EN User manual Washer Dryer ZKG 7125 ZKG 7145 ZKG 7165
Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 Safety instructions _ _ _ _ _ _ _ _ _ _ _ _ _ _ 3 Product description _ _ _ _ _ _ _ _ _ _ _ _ _ 5 Control panel _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 6 Washing Programmes _ _ _ _ _ _ _ _ _ _ _ _ 9 Automatic Drying programmes _ _ _ _ _ _ _ 11 Drying Programmes _ _ _ _ _ _ _ _ _ _ _ _ _ 12 Helpful hints and tips _ _ _ _ _ _ _ _ _ _ _ _ 12 Drying Hints _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 14 First use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 14 Personalisation _
• Do not change the specification of this appliance. • Obey the maximum load volume of 8 kg (refer to the “Programme chart” chapter). • If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. • The operating water pressure (minimum and maximum) must be between 0,5 bar (0,05 MPa) and 8 bar (0,8 MPa) • The ventilation openings in the base (if applicable) must not be obstructed by a carpet.
change the fuse in the mains plug, use a 13 amp ASTA (BS 1362) fuse. • This appliance complies with the E.E.C. Directives. Water connection • Make sure not to cause damage to the water hoses. • The appliance is to be connected to the water mains using the new supplied hose-sets. Old hose sets must not be reused. • Before you connect the appliance to new pipes or pipes not used for a long time, let the water flow until it is clean. • The first time you use the appliance, make sure that there is no leakage.
Warning! Risk of injury or suffocation. • Disconnect the appliance from the mains supply. • Cut off the mains cable and discard it. • Remove the door catch to prevent children and pets to get closed in the appliance. Service • Contact the Service to repair the appliance. We recommend only the use of original spare parts.
Compartment for liquid additives (fabric softener, starch). Follow the product manufacturer’s recommendations on quantities to use and do not exceed the «MAX» mark in the detergent dispenser drawer. Any fabric softener or starching additives must be poured into the compartment before starting the wash programme. Child Safety device Make sure that children or pets do not climb into the drum. To prevent children and pets becoming trapped inside the drum this machine incorporates a special feature.
Start/Pause button 8 Delay start button 9 Door pilot light 10 Display Table of symbols = Rinse hold 1-8 Programme selector dial, spin speed button, drying level and time, and available options Programme Selector Dial It allows you to switch the appliance on/off and/ or to select a programme. Spin By pressing this button you can change the spin speed of the selected programme or to select Rinse Hold option.
10 Display 10.1 10.2 The display shows the following information: 10.1 Child safety lock This device permits you to leave the appliance unattended during it's functioning. 10.2 • Duration of the selected programme After selecting a programme, the duration is displayed in hours and minutes (for example ). The duration is calculated automatically on the basis of the maximum recommended load for each type of fabric. After the programme has started, the time remaining is updated every minute.
Washing Programmes Programme - Maximum and Minimum Temperature - Cycle Description - Maximum Spin Speed - Maximum Fabrics Load - Type of Laundry Options Cottons 90° - 60° Main wash - Rinses Maximum spin speed at 1200 rpm (ZKG 7125), 1400 rpm (ZKG 7145), 1600 rpm (ZKG 7165) Max. load 6 kg - Reduced load 3 kg1) White cotton(heavily and normally soiled items).
Programme - Maximum and Minimum Temperature - Cycle Description - Maximum Spin Speed - Maximum Fabrics Load - Type of Laundry Options Easy iron 40° Main wash - Rinses Maximum spin speed at 900 rpm Max. load 1 kg Synthetic or mixed fabrics: selecting this programme the laundry is gently washed and spun to avoid any creasing. In this way ironing is easier. Furthermore the machine will perform additional rinses.
Programme - Maximum and Minimum Temperature - Cycle Description - Maximum Spin Speed - Maximum Fabrics Load - Type of Laundry Rinses Maximum spin speed at 1200 rpm (ZKG 7125), 1400 rpm (ZKG 7145), 1600 rpm (ZKG 7165) Max. load 6 kg With this programme it is possible to rinse and spin cotton garments which have been washed by hand. The machine performs 3 rinses, followed by a final long spin.
Drying Programmes Degree of Drying Suitable for items to put away without ironing Suitable for items to put away without ironing Suitable for ironing Type of Fabric Max Load Cotton and linen (bathrobes, bath towels, etc) Synthetics and mixed fabrics 4 kg 3 kg 1,5 kg 2 kg 1 kg Cotton and linen (sheets, tablecloths, shirts, etc.
Dried grease stains: moisten with turpentine, lay the garment on a soft surface and dab the stain with the fingertips and a cotton cloth. Rust: oxalic acid dissolved in hot water or a rust removing product used cold. Be careful with rust stains which are not recent since the cellulose structure will already have been damaged and the fabric tends to hole. Mould stains: treat with bleach, rinse well (whites and fast coloureds only). Grass: soap lightly and treat with bleach (whites and fast coloureds only).
Drying Hints Preparing the drying cycle As a dryer, the appliance works on the condensation principle. Therefore, the water tap must be open and the drain hose must drain water into a sink or into the drain pipe, even during the drying cycle. Attention! Before starting the drying programme, reduce the loads of washed laundry, in order to obtain good performances.
laundry in the machine, to remove any manufacturing residue from the drum and tub. Pour 1/2 a measure of deter- gent into the main wash compartment and start the machine. Personalisation Acoustic signals The machine is provided with an acoustic device, which sounds in the following cases: • at the end of the cycle • if there is a fault. By pressing the 3 and 4 buttons simultaneously for about 6 seconds, the acoustic signal is deactivated (except if there is a fault).
