REFRIGERATORFREEZER ZI 9310 DIS © Electrolux plc 2002 INSTRUCTION BOOKLET 2222 209-46
IMPORTANT SAFETY INFORMATION It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is left with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant safety information. This information has been provided in the interest of safety.
CONTENTS Should the lining up of the furniture door be necessary, use the clearance of slots. At the end of operations, it is necessary to check if the door of the furniture closes properly.
Separate parts A, B, C, D as shown in the figure OPERATION B A O 6 C 4 3 5 2 1 Control panel D A PR266 B Before using Do not use soap or detergent as the smell may linger. Dry thoroughly. 50mm Place guide (A) on the inside part of the furniture door, up and down as shown in the figure and mark the position of external holes. After having drilled holes, fix the guide with the screws supplied. Remove all securing tapes.
Push appliance into housing until stop strip (A) touches the kitchen unit. Storage of frozen food A When first starting-up or after a period of non use, before putting the products in the freezer compartment let the appliance run for at least two hours on the coldest setting, then turn the thermostat knob to the normal opertion position. Do not exceed the storage period indicated by the manufacturer. Finally, do not open the door frequently or leave it open longer than is absolutely necessary.
HINTS AND TIPS Instructions for totally built-in appliances Food Storage In the Event of a Power Failure • If there is a power failure during the storage of frozen foods, keep the door closed. If the temperature within your freezer should rise do not refreeze the food without checking it’s condition. The following guidelines should assist you. To obtain the best results from your appliance, neither hot foods nor liquids which may evaporate, should be placed in the larder compartment.
Electrical connections Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. WARNING: THIS APPLIANCE MUST BE EARTHED. The manufacturer declines any liability should this safety measure not be observed. For replacement, use a 13amp BSI362 fuse. Only ASTA or BSI approved fuses should be used. The plug must not be used if the fuse cover/carrier is lost. The cover/carrier is indicated by the coloured insert at the base of the plug.
INSTALLATION Defrosting Refrigerator The refrigerator automatically defrosts every time the compressor stops. The water is discharged, via the pipe, into a tray located at the back of the appliance above the compressor, where it evaporates. Warning IF YOU ARE DISCARDING AN OLD APPLIANCE THAT HAS A LOCK OR CATCH ON THE DOOR, YOU MUST ENSURE THAT IT IS MADE UNUSABLE TO PREVENT YOUNG CHILDREN BEING TRAPPED INSIDE.
TECHNICAL SPECIFICATIONS SOMETHING NOT WORKING POWER SUPPLY VOLTAGE AND FREQUENCY 220-240 V / 50 Hz TOTAL POWER ABSORBED 110 W AVERAGE DAILY UNITS ELECTRICITY * 0.86 kWh GROSS CAPACITY Fridge 204 l Freezer 76 l NET CAPACITY Important: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation a charge will be made, even if the appliance is under guarantee.
SERVICE AND SPARE PARTS In the event of your appliance requiring service, or if you wish to purchase spare parts, please contact your local Zanussi Service Force Centre by telephoning:- 0870 5 929929 Your telephone call will be automatically routed to the Service Force Centre covering your post code area. For the address of your local Service Force Centre and further information about Service Force, please visit the website at www.serviceforce.co.
SERVICE AND SPARE PARTS In the event of your appliance requiring service, or if you wish to purchase spare parts, please contact your local Zanussi Service Force Centre by telephoning:- 0870 5 929929 Your telephone call will be automatically routed to the Service Force Centre covering your post code area. For the address of your local Service Force Centre and further information about Service Force, please visit the website at www.serviceforce.co.
TECHNICAL SPECIFICATIONS SOMETHING NOT WORKING POWER SUPPLY VOLTAGE AND FREQUENCY 220-240 V / 50 Hz TOTAL POWER ABSORBED 110 W AVERAGE DAILY UNITS ELECTRICITY * 0.86 kWh GROSS CAPACITY Fridge 204 l Freezer 76 l NET CAPACITY Important: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation a charge will be made, even if the appliance is under guarantee.
INSTALLATION Defrosting Refrigerator The refrigerator automatically defrosts every time the compressor stops. The water is discharged, via the pipe, into a tray located at the back of the appliance above the compressor, where it evaporates. Warning IF YOU ARE DISCARDING AN OLD APPLIANCE THAT HAS A LOCK OR CATCH ON THE DOOR, YOU MUST ENSURE THAT IT IS MADE UNUSABLE TO PREVENT YOUNG CHILDREN BEING TRAPPED INSIDE.
Electrical connections Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. WARNING: THIS APPLIANCE MUST BE EARTHED. The manufacturer declines any liability should this safety measure not be observed. For replacement, use a 13amp BSI362 fuse. Only ASTA or BSI approved fuses should be used. The plug must not be used if the fuse cover/carrier is lost. The cover/carrier is indicated by the coloured insert at the base of the plug.
HINTS AND TIPS Instructions for totally built-in appliances Food Storage In the Event of a Power Failure • If there is a power failure during the storage of frozen foods, keep the door closed. If the temperature within your freezer should rise do not refreeze the food without checking it’s condition. The following guidelines should assist you. To obtain the best results from your appliance, neither hot foods nor liquids which may evaporate, should be placed in the larder compartment.
Push appliance into housing until stop strip (A) touches the kitchen unit. Storage of frozen food A When first starting-up or after a period of non use, before putting the products in the freezer compartment let the appliance run for at least two hours on the coldest setting, then turn the thermostat knob to the normal opertion position. Do not exceed the storage period indicated by the manufacturer. Finally, do not open the door frequently or leave it open longer than is absolutely necessary.
Separate parts A, B, C, D as shown in the figure OPERATION B A O 6 C 4 3 5 2 1 Control panel D A PR266 B Before using Do not use soap or detergent as the smell may linger. Dry thoroughly. 50mm Place guide (A) on the inside part of the furniture door, up and down as shown in the figure and mark the position of external holes. After having drilled holes, fix the guide with the screws supplied. Remove all securing tapes.
CONTENTS Should the lining up of the furniture door be necessary, use the clearance of slots. At the end of operations, it is necessary to check if the door of the furniture closes properly.
IMPORTANT SAFETY INFORMATION It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is left with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant safety information. This information has been provided in the interest of safety.
REFRIGERATORFREEZER ZI 9310 DIS © Electrolux plc 2002 INSTRUCTION BOOKLET 2222 209-46
