User Manual GETTING STARTED? EASY.
SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference.
• • • • • • • • • • • NEVER try to extinguish a fire with water, but switch off the appliance and then cover flame e.g. with a lid or a fire blanket. CAUTION: The cooking process has to be supervised. A short term cooking process has to be supervised continuously. WARNING: Danger of fire: Do not store items on the cooking surfaces. Metallic objects such as knives, forks, spoons and lids should not be placed on the hob surface since they can get hot. Do not use a steam cleaner to clean the appliance.
SAFETY INSTRUCTIONS This appliance is suitable for the following markets: • GB IE INSTALLATION WARNING! Only a qualified person must install this appliance. WARNING! Risk of injury or damage to the appliance. • • • • • • • • • • • • Remove all the packaging. Do not install or use a damaged appliance. Follow the installation instructions supplied with the appliance. Keep the minimum distance from other appliances and units. Always take care when moving the appliance as it is heavy.
• • The information about the gas supply is on the rating plate. This appliance is not connected to a device, which evacuates the products of combustion. Make sure to connect the appliance according to current installation regulations. Pay attention to requirements regarding adequate ventilation. USE • • • • • • • • • • • WARNING! Risk of injury, burns and electric shock. • • Remove all the packaging, labelling and protective film (if applicable) before first use.
• DISPOSAL WARNING! Risk of injury or suffocation. • • Contact your municipal authority for information on how to discard the appliance correctly. • Disconnect the appliance from the mains supply. Cut off the mains electrical cable close to the appliance and dispose of it. Flat the external gas pipes.
BURNER OVERVIEW WARNING! Do not keep the control knob pushed for more than 15 seconds. If the burner does not light after 15 seconds, release the control knob, turn it into off position and try to light the burner again after minimum 1 minute. A CAUTION! In the absence of electricity you can ignite the burner without electrical device; in this case approach the burner with a flame, turn the control knob counter-clockwise to maximum gas supply position and push it down.
WARNING! Do not put unstable or damaged pots on the burner to prevent spills and injuries. CAUTION! Make sure that the bottoms of pots do not stand too close to the control knob, otherwise the flame heats the control knob up. CAUTION! Liquids spilt during cooking can cause the glass to break. DIAMETERS OF COOKWARE Use cookware with diameters applicable to the size of burners. CAUTION! Make sure that pot handles are not above the front edge of the cooktop.
TROUBLESHOOTING WARNING! Refer to Safety chapters. WHAT TO DO IF... Problem There is no spark when you try to activate the spark generator. Possible cause Remedy The hob is not connected to an electrical supply or it is connected incorrectly. Check if the hob is correctly connected to the electrical supply. The fuse is blown. Make sure that the fuse is the cause of the malfunction. If the fuse is blown again and again, contact a qualified electrician. Burner cap and crown are placed incorrectly.
LABELS SUPPLIED WITH THE ACCESSORIES BAG Stick the adhesive labels as indicated below: A B MOD. MOD. PROD.NO. PROD.NO. SER.NO SER.NO DATA DATA C 0049 MOD. PROD.NO. SER.NO. TYPE IP20 03 IT MADE IN ITALY A. Stick it on Guarantee Card and send this part (if applicable). B. Stick it on Guarantee Card and keep this part (if applicable). C. Stick it on instruction booklet. INSTALLATION WARNING! Refer to Safety chapters. 813 Current Editions and the ETCI Rules for Electrical Installations.
should be consulted to determine the requisite air vent requirements. For appliances installed in the Republic of Ireland please refer to the NSAI- Domestic Gas Installation I.S. 813 Current Editions Table Four. Location The hob may be located in a kitchen, a kitchen/ diner or bed sitting room (with a volume greater than 20 m³), but not in a bathroom or shower room. The minimum distance combustible material can be fitted above the hob in line with the edges of the hob is 400 mm.
A 5. If you change: • from natural gas G20 20 mbar to liquid gas, fully tighten the bypass screw in. • from liquid gas to natural gas G20 20 mbar, undo the bypass screw approximately 1/4 of a turn. • or E — Earth terminal Before carrying out the connection, make sure: 1. The limiter valve and the electrical system can take the appliance load (see the rating plate) 2. The supply system is equipped with an efficient earth connection in compliance with the current standards and regulations 3.
REPLACEMENT OF THE CONNECTION CABLE ASSEMBLY 1. The replacement of electric cable must be carried out exclusively by the service force centre or by personnel with similar competencies, in accordance with the current regulations. To replace the connection cable use only H03V2V2-F T90 or equivalent type. Make sure that the cable section is applicable to the voltage load and the working temperature. The yellow/ green earth wire (B) must be approximately 2 cm longer than the live and neutral wire (A). 2.
4. 8. min. 600 mm min. 100 mm min. 12 mm min. 650 mm min. 55 mm 30 mm 470 02 mm + 550+02 mm CAUTION! Install the appliance only on a worktop with flat surface. 5. POSSIBILITIES FOR INSERTION Kitchen unit with door or drawer 400 mm 50 mm The panel installed below the hob must be easy to remove and let an easy access in case a technical assistance intervention is necessary.
min. 30 mm min.
GAS BURNERS FOR NATURAL GAS G20 20 mbar BURNER NORMAL POWER kW MINIMUM POWER kW INJECTOR MARK Rapid 2,9 0,75 119 Semi-rapid 1,9 0,45 96 Auxiliary 1,0 0,33 70 GAS BURNERS FOR LPG G30/G31 28-30/37 mbar NOMINAL GAS FLOW g/h BURNER NORMAL POWER kW MINIMUM POWER kW INJECTOR MARK G30 28-30 mbar G31 37 mbar Rapid 2,7 0,75 86 196 193 Semi-rapid 1,9 0,45 71 138 136 Auxiliary 1,0 0,33 50 73 71 ENERGY EFFICIENCY PRODUCT INFORMATION ACCORDING TO EU 66/2014 Model identification ZGO
ENVIRONMENTAL CONCERNS with the symbol with the household waste. Return the product to your local recycling facility or contact your municipal office. Recycle materials with the symbol . Put the packaging in relevant containers to recycle it. Help protect the environment and human health by recycling waste of electrical and electronic appliances.
867345617-A-132018 WWW.ZANUSSI.