User Manual GETTING STARTED? EASY.
SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference.
• • • • • • • • • • CAUTION: The appliance must not be supplied through an external switching device, such as a timer, or connected to a circuit that is regularly switched on and off by a utility. CAUTION: The cooking process has to be supervised. A short term cooking process has to be supervised continuously. WARNING: Danger of fire: Do not store items on the cooking surfaces. Metallic objects such as knives, forks, spoons and lids should not be placed on the hob surface since they can get hot.
• • • • • • • Keep the minimum distance from other appliances and units. Always take care when moving the appliance as it is heavy. Always use safety gloves and enclosed footwear. Seal the cut surfaces with a sealant to prevent moisture to cause swelling. Protect the bottom of the appliance from steam and moisture. Do not install the appliance adjacent to a door or under a window. This prevents hot cookware falling from the appliance when the door or the window is opened.
WARNING! Risk of fire and explosion • • • • Fats and oil when heated can release flammable vapours. Keep flames or heated objects away from fats and oils when you cook with them. The vapours that very hot oil releases can cause spontaneous combustion. Used oil, that can contain food remnants, can cause fire at a lower temperature than oil used for the first time. Do not put flammable products or items that are wet with flammable products in, near or on the appliance.
Model ....................................... PNC ......................................... Serial number ........................... GAS CONNECTION WARNING! The following instructions about installation, connection and maintenance must be carried out by qualified personnel in compliance with standards and local regulations in force. Choose fixed connections or use a flexible pipe in stainless steel in compliance with the regulation in force.
WARNING! Pay attention not to damage the gasket. Do not use sharp tool to remove it. 4. With a thin screwdriver, adjust the bypass screw position (A). A 5. If you change: • from natural gas G20 20 mbar to liquid gas, fully tighten the bypass screw in. • from liquid gas to natural gas G20 20 mbar, undo the bypass screw approximately 1/4 of a turn (1/2 of a turn for Multi Crown burner). 6. Reassemble the gasket and the knob. WARNING! Make sure to place the gasket exactly in the original position.
CONNECTION CABLE To replace the connection cable use only the special cable or its equivalent. The cable type is: H03V2V2-F T90. Make sure that the cable section is applicable to the voltage and the working temperature. The yellow / green earth wire must be approximately 2 cm longer than the brown (or black) phase wire. ASSEMBLY 1. 4. 5. 6. 2. 7. A 3. min. 100 mm min. 650 mm B min. 55 mm 30 mm 480+02 mm 8 +2 560 0 mm 8. A. Supplied seal B.
A CAUTION! Install the appliance only on a worktop with flat surface. POSSIBILITIES FOR INSERTION The panel installed below the hob must be easy to remove and let an easy access in case a technical assistance intervention is necessary. Kitchen unit with door B min 30 mm min 5 mm (max 150 mm) 60 mm A. Removable panel B.
DAILY USE WARNING! Refer to Safety chapters. BURNER OVERVIEW $ 1. Push the control knob down and turn it counterclockwise to the maximum gas supply % position ( ). 2. Keep the control knob pushed for equal or less than 10 seconds. This lets the thermocouple warm up. If not, the gas supply is interrupted. 3. Adjust the flame after it is regular. & ' $ % & ' A. B. C. D.
TURNING THE BURNER OFF To put the flame out, turn the knob to the off position WARNING! Always turn the flame down or switch it off before you remove the pans from the burner. . HINTS AND TIPS WARNING! Refer to Safety chapters. CAUTION! Make sure that the pots are placed centrally on the burner in order to get the maximum stability and a lower gas consumption. COOKWARE CAUTION! Do not use cast iron pans, clay or earthenware pots, grill or toaster plates.
Be very careful when you replace the pan supports to prevent the hob top from damage. 2. The enamel coating occasionally can have rough edges, so be careful when you wash the pan supports by hand and dry them. If necessary, remove stubborn stains with a paste cleaner. 3. After you clean the pan supports, make sure that they are in correct positions. 4. For the burner to operate correctly, make sure that the arms of the pan supports are aligned with the centre of the burner.
Problem Possible cause Remedy The fuse is blown. Make sure that the fuse is the cause of the malfunction. If the fuse is blown again and again, contact a qualified electrician. Burner cap and crown are placed incorrectly. Place the burner cap and crown correctly. The flame extinguishes immediately after ignition. Thermocouple is not heated up sufficiently. After lightning the flame, keep the knob pushed for equal or less than 10 seconds. The flame ring is uneven.
TECHNICAL DATA HOB DIMENSIONS Width 595 mm Depth 510 mm BYPASS DIAMETERS BURNER Ø BYPASS 1/100 mm Multi Crown 57 Semi-rapid 32 Auxiliary 28 OTHER TECHNICAL DATA Gas original: G20 (2H) 20 mbar 9 kW TOTAL POWER: Gas replacement: G30 (3+) 28-30 mbar G31 (3+) 37 mbar 629 g/h 618 g/h Electric supply: 220-240 V ~ 50-60 Hz Appliance category: II2H3+ Gas connection: R 1/2" Appliance class: 3 GAS BURNERS FOR NATURAL GAS G20 20 mbar BURNER NORMAL POWER kW MINIMUM POWER kW INJECTOR MARK M
NOMINAL GAS FLOW g/h BURNER NORMAL POWER kW MINIMUM POWER kW INJECTOR MARK G30 28-30 mbar Auxiliary 1,0 0,33 50 73 G31 37 mbar 71 ENVIRONMENTAL CONCERNS with the symbol with the household waste. Return the product to your local recycling facility or contact your municipal office. Recycle materials with the symbol . Put the packaging in relevant containers to recycle it. Help protect the environment and human health by recycling waste of electrical and electronic appliances.
867356414-B-252019 WWW.ZANUSSI.