REFRIGERATEUR REFRIGERATOR FRIGORÍFICO ZI 7165 ZI 5165 NOTICE D’UTILISATION 2222 748-91 INSTRUCTION BOOKLET MANUAL DE INSTRUÇÕES
WARNINGS GB It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings. These warnings are provided in the interest of safety.
CONTENTS Installation 15 Positioning 15 Cleaning the interior 15 Instructions for totally built-in appliances 15 Electrical connection 17 Technical specification 17 Use 18 Operation 18 Temperature regulation 18 Fresh food refrigeration 18 Movable shelves 18 Positioning the door shelves 18 Use and features of the «CRISP’N FRESH» filter 19 Cleaning the filter 19 Defrosting 19 Maintenance 20 Periodic cleaning 20 Periods of non-operation 20 Inter
INSTALLATION Positioning The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. Best performance is obtained with ambient temperature between +18°C and +43°C (class T); +18°C and +38°C (class ST); +16°C and +32°C (class N); +10°C and +32°C (class SN). The class of your appliance is shown on its rating plate.
Fig. 2 Push appliance into the housing until stop strip (A) touches the kitchen unit. A D022 If after having carried out the previously described operation there is still some space left between the appliance and the kitchen unit, fit the trimming provided together with the appliance on the stop strip (A). Fig. 3 A D265 Open the door and push the appliance against the side of the kitchen unit opposite to that of appliance hinges.
Fig. 7 Position the runners (H) at the top and bottom of the inside of the kitchen unit as shown in Fig. 7 and mark the position of the external holes. After preparing the holes, screw the runners to the kitchen unit door using 3.5x16 mm screws. H 20m m D094 Open both the appliance door and that of the kitchen unit to approx. 90°. Place the little plates over the runners. Hold the doors of the appliance and the unit together and mark the holes. Fig.
USE Operation Insert the plug into the wall socket. Open the refrigerator door and turn the thermostat knob, clockwise, beyond the «O» (STOP) position. The appliance will start to operate. Temperature regulation The temperature is automatically regulated and can be increased to achieve a higher temperature (warmer) by rotating the thermostat knob toward lower settings or reduced (colder) rotating the knob towards higher settings.
Fig. 12 For more thorough cleaning, the top door shelf can be removed by pulling it in the direction of the arrows, then refitting it in position (Fig. 12). Use and features of the «CRISP’N FRESH» filter D009 The glass shelf on top of the vegetable drawer is fitted with a special filter called «CRISP’N FRESH» which ensures the correct amount of ventilation, and significantly reduces the rate of food dehydration; vegetables therefore store better and keep longer. Cleaning the filter Fig. 13 D683 Fig.
MAINTENANCE Unplug the appliance before carrying out any maintenance operation. Periodic cleaning Never use metal objects for cleaning your appliance as it may get damaged. Clean the inside with warm water and bicarbonate of soda. Rinse and dry thoroughly. Periods of non-operation GB Interior light The light bulb inside the refrigerator compartment can be reached as follows: unscrew the light cover securing screws; unhook the moving part by pressing it as shown in the figure.