User manual

11
I
P
Fijar el aparato con los 4 tornillos en dotación.
(I = corto) (P = largo)
D724
Colocar a presión el cubrejuntas entre el aparato y
el mueble.
PR266
Ha
Hb
Hc
Hd
2
1
m
m
2
1
m
m
ca. 50 mm
90°
90°
ca. 50 mm
Separar las piezas Ha, Hb, Hc, Hd según se indica
en la figura.
Apoyar la guía (Ha) sobre la parte interior de la
puerta del mueble arriba y abajo según se indica en
la figura y marcar la posición de los agujeros
exteriores. Una vez que se hayan hecho los
agujeros, fijar la guía con los tornillos presentes en
el equipo base.
B
E
C
D
Colocar les tapas (C-D) sobre los extremos del perfil
y en los agujeros para la bisagra.
Colocar la parrilla de aireación (B) encajándola a
presión y engornar la tapa (E) en posición.
14
CONTENTS
Warnings 13
Use 15
Cleaning the interior 15
Control panel 15
Dispaly 15
Operation 16
Activation of function 16
Switching off 16
Temperature regulation 16
Shopping function 16
Fresh food refrigeration 16
Door open acoustic alarm 16
Movable shelves 17
Positioning the door shelves 17
Hints 17
Hints for refrigeration 17
Maintenance 18
Periodic cleaning 18
Periods of no operation 18
Interior light 18
Defrosting 18
Customer service and spare parts 19
Technical information 19
Installation 19
Location 19
Electrical connection 20
Shelf holders 20
Door Reversibility 20
Instruction for totally built-in appliances 21
Environment Protection
This appliance does not contain gasses which
could damage the ozone layer, in either its
refrigerant circuit or insulation materials.The
appliance shall not be discarded together with
the urban refuse and rubbish. Avoid damaging
the cooling unit, especially at the rear near the
heat exchanger. Information on your local
disposal sites may be obtained from municipal
authorities.The materials used on this appliance
marked by the symbol are recyclable.
Installation
• During normal operation, the condenser and
compressor at the back of the appliance heat up
considerably. For safety reasons, minimum
ventilation must be as shown in the instructions.
Attention: keep ventilation openings clear of
obstruction.
• Care must be taken to ensure that the appliance
does not stand on the electrical supply cable.
Important: if the supply cord is damaged, it must
be replaced by a special cord or assembly availa-
ble from the manufacturer or its service agent.
• If the appliance is transported horizontally, it is
possible that the oil contained in the compressor
flows in the refrigerant circuit. It is advisable to
wait at least two hours before connecting the
appliance to allow the oil to flow back in the
compressor.
• There are working parts in this product which
heat up. Always ensure that there is adequate
ventilation as a failure to do this will result in
component failure and possible food loss. See
installation instructions.
• Parts which heat up should not be exposed.
Wherever possible the back of the product should
be against a wall.