User Manual GETTING STARTED? EASY.
SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference.
• • • • • • • • • • • • CAUTION: The appliance must not be supplied through an external switching device, such as a timer, or connected to a circuit that is regularly switched on and off by a utility. CAUTION: The cooking process has to be supervised. A short term cooking process has to be supervised continuously. WARNING: Danger of fire: Do not store items on the cooking surfaces. Metallic objects such as knives, forks, spoons and lids should not be placed on the hob surface since they can get hot.
guards incorporated in the appliance. The use of inappropriate guards can cause accidents. SAFETY INSTRUCTIONS This appliance is suitable for the following markets: • EG INSTALLATION WARNING! Only a qualified person must install this appliance. WARNING! Risk of injury or damage to the appliance. • • • • • • • • • • Remove all the packaging. Do not install or use a damaged appliance. Follow the installation instructions supplied with the appliance.
• • • Make sure that there is air circulation around the appliance. The information about the gas supply is on the rating plate. This appliance is not connected to a device, which evacuates the products of combustion. Make sure to connect the appliance according to current installation regulations. Pay attention to requirements regarding adequate ventilation. USE • • • • • • • • • • • • WARNING! Risk of injury, burns and electric shock.
SERVICE • To repair the appliance contact the Authorised Service Centre. • Use original spare parts only. DISPOSAL WARNING! Risk of injury or suffocation. • • • • Contact your municipal authority for information on how to discard the appliance correctly. Disconnect the appliance from the mains supply. Cut off the mains electrical cable close to the appliance and dispose of it. Flat the external gas pipes. INSTALLATION WARNING! Refer to Safety chapters.
WARNING! When installation is complete, make sure that the seal of each pipe fitting is correct. Use a soapy solution, not a flame! INJECTORS REPLACEMENT 1. Remove the pan supports. 2. Remove the caps and crowns of the burner. 3. With a socket spanner 7 remove the injectors and replace them with the ones which are necessary for the type of gas you use (see table in "Technical Data" chapter). 4. Assemble the parts, follow the same procedure backwards. 5.
ASSEMBLY 1. 5. 6. A 2. B 7. A) supplied seal B) supplied brackets 3. min. 100 mm min. 650 mm min. 55 mm 30 mm 470+20 mm 550+20 mm 4. 8 CAUTION! Install the appliance only on a worktop with flat surface. POSSIBILITIES FOR INSERTION The panel installed below the hob must be easy to remove and let an easy access in case a technical assistance intervention is necessary.
Kitchen unit with door A. Removable panel B. Space for connections 30 mm Kitchen unit with oven min 20 mm (max 150 mm) A 60 mm The electrical connection of the hob and the oven must be installed separately for safety reasons and to let easy remove oven from the unit.
BURNER OVERVIEW WARNING! Do not keep the control knob pushed for more than 15 seconds. If the burner does not light after 15 seconds, release the control knob, turn it into off position and try to light the burner again after minimum 1 minute. $ % CAUTION! In the absence of electricity you can ignite the burner without electrical device; in this case approach the burner with a flame, turn the control knob counter-clockwise to maximum gas supply position and push it down.
WARNING! Do not put the same pan on two burners. WARNING! Do not put unstable or damaged pots on the burner to prevent spills and injuries. CAUTION! Make sure that the bottoms of pots do not stand too close to the control knob, otherwise the flame heats the control knob up. CAUTION! Make sure that pot handles are not above the front edge of the cooktop. CAUTION! Make sure that the pots are placed centrally on the burner in order to get the maximum stability and a lower gas consumption.
• CLEANING THE HOB • Remove immediately: melted plastic, plastic foil, sugar and food with sugar, otherwise, the dirt can cause damage to the hob. Take care to avoid burns. • Remove when the hob is sufficiently cool: limescale rings, water rings, fat stains, shiny metallic discoloration. Clean the hob with a moist cloth and a non-abrasive detergent. After cleaning, wipe the hob dry with a soft cloth.
LABELS SUPPLIED WITH THE ACCESSORIES BAG Stick the adhesive labels as indicated below: A B MOD. MOD. PROD.NO. PROD.NO. SER.NO SER.NO DATA DATA C 0049 MOD. PROD.NO. SER.NO. TYPE IP20 03 IT MADE IN ITALY A. Stick it on Guarantee Card and send this part (if applicable). B. Stick it on Guarantee Card and keep this part (if applicable). C. Stick it on instruction booklet.
OTHER TECHNICAL DATA Gas original: G20 (2H) 20 mbar 7,65 kW TOTAL POWER: Gas replacement: G30 (3+) 28-30 mbar G31 (3+) 37 mbar 553 g/h 543 g/h Electric supply: 220-240 V ~ 50-60 Hz Appliance category: II2H3+ Gas connection: R 1/2" Appliance class: 3 GAS BURNERS FOR NATURAL GAS G20 20 mbar BURNER NORMAL POWER kW MINIMUM POWER kW INJECTOR MARK Rapid 2,95 0,75 119° Semi-rapid 1,85 0,6 92 Auxiliary 1,0 0,33 70 GAS BURNERS FOR LPG G30/G31 28-30/37 mbar NOMINAL GAS FLOW g/h BURNER N
867356412-B-252019 WWW.ZANUSSI.
