EN User manual Washer Dryer ZKN 7147 J
Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 Safety instructions _ _ _ _ _ _ _ _ _ _ _ _ _ _ 3 Product description _ _ _ _ _ _ _ _ _ _ _ _ _ 5 Special accessories for installation _ _ _ _ _ 6 Control panel _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 6 Washing Programmes _ _ _ _ _ _ _ _ _ _ _ _ 9 Automatic Drying programmes _ _ _ _ _ _ _ 11 Helpful hints and tips _ _ _ _ _ _ _ _ _ _ _ _ 12 First use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 14 Personalisation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 14 Daily Use _ _ _
• Do not change the specification of this appliance. • Obey the maximum load volume of 8 kg (refer to the “Programme chart” chapter). • If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. • The operating water pressure (minimum and maximum) must be between 0,5 bar (0,05 MPa) and 8 bar (0,8 MPa) • The ventilation openings in the base (if applicable) must not be obstructed by a carpet.
change the fuse in the mains plug, use a 13 amp ASTA (BS 1362) fuse. • This appliance complies with the E.E.C. Directives. Water connection • Make sure not to cause damage to the water hoses. • The appliance is to be connected to the water mains using the new supplied hose-sets. Old hose sets must not be reused. • Before you connect the appliance to new pipes or pipes not used for a long time, let the water flow until it is clean. • The first time you use the appliance, make sure that there is no leakage.
Product description 1 Detergent dispenser drawer 2 Control panel 1 2 3 Door opening handle 4 Rating plate 5 Drain pump 6 Adjustable feet 3 4 5 6 Detergent dispenser drawer Compartment for detergent used for prewash and soak phase or for stain remover used during the stain action phase (if available). The prewash and soak detergent is added at the beginning of the wash programme. The stain remover is added during the stain action phase. Compartment for powder or liquid detergent used for main wash.
To activate this device, rotate the button (without pressing it) inside the door clockwise until the groove is horizontal. If necessary use a coin. To disable this device and restore the possibility of closing the door, rotate the button anti-clockwise until the groove is vertical. Special accessories for installation Rubber feet kit (4055126249) Available from your authorized dealer. The rubber feet are particularly recommended on floating, slippery and wooden floors.
1 Programme selector dial 2 Spin button 6 Extra rinse button 7 Start/Pause button 3 Automatic drying button 4 Drying time button 8 Delay start button 9 Door pilot light 5 Super quick button 10 Display Table of symbols = Rinse hold = Child Safety Lock 1-8 Programme selector dial, spin speed button, drying level and time, and available options press this button the drying time increases by 5 mins. Programme Selector Dial It allows you to switch the appliance on/off and/ or to select a programme.
• light blinking: the door is opening in a few minutes. 10 Display 10.1 10.2 The display shows the following information: 10.1 Child safety lock This device permits you to leave the appliance unattended during it's functioning. 10.2 • Duration of the selected programme After selecting a programme, the duration is displayed in hours and minutes (for example ). The duration is calculated automatically on the basis of the maximum recommended load for each type of fabric.
Washing Programmes Programme - Maximum and Minimum Temperature - Cycle Description - Maximum Spin Speed - Maximum Fabrics Load - Type of Laundry Options Cottons 90° - 60° Main wash - Rinses Maximum spin speed at 1400 rpm Max. load 8 kg - Reduced load 4 kg1) White cotton(heavily and normally soiled items). SPIN RINSE HOLD SUPER QUICK EXTRA RINSE Cottons Eco 60° - 40° Main wash - Rinses Maximum spin speed at 1400 rpm Max. load 8 kg White or fast colour cotton (normally soiled items).
Programme - Maximum and Minimum Temperature - Cycle Description - Maximum Spin Speed - Maximum Fabrics Load - Type of Laundry Delicates 40° - 30° Main wash - Rinses Maximum spin speed at 700 rpm Max. load kg 4 - Reduced load kg 21) Delicate fabrics: acrylics, viscose, polyester. Options Detergent Compartment RINSE HOLD SUPER QUICK EXTRA RINSE Wool / Handwash 40° - Cold Main wash - Rinses Maximum spin speed at 900 rpm Max.
