Contents Installation Unpacking Positioning & leveling Water connection Electrical connection Operation Controls description Loading the clothes Filling with washing powder Use of additives ‘Which powder? Selection of washing Programmed Wash cycles Starting Stopping Care and cleaning Cleaning the machine Cleaning the drain filter Hints for car of washing powder dispenser Helpful tips for washing Servicing page page page page page page page page page page page page page 10-11 page Page page page page page pa
Installation Unpacking After removing outer carton, reinforcing angles and polythene wrapping, proceed as follows: Unscrew and remove, by means of the special spanner that comes with the machine, the three big resews to be found on the back of the appliance {fig. {fig. 1). The spanner supplied with the machine is provided with an hexagonal insert should be used for this purpose.
‘Water connection The machine may either be plumbed in or connected to existing taps. Details are given below. Water supply Separate supplies of hot and cold water are necessary. Single outlet gus or electric heaters are not suitable, 1f only cold water supply is available, connect the two hoses to a cold water tap. ‘Water outlet connection The drain pipe from this machine must connect into the main drain of the precises, but not into the rainwater n.
If an extension hose is required, it should not exceed a length of 180 ems (6 ft) fts diameter should not be smaller than that of the original drain hose and the extension hose should not be choked (kinked) in any way. The hose is to be positioned at. floor level and only the terminal part should be placed at the requisite drain level previously indicated. A failure to comply with these requirements may result in a malfunction of the drain pump.
Electrical Connection WARNING: THIS APPLIANCE MUST BE EARTHED The manufacturer declines to accept any Ability should this safety measure not be observed. If the plug that is fitted to your appliance is not suitable for your socket outlet, it must be cut off and the appropriate plug fitted. The cut off plug should be disposed of to prevent the hazard of electric shocks in ease it should be plugged into a 13 Amp socket in another part of your home.
1. Handle dispenser 2. Pilot lamp 3. Half load distribution «2h 4. Cold wash push button «l&» 5, Program selector Controls description Half-load push button « ¥4 » when pressed in, this push button will provide a reduced load in the tub. This makes it possible, when washing only a reduced load (ot more than half of the normal dry load), to obtain a reduced water consumption and a considerable saving in electric power consumption, This push button should not be pressed in when washing synthetics or woolens.
Loading the clothes Open the door of the machine by pulling the small double-action eaten (fig, 7) to the left first and then outwards. Load the clothes spreading them out evenly and then close the door again. Filling with washing pewter The washing powder dispenser is located on the front left of the control panel It is very important to use a low sussing powder (see paragraph «Which powders} such as Persia Automatic, or Ariel Autocratic, L3 Pull out the dispenser and add washing powder.
Which powder? Do not use ordinary powders in your new washing machine. The reason for this is very shingle, these powders produce so much lather that clothes are prevented from tumbling freely and cannot get properly clean. Do use the right powder. To get the best resits, we recommend Persia Automatic or Ariel Automatic. Like all modern automatic machines the ZI959T works at peak efficiency with a low lather product.
Energetic wash cycle For Cotton, Linen and Hemp Fabrics Recommended wash load: 10 Ths (4,5 Kgs) max. Wash eyl description Prewar in water at 40°C (normal level) followed by 2 soaking phase (the Landry is left sinking in water). To drain the water, turn the program knob b cycle < (drain with a gentle Pin) or
Gentle wash cycle For Delicate, Syntheses, Mixed Fabrics and Woolens Recommended wash load: 3-5 Ths (1,5-2 Kg; wool max. 2 Ibs (1 Kg). Important: There is no waiter draining in the last rinse of the gentle wash cycles, to prevent the clothes from creasing if they are left in the machine at the end of the wash cycle. To drain the water, turn the program selector knob to cycle «Us (draining & gentle spinning) or cycle «V» (draining without spinning).
Starch After loading the clothes, the washing powder and the fabric conditioners into the respective compartments, make sure before you start the machine that: -~ the plug i in the wall socket the water tap is turned on (fully open} — the drain hose is correctly placed the loading soot is correctly closed. You may now select the required wash cycle by turning the program control knob clockwise after making sure that it is pressed in.
Care and cleaning Cleaning the machine Important: Make sure that the plug has been removed from the socket prior to undertaking any kind of maintenance. From time to time, carry out a complete eyelet without a washing load, adding 1 oz of «Calgary, This should also be done when the washer has been out of use for a long time. Leave the door ajar for about 2 hours after the wash to allow air to crenelate freely inside the machine.
Hints for care of washing powder dispenser ‘We recommend that the washing powder dispenser is checked regularly to ensure that it is clean and dry. Do wipe the dispenser after each wash. Should the dispenser require special cleaning, the drawer can be completely removed, and the interior cleared of any deposit. The drawer can be removed from the front of the appliance by giving a sharp pull outwards. A sharp tap with the palm of the hand may be necessary when replacing the drawer.
Servicing Should servicing be required for this appliance contact your local Service Agent but before requesting service the following simple checks may save you inconvenience and expenses: The machine won't start Check that: the plug is firmly in the wall socket and that there is an electricity supply by plugging in another appliance; the door of the machine is firmly closed; the required programmer is correctly selected; the program control knob is actually pulled out; make sure the fuses of your electric
ZANINESS APPLIANCE GUARANTEE GAUSSIAN STANDARD GUARANTEE CONDITIONS This guarantee is in addition to your statutory and other legal rights which will not be excluded or in any way diminished hy the return of the guarantee card.