User Manual GETTING STARTED? EASY.
SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference.
• • • • • • • • CAUTION: The cooking process has to be supervised. A short term cooking process has to be supervised continuously. WARNING: Danger of fire: Do not store items on the cooking surfaces. Metallic objects such as knives, forks, spoons and lids should not be placed on the hob surface since they can get hot. Do not use a steam cleaner to clean the appliance.
• • • appliance and the upper drawer, is sufficient for air circulation. The underside of the appliance can get hot when in use. If an oven has not been fitted underneath the hob and underside of the appliance is accessible and could allow a user or items stored beneath the hob to come in direct contact with the underside of the hob, an intermediate protection panel must be fitted. Plywood or kitchen carcass material is acceptable for the panel. The panel must be removable for servicing.
• • • The vapours that very hot oil releases can cause spontaneous combustion. Used oil, that can contain food remnants, can cause fire at a lower temperature than oil used for the first time. Do not put flammable products or items that are wet with flammable products in, near or on the appliance. WARNING! Risk of damage to the appliance. • • • • • • • • • • • • • • Do not keep hot cookware on the control panel. Do not let cookware to boil dry.
PRODUCT DESCRIPTION COOKING SURFACE LAYOUT 1 1 Semi-rapid burner 2 Triple Crown burner 2 3 Auxiliary burner 4 Control knobs 3 4 CONTROL KNOB Symbol Description no gas supply / off position ignition position / maximum gas supply DAILY USE WARNING! Refer to Safety chapters.
BURNER OVERVIEW WARNING! Be very careful when you use open fire in the kitchen environment. The manufacturer declines any responsibility in case of the flame misuse. A B 1. Push the control knob down and turn it counterclockwise to the maximum gas supply position ( ). 2. Keep the control knob pushed for equal or less than 10 seconds. This lets the thermocouple warm up. If not, the gas supply is interrupted. 3. Adjust the flame after it is regular.
WARNING! Always turn the flame down or switch it off before you remove the pans from the burner. HINTS AND TIPS WARNING! Refer to Safety chapters. CAUTION! Make sure that the pots are placed centrally on the burner in order to get maximum stability and to get lower gas consumption. COOKWARE CAUTION! Do not use cast iron pans, potstones, earthenware, grill or toaster plates. The stainless steel can become tarnished if it is too much heated.
Be very careful when you replace the pan supports to prevent the hob top from damage. 2. The enamel coating occasionally can have rough edges, so be careful when you wash the pan supports by hand and dry them. If necessary, remove stubborn stains with a paste cleaner. 3. After you clean the pan supports, make sure that they are in correct positions. 4. For the burner to operate correctly, make sure that the arms of the pan supports are aligned with the centre of the burner.
WHAT TO DO IF... Problem Possible cause There is no spark when you try to activate the spark generator. The hob is not connected to an electrical supply or it is connected incorrectly. Check if the hob is correctly connected to the electrical supply. The fuse is blown. Make sure that the fuse is the cause of the malfunction. If the fuse is blown again and again, contact a qualified electrician. Burner cap and crown are placed incorrectly. Place the burner cap and crown correctly.
C. Stick it on instruction booklet. INSTALLATION WARNING! Refer to Safety chapters. BEFORE THE INSTALLATION Before you install the hob, write down the information bellow from the rating plate. The rating plate is on the bottom of the hob. Model ....................................... PNC ......................................... Serial number ...........................
Make sure that the main connection pipe does not exert any strain on the hob. If you use flexible metal pipes make sure that they agree to ISO 10380 and ISO 10807 standards. Be careful they do not come in touch with mobile parts or they are not squeezed. Also be careful when the hob is put together with an oven. CAUTION! It is important to install the elbow correctly, with the shoulder on the end of the thread, fitted to the hob connecting pipe.
• N — Neutral terminal • or E — Earth terminal Before carrying out the connection, make sure: 1. The limiter valve and the electrical system can take the appliance load (see the rating plate) 2. The supply system is equipped with an efficient earth connection in compliance with the current standards and regulations 3. The outlet or omnipolar switch used for connection is easily accessible with the appliance installed. The appliance is supplied with a 3 core flexible power cable with a 3 amp plug.
ASSEMBLY 1. If a furniture unit is installed at a distance of 400 mm above the hob, there must be a minimum safety distance of 50 mm to the left or right from the edge of the hob. 5. 6. 2. 7. 3. min. 600 mm min. 100 mm min. 650 mm 8. min. 55 mm 30 mm 480 mm 560 mm 4. 400 mm 9.
10. Kitchen unit with door or drawer A) supplied seal B) supplied brackets min 6 mm A 11. B min 30 mm min 5 mm (max 150 mm) 60 mm A. Removable panel B. Space for connections CAUTION! Install the appliance only on a worktop with flat surface. POSSIBILITIES FOR INSERTION The panel installed below the hob must be easy to remove and let an easy access in case a technical assistance intervention is necessary.
OTHER TECHNICAL DATA Gas original: G20 (2H) 20 mbar = 9 kW TOTAL POWER: Gas replacement: G30 (3+) 28-30 mbar = 654 g/h G31 (3+) 37 mbar = 643 g/h Electric supply: 220-240 V ~ 50/60 Hz 3 core flexible cable with non rewireable plug fitted with a 3 amp cartridge fuse Appliance category: II2H3+ Gas connection: R 1/2" Appliance class: 3 GAS BURNERS FOR NATURAL GAS G20 20 MBAR BURNER NORMAL POWER kW MINIMUM POWER kW INJECTOR MARK Triple Crown 4,0 1,4 146 Semi-rapid 2,0 0,45 96 Auxiliary
Energy efficiency per gas burner (EE gas burner) Left middle - Semi-rapid 56.2% Centre rear - Semi-rapid 62.2% Right middle - Triple Crown 55.6% Centre front - Auxiliary not applicable Energy efficiency for the gas hob (EE gas hob) 58.0% Model identification ZGX66424XS Type of hob Built-in hob Number of gas burners 4 Energy efficiency per gas burner (EE gas burner) Left middle - Semi-rapid 60.4% Centre rear - Semi-rapid 61.2% Right middle - Triple Crown 55.
867334619-B-082017 WWW.ZANUSSI.