REFRIGERATOR FRIGORÍFICO ZKC 49/3 INSTRUCTION BOOKLET 2222 257-04 MANUAL DE INSTRUÇÕES
CONTENTS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page 3 Conservation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page 4 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page 5 Positioning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page 5 Before using . . . . . . . . . . . . . . . . .
WARNINGS IT IS MOST IMPORTANT THAT THIS INSTRUCTION BOOK SHOULD BE RETAINED WITH THE APPLIANCE FOR FUTURE REFERENCE. SHOULD THE APPLIANCE BE SOLD OR TRANSFERRED TO ANOTHER OWNER, OR SHOULD YOU MOVE HOUSE AND LEAVE THE APPLIANCE, ALWAYS ENSURE THAT THE BOOK IS SUPPLIED WITH THE APPLIANCE IN ORDER THAT THE NEW OWNER CAN GET TO KNOW THE FUNCTIONING OF THE APPLIANCE AND THE RELEVANT WARNINGS.
CONSERVATION In the interests of the Environment: When disposing of your old fridge, freezer or fridge/ freezer. Help to keep your country tidy – use authorised disposal sites for your old appliances. For maximum efficiency: Make sure that the appliance is cleaned properly. Make sure that the door is closed properly. Do not position the appliance near to sources of heat. Do not over-fill your appliance, air MUST be allowed to circulate.
INSTALLATION Warning Before using IF YOU ARE DISCARDING AN OLD APPLIANCE THAT HAS A LOCK OR CATCH ON THE DOOR, YOU MUST ENSURE THAT IT IS MADE UNUSABLE TO PREVENT YOUNG CHILDREN BEING TRAPPED INSIDE. Remove all securing tapes. Wash inside the appliance with lukewarm water and bicarbonate of soda (5 ml to 0.5 litre of water). Do not use soap or detergent as the smell may linger. Dry thoroughly.
The electrical connections WARNING: THIS APPLIANCE MUST BE EARTHED. The manufacturer declines any liability should this safety measure not be observed. If the plug that is fitted to your appliance is not suitable for your socket outlet, it must be cut off and the appropriate plug fitted. Remove the fuse from the cut off plug. The cut off plug should then be disposed of to prevent the hazard of shocks in case it should be plugged into a 13amp socket in another part of your home.
Location Door reversibility This appliance is designed to be built-in to a space having the dimensions given in Fig. 2. Remove the two screws which fix the upper hinge to the door. Carefully lean the appliance on its back and remove the plastic insert (Fig. 4). 870 820 Fig. 2 Fig. 4 600 550 820-870 547 59 6 D506 100-170 The height of the appliance can be altered if required by means of adjustable feet situated at its base (Fig. 3). Fig.
Fitting a decorative door panel Important: The components needed to fit the decorative panel have been pre-fitted on the appliance. The brackets are secured to the panel by means of the 7 Ø 3.5x13 screws supplied. Before starting to fit the panel, remove the large top bracket by unscrewing the screws and adjusting pins prefitted on the appliance door. The small bottom bracket need not be removed. Place the appliance in the position where it is to be built in (Fig. 6).
Check the position again by slackening the screws and pins then, once the best position has been obtained, fully tighten all the fixings. Cover the visible part of the top bracket on the panel with plastic cover (D), inserting it in the locations provided in the bracket. If the base plate is between 100 and 135 mm high, cut it as shown in Fig. 15 and mount as described above. If the base plate is between 135 and 170 mm high, cut it as shown in Fig. 13. Fig. 14 Fig.
Changing the opening direction of the door (freezer compartment) Having changed the opening direction of the appliance door, it is advisable to also change the opening direction of the freezer compartment door. To do this, proceed as follows: Unscrew the two fixing screws to remove the lower hinge from the door (Fig. 16). Fig. 16 D576 Remove the freezer compartment door and the upper hinge. Once the freezer door has been removed, remove the screws from the catch and refit it on the opposite side (Fig.
YOUR APPLIANCE I H G F E D A B C A - Dairy compartment B - Shelf with egg tray C - Bottle storage shelf D - Salad drawers E - Glass shelf (for storing meat) F - Cool check temperature guide G - Storage shelves H - Thermostat control I- freezer compartment 11
OPERATION Setting the temperature Storing deep-frozen foods The temperature inside the refrigerator is regulated by a thermostat with 6 temperature positions and one «OFF» (O) position. The compartment marked reaches a temperature of –18°C and is therefore suitable for storing ice-creams and deep-frozen food.
HEALTH AND SAFETY GUIDELINES Because of consumer demand, preservatives have been removed from many pre-prepared food. This together with the changes in shopping habits to a once-a-week shop, mean that safe handling and storage of food is even more important than ever. The following tips should help you to ensure that the food in your home is in as perfect condition as possible. “ Keep the time between buying chilled food and placing it in your fridge as short as possible.
Fresh food refrigeration Cool check temperature guide To obtain the best performance, do not store warm food or evaporating liquids in the refrigerator; do cover or wrap the food, particularly if it has a strong flavour. Do not cover the shelves with any protective material, such as paper, cardboard or plastic, which may obstruct the air circulation through them. This model has a cool check temperature guide fitted to a shelf in the fridge compartment.
Everyday use of the cool check temperature guide Defrosting During everyday use a fridge door is opened many times and as a result temperature fluctuation may occur. A Zanussi fridge is designed to cope with any changes in temperature but under certain conditions the temperature guide in the appliance may show TOO WARM. The refrigerator compartment evaporator is automatically defrosted every time the compressor stops. The water drains out through a channel (Fig.
MAINTENANCE AND CLEANING Before any maintenance or cleaning work is carried out, DISCONNECT the appliance from the ELECTRICITY supply. Changing the light bulb Should the interior light fail to work, first switch off the appliance and disconnect from the electricity supply, then replace the bulb as follows, see Fig. 21. Internal cleaning Fig. 21 Clean the inside and accessories with warm water and bicarbonate of soda (5ml to 0.5 litre of water). Rinse and dry thoroughly.
WHAT HAPPENS IF SOMETHING GOES WRONG? Before contacting your local Zanussi Service Centre, check the following points: The appliance does not work... Check that: “ There is power at the socket. “ Ensure that there is not a power cut by checking the household lights. “ The fuse has not blown. “ The air circulation passages are not covered. “ The thermostat dial is in the correct position. Vibration or abnormal noises...
PEACE OF MIND FOR TWENTYFOUR MONTHS Zanussi standard guarantee conditions Exclusions This guarantee is in addition to your statutory and other legal rights which will not be excluded or in any way diminished by the return of this guarantee card. This guarantee does not cover: We, Zanussi Ltd.