REFRIGERADOR CONGELADOR FRIDGE-FREEZER FRIGORÍFICOCONGELADOR ZI 7280 D LIBRO DE INSTRUCCIONES 2222 014-83 INSTRUCTION BOOKLET MANUAL DE INSTRUÇÕES
Warning! The appliance which you have just bought is supplied not only with the instruction manual, but also with a Warranty Card Certificate, on the back of which are written the relative conditions. Please fill in the necessary details on the Card Certificate and send it to the Zanussi Centre covering the area in which the appliance is to be installed. (See list of Zanussi network centres). We congratulate you on your choice.
WARNINGS GB It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings. These warnings are provided in the interest of safety.
CONTENTS Installation 18 ª Location 18 ª Cleaning the appliance’s interior 18 ª Instructions for total built-in 19 ª Door reversibility 19 ª Electrical connection 22 Technical specification 22 Use 23 ª Starting-up and temperature regulation 23 ª Freezing fresh food 23 ª Storage of frozen food 23 ª Thawing 23 ª Food refrigeration 24 ª Movable shelves 24 ª Positioning the door shelves 24 GB ª Use and features of the «CRISP’N FRESH» filter 25 ª Cleaning the filter 25 ª Defrosti
INSTALLATION If this refrigerator featuring magnetic door seals is to replace an older appliance having a spring lock on the door or lid, be sure to make that spring lock unusable before you discard the old appliance. This will prevent it from becoming a death-trap for a child. Location The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc.
Instructions for total built-in Door reversibility Right-hand opening Remove the pins (P) and (P1). Left-hand opening Remove pins (P) from both sides and the door. Remove the middle hinge (A) and refit it on the opposite side. Refit the door and pin (P) on the left side. Remove pin (P1) from the right side. Housing’s dimensions Height 1580 mm Depth 550 mm Width 560 mm Fig.
For appropriate venting, follow indications in Fig. 2. Fig. 2 50-min. cm 2 200 min. cm2 200 D033 Fig. 3 Push appliance into housing until stop strip (A) touches the kitchen unit. A D015 If after having carried out the operation described in the previous section there is still some space left between the appliance and the kitchen unit, fit the trimming provided together with the appliance on the stop strip (A). Fig.
Press in the joint covers between the appliance and the kitchen furniture. Fig. 6 D503 Fig. 7 Apply covers (B) on joint cover lugs and into hinge holes. B D353 Position the runners (H) at the top and bottom of the inside of the kitchen unit as shown in Fig. 8 and mark the position of the external holes. After preparing the holes, screw the runners to the kitchen unit door using 3.5x16 mm screws. Fig. 8 H 20m m D094 Fig. 9 Open both the appliance door and that of the kitchen unit to approx. 90°.
Remove the little plates and make the holes with a diam. of 2 mm. Replace the little plates over the runners and screw in the screws provided (3.5x16 mm). For the alignment of the kitchen unit door, if necessary, use the clearance size of the slotted holes. At the end of the procedure, check that the doors of the appliance and the kitchen unit open properly. Fig. 10 PR35 Fig.
USE Starting-up and temperature regulation Insert the plug into the wall socket. Open the refrigerator door and turn the thermostat knob, to be found on the top right hand side of the inner liner, clockwise beyond the «O» position, to start the appliance. GB temperature of the food to be frozen cannot increase the temperature of frozen foods. Never load a larger quantity of foods than that recommended. During freezing, never add other food to be frozen and do not open the door too often.
Food refrigeration To achieve the best results with the refrigerator compartment, you should follow one or two very simple rules: Do not put warm foods or evaporating liquids in the refrigerator. Cover or wrap foods (particularly if they have a strong smell). Do not cover the shelves (grids) with paper or plastic since this blocks circulation of air in the compartment.
For more thorough cleaning, the top door shelf can be removed by pulling it in the direction of the arrows, then refitting it in position (Fig. 13). Fig. 13 D009 Use and features of the «CRISP’N FRESH» filter Fig. 14 The glass shelf on top of the vegetable drawer is fitted with a special filter called «CRISP’N FRESH» which ensures the correct amount of ventilation, and significantly reduces the rate of food dehydration; vegetables therefore store better and keep longer. D002 Fig.
Defrosting Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor compressor stops, during normal use. The defrost water drains out through a trough into a special container at the back of the appliance, over the motor compressor, where it evaporates. Fig. 16 It is important to periodically clean the defrost water drain hole in the middle of the refrigerator compartment channel to prevent the water overflowing and dripping onto the food inside.
MAINTENANCE Unplug the appliance before carrying out any maintenance operation. GB Interior light The light bulb inside the refrigerator compartment can be reached as follows: Periodic cleaning ª unscrew the light cover securing screws; Never use metal objects for cleaning your appliance as it may get damaged. Clean the inside with warm water and bicarbonate of soda. Rinse and dry thoroughly. Periods of non-operation ª unhook the moving part by pressing it as shown in the figure.
