Installation Warn If you are discarding an old appliance that has a lock or eats on the door, please ensure that this is made unusable to prevent young children getting trapped inside. Electricity Supply The appliance is for operation on & 220/ 240 V, 50 Hz supply, so be sure that your electricity supply voltages is within the range marked on the nameplate located inside the cabinet. Earthing ‘WARNING: THIS APPLIANCE MUST BE BERTHED.
Positioning These models can be fitted into a kitchen column {see relevant paragraph) being careful that the wall socket remains easily accessible. Before using Remove all securing tapes, Wash inside the appliance with lukewarm water and a little bicarbonate of soda (one teaspoonful to one quart of water). Do not use soap or detergent as the smell might linger. Dry thoroughly. Refrigerator Starting-up Temperature Regulation Mod. ZI 3165A Z1 3243A Insert the plug into the wall socket.
Cooked food, dole cuts, jelly, ete: these should be well covered and can be stored on anyone of the shelves. Fruit & vegetables: these should be thoroughly cleaned and placed in the bottom drawer. Butter & cheese: these should be placed in special airtight containers or wrapped in aluminum foil or polythene bags to exclude as much air as possible. Milk bottles: these should have a cap and should be stored in the bottle rack on the door.
Maintenance Prior to undertaking any maintenance operation, be sure to unpin the appliance from the wall socket as a safety precaution. Clean out the interior periodically with lukewarm water and some bicarbonate of sods, the cabinet exterior with a Silicon wax spray, the condenser and the motor compressor with a brush or a vacuum cleaner.
Instructions for totally built-in appliances Models Height of housing | Depth of housing | Width of housing 71 32434 mm 1225 mm 550 mm 560 Z1 81654 mm 880 mm 550 mm 560 FLe L feE The appliance's door has been locked in position for transport by means of pins on goth sides. : According to the door opening direction, remove relevant pins at the top and at the bottom. For appropriate venting, follow indications in fig. 2. Push appliance into housing until stop strip «A» touches the kitchen unit.
Open the door and push the appliance against the side of kitchen furniture opposite to that of appliance hinges. Fasten the appliance with 4 screws provided in the kit included with the appliance. Snap vent grill «C» and hinge cover «D» into position. Press in the joint covers between the appliance and the kitchen furniture. Apply covers «B» on joint cover lugs and into hinge holes.
Fig. 8 Drill holes in the door as indicated in fig. 7 with reference to the opening direction and fasten the runners. Open the door as shown in fig. 8, position runner B at the top and at the bottom as shown in fig. 9; slide it to the left (or to the right) and fasten it firmly. Fit snap-wise cover C.
Inner door reversal Slide out pin xAx, remove the inner door, remove catch «C»; reassemble the inner door on the opposite side using pins «A» and «B».
GAUSSIAN GUARANTEE CONDITIONS This guarantee is in addition te your statutory and other legal rights which will not be excluded or in any way diminished by the return of the enclosed card.