turn the lamp glass cover counterclockwise to

remove it.

2. Clean the glass cover.

3. Replace the lamp with a suitable 300 °C heat-

resistant lamp.

4. Install the glass cover.

TROUBLESHOOTING

WARNING! Refer to Safety chapters.

WHAT TO DO IF...

Problem Possible cause Remedy

The oven does not heat up. The oven is deactivated. Activate the oven.