Programme - Maximum and Minimum Temperature - Cycle Description - Maximum Spin Speed - Maximum Fabrics Load - Type of Laundry Detergent Compartment Options Drain Draining of water Max. load 8 kg For emptying out the water of the last rinse in programmes which stop with water in the tub. Spin Drain and long spin Maximum spin speed at 1400 rpm Max. load 8 kg Separate spin for hand washed garments and after programmes which stop with water in the tub.
Degree of Drying Iron dry Suitable for ironing Type of Fabric Drying Load Spin Speed (rpm) Suggested drying time (minutes) Cotton and linen (sheets, tablecloths, shirts, etc.) 6 kg 4 kg 2 kg 1400 150 - 170 90 - 100 50 - 60 Hints for test institute Test performance, in accordance with EN 50229, must be carried out with the a first drying load of 5 kg (load composition : pillowcase and towels) by selecting the TIMED DRYING programme for Cotton and setting 120 minutes.
Although biodegradable, detergents contain substances which, in large quantities, can upset the delicate balance of nature. The choice of detergent will depend on the type of fabric (delicates, woollens, cottons, etc.), the colour, washing temperature and degree of soiling.
dispenser drawer before starting the wash programme. If using liquid detergents, a programme without prewash must be selected. Your appliance incorporates a re-circulation system which allows an optimal use of the concentrated detergent. Follow the product manufacturer’s recommendations on quantities to use and do not exceed the «MAX» mark in the detergent dispenser drawer. • speed of the final spin • dryness degree required (iron dry, store dry) • type of laundry • weight of the load size .
To enable or disable this option press simultaneously for about 6 seconds buttons 2 and 3 until on the display, the icon appears. appears or dis- Daily Use Load the laundry Open the door by carefully pulling the door handle outwards. Place the laundry in the drum, one item at a time, shaking them out as much as possible. Close the door. Make sure that no laundry stays between the seal and the door. There is a risk of water leakage or damage to the laundry.
For the compatibility among the washing programmes and the options see chapter «Washing programmes». Select an additional rinse This appliance is designed for saving water. However, for people with a very delicate skin (allergic to detergents) it may be necessary to rinse the laundry using an extra quantity of water (Extra Rinse). To activate this option press simultaneously the buttons 4 and 6 for some seconds. The pilot light 9 illuminates. This function stays permanently on.
Opening the door after the programme has started First set the machine to pause by pressing the button 7. If the pilot light 9 blinks and after a few minutes goes off, the door can be opened. If the pilot light 9 remains lit, this means that the machine is already heating or that the water level is too high. In any case, do not try to force the door open! If you cannot open the door but you need to open it, you have to switch the machine off by .
6. 7. button the drying time increases by 5 minutes. 8. The programme time will automatically increase by some minutes. 9. Press button 7 to start the programme. The time remaining is updated every minute. At the end of the programme, the buzzer sounds. The blinking appears on the display. The door pilot light 9 is on. During the last minutes of the drying cycle the appliance performs an anti-crease phase. Through this time the door is locked. The display shows the blinking .
2. 3. Switch the machine on by turning the selector dial to the set washing programme/ fabric. Select the required options by pressing the relevant buttons. If possible, do not select a spin speed lower than that proposed by the appliance to avoid too long a drying time therefore saving energy. In any case the reduction of the spin speed is only possible after selecting drying. The lowest values you can select are 900 r.p.m. for cottons and synthetics and 700 r.p.m. for delicate fabrics.
must be cold before you clean the drain pump. Proceed as follows: Remove the drawer by pressing the catch downwards and by pulling it out. Flush it out under a tap, to remove any traces of accumulated powder. To aid cleaning, the top part of the additive compartment should be removed. Open the pump door. Put a container below the recess of the drain pump to collect the water that flows out.
