EN User manual Washer Dryer ZKG 7169
Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 Safety instructions _ _ _ _ _ _ _ _ _ _ _ _ _ _ 3 Product description _ _ _ _ _ _ _ _ _ _ _ _ _ 5 Control panel _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 6 Washing Programmes _ _ _ _ _ _ _ _ _ _ _ _ 8 Drying Programme _ _ _ _ _ _ _ _ _ _ _ _ _ 10 Helpful hints and tips _ _ _ _ _ _ _ _ _ _ _ _ 11 Drying Hints _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 12 First use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 13 Personalisation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 13 Daily Use _ _
• Do not change the specification of this appliance. • Obey the maximum load volume of 6 kg (refer to the “Programme chart” chapter). Safety instructions Installation • Remove all the packaging and the transit bolts. • Keep the transit bolts. When you move the appliance again you must block the drum. • Do not install or use a damaged appliance. • Do not install or use the appliance where the temperature is less than 0 °C or where it is exposed to the weather.
• • • • • • • • • • • 4 If you stop the appliance before the end of the drying cycle, immediately remove and spread out all items, so that the heat can dissipate. If you use detergent, fabric softener or similar products, obey the instructions on the packaging. Wipe away lint that has accumulated around the appliance. Do not dry the damaged items which contain padding or fillings . Do not dry items such as foam rubber (latex foam), shower caps, waterproof textiles and rubber backed articles.
Product description 1 Detergent dispenser drawer 2 Control panel 1 2 3 Door opening handle 4 Rating plate 5 Drain pump 6 Adjustable feet 3 4 5 6 Detergent dispenser drawer Compartment for detergent used for prewash and soak phase or for stain remover used during the stain action phase (if available). The prewash and soak detergent is added at the beginning of the wash programme. The stain remover is added during the stain action phase. Compartment for powder or liquid detergent used for main wash.
Control panel On the following page there is a picture of the control panel. It shows the programme selector dial as well as the buttons, pilot lights and the display. These are presented by relevant numbers on the following pages.
from 10 minutes to 250 minutes (4.10). For Synthetics you can select a drying time from 10 minutes to 130 minutes (2.10). Every time you press this button the drying time increases by 5 mins. Delay Start The programme can be delayed from 30 min 60 min - 90 min, 2 hours and then by 1 hour up to a maximum of 20 hours by means of this button. Available options: Door light The pilot light 9 illuminates when the programme starts and indicates if the door can be opened: • light on: the door cannot be opened.
• Delayed start The Selected delay set by pressing the relevant button appears on the display for a few seconds, then the duration of the selected programme is displayed again. The delay time value decreases by one unit every hour and then, when 1 hour remains, every minute. • Alarm codes In the event of operating problems, some alarm codes can be displayed, for example (see paragraph «What to do if...»).
Programme - Maximum and Minimum Temperature - Cycle Description - Maximum Spin Speed - Maximum Fabrics Load - Type of Laundry Options Cottons + Prewash 60° - 40° Prewash - Main wash - Rinses Maximum spin speed at 1600 rpm Max. load 6 kg - Reduced load 3 kg1) White or colour cotton (heavily or normally soiled items) SPIN RINSE HOLD SUPER QUICK EXTRA RINSE Synthetics 60° - 40° - 30° - Cold Main wash - Rinses Maximum spin speed at 900 rpm Max.
Programme - Maximum and Minimum Temperature - Cycle Description - Maximum Spin Speed - Maximum Fabrics Load - Type of Laundry Rinses Maximum spin speed at 1600 rpm Max. load 6 kg With this programme it is possible to rinse and spin cotton garments which have been washed by hand. The machine performs 3 rinses, followed by a final long spin. Options Detergent Compartment SPIN RINSE HOLD EXTRA RINSE Important! The spin speed will automatically assume the setting for cotton items.
Timed programmes Degree of Drying Type of Fabric Drying Load Spin Speed Suggested drying time in Minutes Suitable for items to put away without ironing1) Cotton and linen (bathrobes, bath towels, etc) 4 kg 3 kg 1.5 kg 1600 130 - 150 75 - 85 35 - 45 Suitable for items to put away without ironing Synthetics and mixed fabrics 2 kg 1 kg 900 70 - 80 35 - 45 Suitable for ironing Cotton and linen (sheets, tablecloths, shirts, etc.) 4 kg 3 kg 1.
Tar stains: first treat with stain remover, methylated spirits or benzine, then rub with detergent paste. Detergents and additives Good washing results also depend on the choice of detergent and use of the correct quantities to avoid waste and protect the environment. Although biodegradable, detergents contain substances which, in large quantities, can upset the delicate balance of nature. The choice of detergent will depend on the type of fabric (delicates, woollens, cottons, etc.
• Also, fabrics containing residue of setting lotions or hair sprays, nail solvents or similar solutions must not be machine dried in order to avoid the formation of harmful vapours. The detergent and any additives must be placed in the appropriate compartments of the dispenser drawer before starting the wash programme. If using liquid detergents, a programme without prewash must be selected. Your appliance incorporates a re-circulation system which allows an optimal use of the concentrated detergent.
