User manual

thermocouple warm up. If not, the gas
supply is interrupted.
3. Adjust the flame after it is regular.
If after some tries the burner does
not light, check if the crown and its
cap are in correct positions.
WARNING!
Do not keep the control knob
pushed for more than 15 seconds. If
the burner does not light after 15
seconds, release the control knob,
turn it into off position and try to light
the burner again after minimum 1
minute.
CAUTION!
In the absence of electricity you can
ignite the burner without electrical
device; in this case approach the
burner with a flame, turn the control
knob counter-clockwise to maximum
gas supply position and push it
down. Keep the control knob
pushed for equal or less than 10
seconds to let the thermocouple
warm up.
If the burner accidentally goes out,
turn the control knob to the off
position and try to light the burner
again after minimum 1 minute.
The spark generator can start
automatically when you switch on
the mains, after installation or a
power cut. It is normal.
Turning the burner off
To put the flame out, turn the knob to the off
position .
WARNING!
Always turn the flame down or
switch it off before you remove the
pans from the burner.
Hints and tips
WARNING!
Refer to Safety chapters.
Cookware
CAUTION!
Do not use cast iron pans,
potstones, earthenware, grill or
toaster plates. The stainless steel
can become tarnished if it is too
much heated.
WARNING!
Do not put the same pan on two
burners.
WARNING!
Do not put unstable or damaged
pots on the burners to prevent from
spill and injury.
CAUTION!
Make sure that the bottoms of pots
do not stand above the control
knobs, otherwise the flame heats the
control knobs up.
CAUTION!
Make sure that pot handles are not
above the front edge of the cooktop.
CAUTION!
Make sure that the pots are placed
centrally on the burners in order to
get maximum stability and to get
lower gas consumption.
Diameters of cookware
Use cookware with diameters
applicable to the size of burners.
www.zanussi.com 7