User manual

3. Select the drying programme for Cottons
or Synthetic in the Drying sector of the
programme selector dial.
4. If you wish to select an automatic drying
(for cottons and synthetic items only),
press the button 3 until the pilot light cor-
responding to the required dryness degree
illuminates.
5. If you wish to select a timed drying, press
the button 4 until the time you want ap-
pears on the display (see the «Drying Pro-
gramme» table). Every time you press this
button the drying time increases by 5 mi-
nutes.
The programme time will automatically in-
crease by some minutes.
6. Press button 7 to start the programme. The
time remaining is updated every minute.
7. At the end of the programme, the buzzer
sounds. The blinking
appears on the dis-
play. The door pilot light 9 is on.
During the last minutes of the drying cycle
the appliance performs an anti-crease
phase. Through this time the door is
locked. The display shows the blinking
.
At the end of the anti-crease phase the
door pilot light 9 is off.
If you wish to open the door before or dur-
ing the anti-crease phase or to interrupt it,
press any button or turn the programme selec-
tor dial to any programme position (except
).
8.
Turn the selector dial to the
position to
switch the machine off.
9. Remove the laundry from the drum.
The different type of cottons (towelling,
sheets, shirts, and so on) or any laundry
items rolling up during the spinning phase may
result in partial dryness. In the exceptional case
that at the end of the cycle the laundry remains
slightly wet, we suggest that you unfold the rol-
led up items, redistribute them evenly in the
drum and select an additional drying cycle of
20-30 minutes.
If you set only 10 minutes of drying phase
with the drying time button (4), the appli-
ance performs only a cooling phase.
Use - Washing & Drying
NON-STOP programme - Washing and
Automatic Drying
The maximum load size is 3 kg for cotton and 2
kg for synthetic.
Caution! Do not use a dosing device/
ball when carrying out a washing and
drying programme.
1. Load the laundry.
2. Add detergent and fabric softener.
3. Switch the machine on by turning the se-
lector dial to the set washing programme/
fabric.
4. Select the required options by pressing the
relevant buttons.
If possible, do not select a spin
speed lower than that proposed by
the appliance to avoid too long a drying
time therefore saving energy.
In any case the reduction of the spin speed
is only possible after selecting drying.
For cottons and synthetic the lowest value
you can select is 900 r.p.m.
5. Set the dryness degree by pressing button
3. The display shows the whole duration of
the washing and the set drying cycle.
6. Start the programme by pressing button 7.
The time remaining is updated every minute
on the display.
7. At the end of the programme turn the se-
lector dial to the
position to switch the
machine off. Remove the laundry.
17
www.zanussi.com