2. After pressing button 7: it will be impossible to change any other programme or option. To enable or disable this option press simultaneously for about 6 seconds buttons 2 and 3 until on the display, the icon appears. appears or dis- Daily Use Load the laundry Open the door by carefully pulling the door handle outwards. Place the laundry in the drum, one item at a time, shaking them out as much as possible. Close the door. Make sure that no laundry stays between the seal and the door.
different speed. The relevant pilot light illuminates. Select the available options by pressing the buttons 5 and 6 Depending on the programme, different options can be combined. These must be selected after choosing the desired programme and before starting the programme. When these buttons are pressed, the corresponding pilot lights illuminate. When they are pressed again, the pilot lights go out.
tion. Start the new programme by pressing button 7 again. The washing water in the tub will be not emptied out. Interrupting a programme Press the button 7 to interrupt a programme which is running, the corresponding pilot light starts blinking. Press the button again to restart the programme. Cancelling a programme to cancel a proTurn the selector dial to gramme which is running. Now you can select a new programme.
3. 4. 5. Select the drying programme for Cottons or Synthetic in the Drying sector of the programme selector dial. If you wish to select an automatic drying (for cottons and synthetic items only), press the button 3 until the pilot light corresponding to the required dryness degree illuminates. If you wish to select a timed drying, press the button 4 until the time you want appears on the display (see the «Drying Programme» table). Every time you press this button the drying time increases by 5 minutes.
NON-STOP programme - Washing and Timed Drying The recommended load size is 3 kg for cotton and 2 kg for synthetic. It is also possible to dry up to 4 kg of cotton items (see the «Drying Programme » table). Caution! Do not use a dosing device/ ball when carrying out a washing and drying programme. 1. 2. 3. Load the laundry and add detergent and fabric softener. Switch the machine on by turning the selector dial to the set washing programme/ fabric.
must be cold before you clean the drain pump. Proceed as follows: Remove the drawer by pressing the catch downwards and by pulling it out. Flush it out under a tap, to remove any traces of accumulated powder. To aid cleaning, the top part of the additive compartment should be removed. Open the pump door. Put a container below the recess of the drain pump to collect the water that flows out.
Pull back the drainage duct. Unscrew the filter and remove it. Caution! When the appliance is in use and depending on the programme selected there can be hot water in the pump. Never remove the pump cover during a wash cycle, always wait until the appliance has finished the cycle, and is empty. When refitting the pump cover, ensure it is securely retightened so as to stop leaks and young children being able to remove it. Cleaning the water inlet filters Remove fluff and objects from the pump.
Make sure that the temperature is more than 0 °C before you use the appliance again. The manufacturer is not responsible for damages caused by low temperatures. 35° 45° • Screw the hose back to the machine and make sure the connection is tight. • Turn on the water tap. Frost precautions If the machine is installed in a place where the temperature could drop below 0°C, remove the remaining water from the inlet hose and the drain pump. 1. disconnect the mains plug from the mains socket. 2.
Problem Possible cause/Solution The washing machine does not start: The door has not been closed. • Close the door firmly. The plug is not properly inserted in the power socket. • Insert the plug into the power socket. There is no power at the socket. • Please check your domestic electrical installation. The main fuse has blown. • Replace the fuse. The selector dial is not correctly positioned and/or the button 7 has not been pressed. • Please turn the selector dial and press the button 7 again.
Problem Possible cause/Solution There is water on the floor: Too much detergent or unsuitable detergent (creates too much foam) has been used. • Reduce the detergent quantity or use another one. Check whether there are any leaks from one of the inlet hose fittings. It is not always easy to see this as the water runs down the hose; check to see if it is damp. • Check the water inlet hose connection. The drain or inlet hose is damaged. • Replace it with a new one.
Problem Possible cause/Solution The machine makes an unusual noise: The machine is fitted with a type of motor which makes an unusual noise compared with other traditional motors. This new motor ensures a softer start and more even distribution of the laundry in the drum when spinning, as well as increased stability of the machine. No water is visible in the drum: Machines based on modern technology operate very economically using very little water without affecting performance.
Electrical connection Voltage - Overall power - Fuse Information on the electrical connection is given on the rating plate, on the inner edge of the appliance door.
After removing all the packaging, carefully lay machine on it's back to remove the polystyrene base from the bottom. Unscrew the three bolts. Open the porthole, remove the polystyrene block fitted on the door seal and pull out all items from the drum. Remove the power supply cable and the hose from the hose holders on the rear of the appliance. Slide out the relevant plastic spacers.
Caution! Before connecting up the appliance to new pipework or to pipework that has not been used for some time, run off a reasonable amount of water to flush out any debris that may have collected Caution! Do not use the hose from your previous appliance to connect to water supply. The inlet hose is delivered with the machine. • Connect the appropriate end of the hose to a tap with a 3/4” thread. Always use the hose supplied with the appliance. The appliance must be connected to a cold water supply.
The drain hose may be extended to a maximum of 4 metres. An additional drain hose and joining piece is available from your local Service Force Centre. The joining piece must have an internal diameter of 18 mm. Min. 60 cm (23.6”) In the interest of the environment The appliance should be connected to the FOUL drainage system, the water will then be taken to a sewage works for treatment before being discharged safely into a river.
In the event of having to change the fuse in the plug supplied, a 13 amp ASTA approved (BS1363/A) fuse must be used. Warning! A cut off plug inserted into a 13 amp socket is a serious safety (shock) hazard. Ensure that the cut off plug is disposed of safely. Should the appliance power supply cable need to be replaced, this MUST be carried out by our Service Force Centre. The appliance should not be connected to the electrical supply by means of an extension cable.
www.zanussi.
www.zanussi.
132922840-A-232012 www.zanussi.
