User manual

ManualsBrandsZanussi ManualsDomestic AppliancesZI921/8FF

Movable shelves

The walls of the refrigerator have runners so that the

shelves can be positioned as desired .

For better use of space, the front half-shelves can lie

over the rear ones.

D338

Positioning the door shelves

To permit storage of food packages of various sizes,

the door shelves can be adjusted in height. To do this

proceed as shown in the diagram.

The top shelf can be removed for easier cleaning.

Bottle rack

Place bottles in the rack with the bottleneck to the

front.

Important: Only store unopened bottles horizontally.

The bottle rack can be tilted for storing opened

bottles.

To do this pull the bottle rack forward until it can be

tilted upwards, then slide the front support into the

next level up.

INSTALLATION

Positioning

This appliance should only be installed at a location

where the ambient temperature corresponds to the

climate classification indicated on the rating plate,

which is located at the left on the inside of the

appliance.

The following table shows which ambient

temperature is correct for each climate classification:

SN +10°C to + 32°C

N +16°C to + 32°C

ST +18°C to + 38°C

T +18°C to + 43°C

The appliance should be located in a dry

atmosphere, out of direct sunlight and away from

continuous heat and extreme temperature, e.g. not

next to a boiler or radiator, or in a very cold room e.g.

an outhouse. If these temperatures are exceeded i.e.

warmer or colder, then the appliance may not

operate correctly.

For building-in and door reversal instructions please

refer to the relevant instructions on the following

pages.

Warning

IF YOU ARE DISCARDING AN OLD APPLIANCE

THAT HAS A LOCK OR CATCH ON THE DOOR,

YOU MUST ENSURE THAT IT IS MADE

UNUSABLE TO PREVENT YOUNG CHILDREN

BEING TRAPPED INSIDE.

Depending upon the position which you choose for

your appliance, you may wish to reverse the way in

which the door opens. To do this, refer to instructions

on “Door reversal directions”.

Important

It must be possible to disconnect the appliance from

the mains power supply; the plug must therefore be

easily accessible after installation.

Shelf holders

Your appliance is equipped with shelf retainers that

make it possible to secure the shelves during

transportation.

To remove them proceed as follows:

Raise the shelf from the back, push it in the direction

of the arrow until it is freed and remove the retainers.