Select the required programme by means of the programme selector dial (1) Turn the programme selector dial to the required programme. The green pilot light of button 7 starts to flash. The selector dial can be turned either clockwise or anticlockwise. to reset the Turn the selector dial to position programme/to switch the machine OFF. At the end of the programme the selector , to dial must be turned to position switch the machine off.
Important! • The selected delay can be changed only after selecting the washing programme again. • The door will be locked throughout the delay time. If you need to open the door, you must first set the washing machine to PAUSE by pressing button 7 and wait a few minutes before opening the door. After you have closed the door, press the same button again. Important! The Delay Start cannot be selected with the draining programme.
Note! By pressing Drying Time button it is also possible to dry up to 4 kg of cotton items (see the «Drying Programme» table). The water tap must be open and the drain hose must be positioned in the sink or connected to the drain pipe. 1. Load the laundry. 2. Select a spin cycle at the maximum spin speed allowed for the type of laundry in order to obtain the best drying performances. 3. Select the drying programme for Cottons or Synthetic in the Drying sector of the programme selector dial. 4.
the display. At this point of the programme, starts an anti-crease phase which lasts about 10 minutes. During this time the door is locked and the display keeps showing the flashing zero « ». (If you wish to open the door before or during the Fluff in the garments During the WASHING AND/OR DRYING PHASE, certain types of fabric, as spongecloth, sweatshirt, could release fluff. The released fluff could stick to the fabrics during the next cycle. This drawback increases with technical fabrics.
Replace the drawer and run the rinse programme without any clothes in the drum. Cleaning the pump The pump should be inspected regularly and particularly if: • the appliance does not empty and/or spin; • the appliance makes an unusual noise during draining due to objects such as safety pins, coins etc. blocking the pump; • a problem with water draining is detected (see chapter “What to do if...” for more details). 1. 2. Warning! Disconnect the mains plug from the mains socket.
• Turn off the water tap. • Unscrew the hose from the tap. • Clean the filter in the hose with a stiff brush. 1 2 Clean the filter under the water tap and put it back in the pump into the special guides. Make sure that you tighten correctly the filter to prevent leakages. Close the pump door. Caution! When the appliance is in use and depending on the programme selected there can be hot water in the pump.
4. 5. 6. put the two ends of the inlet hose in a container and let the water flow out of the hose. empty the drain pump as described in the ‘Emergency emptying out’ section. when the drain pump is empty, install the water inlet hose again. Warning! Make sure that the temperature is more than 0 °C before you use the appliance again. The manufacturer is not responsible for damages caused by low temperatures.
Problem Possible cause/Solution The washing machine does not start: The door has not been closed. • Close the door firmly. The plug is not properly inserted in the power socket. • Insert the plug into the power socket. There is no power at the socket. • Please check your domestic electrical installation. The main fuse has blown. • Replace the fuse. The selector dial is not correctly positioned and/or the button 7 has not been pressed. • Please turn the selector dial and press the button 7 again.
Problem Possible cause/Solution There is water on the floor: Too much detergent or unsuitable detergent (creates too much foam) has been used. • Reduce the detergent quantity or use another one. Check whether there are any leaks from one of the inlet hose fittings. It is not always easy to see this as the water runs down the hose; check to see if it is damp. • Check the water inlet hose connection. The drain or inlet hose is damaged. • Replace it with a new one.
Problem Possible cause/Solution The machine makes an unusual noise: The machine is fitted with a type of motor which makes an unusual noise compared with other traditional motors. This new motor ensures a softer start and more even distribution of the laundry in the drum when spinning, as well as increased stability of the machine. No water is visible in the drum: Machines based on modern technology operate very economically using very little water without affecting performance.
Electrical connection Voltage - Overall power - Fuse Information on the electrical connection is given on the rating plate, on the inner edge of the appliance door.
After removing all the packaging, carefully lay machine on it's back to remove the polystyrene base from the bottom. Unscrew the three bolts. Remove the power supply cable and the hose from the hose holders on the rear of the appliance. Slide out the relevant plastic spacers. raising or lowering the feet. The feet may be tight to adjust as they incorporate a self locking nut, but the machine MUST be level and stable. Any necessary adjustment can be made with a spanner.
• Connect the appropriate end of the hose to a tap with a 3/4” thread. Always use the hose supplied with the appliance. There should be a minimum vertical distance of 5.02 m (16.5 ft) between the appliance’s inlet and the bottom of the water storage tank. Water drainage This appliance is designed to be permanently plumbed into your home's drainage system using one of the following methods. 1. Into a drainage standpipe. Firstly form a hook in the end of the drain hose using the “U” piece” supplied.
If you intend to drain the hose from the machine into a sink, make sure that the sink is empty and the plug hole is not blocked. Use the plastic “U - Piece” supplied. Min. 60 cm (23.6”) Max. 90 cm (35.4”) If your drain hose looks like this (see beside) you do not require the “U” piece”. Just push the hose firmly in to the standpipe.
household waste disposal service or the shop where you purchased the product. Packaging materials are The materials marked with the symbol recyclable. >PE<=polyethylene >PS<=polystyrene >PP<=polypropylene This means that they can be recycled by disposing of them properly in appropriate collection containers. • Normally soiled laundry may be washed without prewashing in order to save detergent, water and time (the environment is protected too!). • The machine works more economically if it is fully loaded.
www.zanussi.
132937921-A-432012 www.zanussi.