Pull back the drainage duct. Unscrew the filter and remove it. Caution! When the appliance is in use and depending on the programme selected there can be hot water in the pump. Never remove the pump cover during a wash cycle, always wait until the appliance has finished the cycle, and is empty. When refitting the pump cover, ensure it is securely retightened so as to stop leaks and young children being able to remove it. Cleaning the water inlet filters Remove fluff and objects from the pump.
Make sure that the temperature is more than 0 °C before you use the appliance again. The manufacturer is not responsible for damages caused by low temperatures. 35° 45° • Screw the hose back to the machine and make sure the connection is tight. • Turn on the water tap. Frost precautions If the machine is installed in a place where the temperature could drop below 0°C, remove the remaining water from the inlet hose and the drain pump. 1. disconnect the mains plug from the mains socket. 2.
Problem Possible cause/Solution The washing machine does not start: The door has not been closed. • Close the door firmly. The plug is not properly inserted in the power socket. • Insert the plug into the power socket. There is no power at the socket. • Please check your domestic electrical installation. The main fuse has blown. • Replace the fuse. The selector dial is not correctly positioned and/or the button 7 has not been pressed. • Please turn the selector dial and press the button 7 again.
Problem Possible cause/Solution There is water on the floor: Too much detergent or unsuitable detergent (creates too much foam) has been used. • Reduce the detergent quantity or use another one. Check whether there are any leaks from one of the inlet hose fittings. It is not always easy to see this as the water runs down the hose; check to see if it is damp. • Check the water inlet hose connection. The drain or inlet hose is damaged. • Replace it with a new one.
Problem Possible cause/Solution The machine makes an unusual noise: The machine is fitted with a type of motor which makes an unusual noise compared with other traditional motors. This new motor ensures a softer start and more even distribution of the laundry in the drum when spinning, as well as increased stability of the machine. No water is visible in the drum: Machines based on modern technology operate very economically using very little water without affecting performance.
Maximum Load Cotton 8 kg Spin Speed Maximum 1400 rpm 1) Connect the water inlet hose to a water tap with a 3/4'' thread. Consumption values Programme Energy consumption (KWh) Water consumption (litres) Programme duration (Minutes) Cottons 60° 1.6 65 Cotton Energy Saving Programme 60° 1) 1.05 57 Cottons 40° 0.95 65 For the duration of the programmes, please refer to the display on the control panel. Synthetics 40° 0.60 55 Delicates 40° 0.70 69 Wool/ Handwash 30° 0.
If necessary, check the setting with a spirit level. Unscrew the three bolts. Slide out the relevant plastic spacers. Water inlet The inlet hose is supplied with the appliance and it can been found inside the machine drum. Warning! This appliance must be connected to a cold water supply. Open the porthole, remove the polystyrene block fitted on the door seal and pull out all items from the drum.
2. Connect the other end of the inlet hose to the back of the appliance. The inlet hose can ONLY be turned as showed in the picture. Do not place the inlet hose downwards. Angle the hose to the left or right depending on the position of your water tap. Set the hose correctly by loosening the ring nut. After positioning the inlet hose, be sure to tighten the ring nut again to prevent leaks. Caution! The inlet hose must not be lengthened.
In the interest of the environment The appliance should be connected to the FOUL drainage system, the water will then be taken to a sewage works for treatment before being discharged safely into a river. It is essential that these appliances are not connected to the surface water drainage system as this water is discharged directly into a river or stream and may cause pollution. If you require any further advice please contact your local water authority.
In the event of having to change the fuse in the plug supplied, a 13 amp ASTA approved (BS1363/A) fuse must be used. Should the plug need to be replaced for any reason, proceed as described below. The wires in the mains lead are coloured in accordance with the following code: 1 Green & Yellow 2 Brown 1 3 Cord clamp 4 Blue 2 4 3 The wire coloured green and yellow must be connected to the terminal marked with the letter or coloured «E» or by the earth symbol green and yellow.
• The machine works more economically if it is fully loaded. • With adequate pre-treatment, stains and limited soiling can be removed; the laundry can then be washed at a lower temperature. www.zanussi.com • Measure out detergent according to the water hardness, the degree of soiling and the quantity of laundry being washed.
132935113-A-502012 www.zanussi.
