User manual

25
Place guide (Ha) on the inside part of the furniture
door as shown in the figure and mark the position of
external holes. After having drilled holes, fix the
guide with the screws supplied.
21 m
m
ca. 50 mm
90°
ca. 50 mm
21 m
m
Fix cover (Hc) on guide (Ha) until it clips into place
PR33
Hc
Ha
PR167
Ha
Hb
8mm
Open the appliance door and the furniture door at
90°. Insert the small square (Hb) into guide (Ha).
Put together the appliance door and the furniture
door and mark the holes as indicated in the figure.
Remove the squares and drill holes with ø 2 mm at 8
mm from the outer edge of the door. Place the small
square on the guide again and fix it with the screws
supplied.
PR168
Hb
PR167/1
Hd
Hb
Should the lining up of the furniture door be
necessary, use the clearance of slots.
At the end of operations, it is necessary to check if
the door of the furniture closes properly.
Fix cover (Hd) on guide (Hb) until it clips into place.