Owner's manual

GB 12
INSTALLATION
Drilling the Support surface and Fit-
ting the Hood
SCREW FITTING
• The hood support surface must be 135 mm
abovethebottomsurfaceofthewallunits.
• Drillthesupportwithaø4,5mmdrillbit,using
thedrillingtemplateprovided.
• Cutaholeø125mminsizeonthesupportsur-
face,usingthedrillingtemplateprovided.
• Fixusingthe4screws12a(4,2x44,4)provid-
ed.
SNAP-ON FITTING
• Thehoodcanbeinstalledeitherdirectlyonthe
bottom surfaceof thewall unitsusingsnap-on
sidesupports.
• Cutattedopeninginthebottomsurfaceofthe
wallunit,asshown.
• Insertthehooduntilthesidesupportssnapinto
place.
• LockinpositionbytighteningthescrewsVffrom
underneaththehood.
CLOSING ELEMENT
• Thespacebetweentheedgeofthehoodandthe
rearwallcanbeclosedbyapplyingtheelement
20provided,using thescrews suppliedfor this
purpose.







