KÜHLSCHRANK REFRIGERATEUR KOELKAST REFRIGERATOR ZI 1644 ZI 2444 BEDIENUNGSANLEITUNG GEBRUIKSAANWIJZING 2222750-26 Downloaded from Fridge-Manual.
Instructions for the use of the instructions booklet t Notes which are important for your safety or for the proper functioning of the appliance Supplementary information regarding operation and practical applications of the appliance. Tips and notes concerning economical and environmentally sound use of the appliance Safety Instructions This information has been provided in the interests of your safety. Please read it before installing or using the appliance.
Disposal of old appliances The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product.
¥ Setting ã6Ò = lowest temperature, coldest setting. ¥ Setting ã¥Ò = Off A medium setting is generally the most suitable. Internal Parts Storage shelves ¥ The shelves can be removed for cleaning. ¥ To permit storage of food packages of various sizes, the shelves can be placed at different heights. ¥ To remove the internal shelf pull forward until it can be tipped up or down and removed. D302 ¥ Please do the same in reverse to insert the shelf at a different height.
Freezer compartment Temperature Control ¥ To freeze fresh foods it is not necessary to change the setting of the thermostat knob. ¥ For a quicker freezing operation, turn the thermostat knob to the coldest setting; but remember that, in this condition, the refrigerator compartment temperature might drop below 0¡C. If this occurs reset thermostat knob to a warmer setting.
Freezer compartment ¥ Remove the frost with a plastic scraper. ¥ Whenever the thickness of the frost exceeds 5 mm complete defrosting should be carried out. Prooceed as follows: ¥ Remove any stored food, wrap it in several layers of newspaper and put it in a cool place. ¥ Pull out the plug from the wall socket or turn the thermostat knob to the ÇOÈ setting. ¥ Leave the door open, place a basin on the top shelf of the refrigerator compartment, under the drain hole, remove the plug as shown in the figure.
Something not Working Problems may be due to causes which can easily be solved before calling the Technical Service. Please follow these instructions: SYMPTOM SOLUTION Door does not close Weight surpasses the storage limit of the door shelf so spread weight more evenly or take some products out. The appliance is not properly installed. Please look in the ÒBuilding-inÓ section. It is too warm inside the refrigerator Set a lower temperature.
Door reversal The applianceÕs door has been locked in position for transport by means of pins on both sides. According to the door opening direction, remove relevant pins at the top and at the bottom. A Warning! If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdrier.
Installation Take utmost care when handling your appliance so as not to cause any damages to the cooling unit with consequent possible fluid leakages. ¥ During normal operation, the condenser and compressor at the back of the appliance heat up considerably. Always ensure that there is adequate ventilation as a failure to do this will result in component failure and possible food loss. See installation instructions.
Building-in Dimensions of the recess ZI 1644 ZI 2444 Height of housing (1) 880 Depth of housing (2) 550 Width of housing (3) 560 1225 550 560 mm mm mm 1 50 540 2 3 2 D022 1 1. Fit the appliance in the niche by making sure that it stands against the interior surface of the unit on the side where the door hinges of the appliances are fitted. Insert the appliance until the upper strip butts up against the unit (1) and make sure that the lower hinge is in line with the surface of the unit (2).
D C Ha Hc E B PR33 4. Snap vent grill (B) and hinge cover (E) into position. Apply blanking covers (C-D) as indicated. 7. Fix cover (Hc) on guide (Ha) until it clips into place. 8mm Hb Ha Hc Ha Hd PR167 PR266 5. Separate parts Ha, Hb, Hc, Hd as shown in the figure. Hb 8. Open the appliance door and the furniture door at 90¡. Insert the small square (Hb) into guide (Ha). Put together the appliance door and the furniture door and mark the holes as indicated in the figure. ca.
Hb PR168 10. Place the small square on the guide again and fix it with the screws supplied. Should the alignment of the furniture door be necessary, use the clearance of slots. At the end of this procedure, it is necessary to check if the door of the furniture closes properly. Hb Hd PR167/1 11. Fix cover (Hd) on the small square (Hb) until it clips into place. Downloaded from Fridge-Manual.
DECLARATION OF GUARANTEE TERMS (B) Our appliances are produced with the greatest of care. However, a defect may still occur. Our consumer services department will repair this upon request, either during or after the guarantee period. The service life of the appliance will not, however, be reduced as a result. This declaration of guarantee terms is based on European Union Directive 99/44/EC and the provisions of the Civil Code.
Downloaded from Fridge-Manual.