User Manual GETTING STARTED? EASY.
SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference.
• • • • • • • • CAUTION: The cooking process has to be supervised. A short term cooking process has to be supervised continuously. WARNING: Danger of fire: Do not store items on the cooking surfaces. Metallic objects such as knives, forks, spoons and lids should not be placed on the hob surface since they can get hot. Do not use a steam cleaner to clean the appliance.
• • • appliance and the upper drawer, is sufficient for air circulation. The underside of the appliance can get hot when in use. If an oven has not been fitted underneath the hob and underside of the appliance is accessible and could allow a user or items stored beneath the hob to come in direct contact with the underside of the hob, an intermediate protection panel must be fitted. Plywood or kitchen carcass material is acceptable for the panel. The panel must be removable for servicing.
• • • The vapours that very hot oil releases can cause spontaneous combustion. Used oil, that can contain food remnants, can cause fire at a lower temperature than oil used for the first time. Do not put flammable products or items that are wet with flammable products in, near or on the appliance. WARNING! Risk of damage to the appliance. • • • • • • • • • • • • • • Do not keep hot cookware on the control panel. Do not let cookware to boil dry.
PRODUCT DESCRIPTION COOKING SURFACE LAYOUT 1 2 1 Semi-rapid burner 2 Rapid burner 3 Auxiliary burner 4 Control knobs 4 3 CONTROL KNOB Symbol Description no gas supply / off position ignition position / maximum gas supply DAILY USE WARNING! Refer to Safety chapters.
BURNER OVERVIEW 3. Adjust the flame after it is regular. If after some tries the burner does not light, check if the crown and its cap are in correct positions. WARNING! Do not keep the control knob pushed for more than 15 seconds. If the burner does not light after 15 seconds, release the control knob, turn it into off position and try to light the burner again after minimum 1 minute.
WARNING! Do not put unstable or damaged pots on the burner to prevent from spill and injury. DIAMETERS OF COOKWARE Use cookware with diameters applicable to the size of burners. CAUTION! Make sure that the bottoms of pots do not stand above the control knob, otherwise the flame heats the control knob up. CAUTION! Make sure that pot handles are not above the front edge of the cooktop.
• • can cause damage to the hob. Take care to avoid burns. Remove when the hob is sufficiently cool: limescale rings, water rings, fat stains, shiny metallic discoloration. Clean the hob with a moist cloth and non-abrasive detergent. After cleaning, wipe the hob dry with a soft cloth. To clean the enamelled parts, cap and crown, wash them with warm soapy water and dry them carefully before you put them back on.
IF YOU CANNOT FIND A SOLUTION... If you cannot find a solution to the problem yourself, contact your dealer or an Authorised Service Centre. Give the data from the rating plate. Make sure, you operated the hob correctly. If not the servicing by a service technician or dealer will not be free of charge, also during the warranty period. A The instructions about the Service Centre and conditions of guarantee are in the guarantee booklet.
installed in a room of volume between 5 m³ and 10 m³ an air vent of effective area of 50 cm² is required, while if the volume exceeds 11 m³ no air vent is required. However, if the room has a door which opens directly to the outside no air vent is required even if the volume is between 5 m³ and 11 m³. If there are other fuel burning appliances in the same room, B.S. 5440 Part 2 Current Edition, should be consulted to determine the requisite air vent requirements.
2. Turn the knob on the minimum position. 3. Remove the knob. 4. With a thin screwdriver, adjust the bypass screw position (A). A 5. If you change: • from natural gas G20 20 mbar to liquid gas, fully tighten the bypass screw in. • from liquid gas to natural gas G20 20 mbar, undo the bypass screw approximately 1/4 of a turn. The hob has a terminal block which is marked as follows: • L — Live terminal • N — Neutral terminal • or E — Earth terminal Before carrying out the connection, make sure: 1.
REPLACEMENT OF THE CONNECTION CABLE ASSEMBLY 1. The replacement of electric cable must be carried out exclusively by the service force centre or by personnel with similar competencies, in accordance with the current regulations. To replace the connection cable use only H03V2V2-F T90 or equivalent type. Make sure that the cable section is applicable to the voltage load and the working temperature. The yellow/ green earth wire (B) must be approximately 2 cm longer than the live and neutral wire (A).
If a furniture unit is installed at a distance of 400 mm above the hob, there must be a minimum safety distance of 50 mm to the left or right from the edge of the hob. 10. A) supplied seal B) supplied brackets 5. 11. 6. CAUTION! Install the appliance only on a worktop with flat surface. POSSIBILITIES FOR INSERTION The panel installed below the hob must be easy to remove and let an easy access in case a technical assistance intervention is necessary. 7. Kitchen unit with door or drawer 8.
Kitchen unit with oven The electrical connection of the hob and the oven must be installed separately for safety reasons and to let easy remove oven from the unit.
GAS BURNERS FOR LPG G30/G31 28-30/37 MBAR NOMINAL GAS FLOW g/h BURNER NORMAL POWER kW MINIMUM POWER kW INJECTOR MARK G30 28-30 mbar G31 37 mbar Rapid 2,8 0,75 86 204 200 Semi-rapid 2,0 0,45 71 145 143 Auxiliary 1,0 0,33 50 73 71 ENERGY EFFICIENCY PRODUCT INFORMATION ACCORDING TO EU 66/2014 Model identification ZGG65411XB; ZGG65414XB; ZGG65414XS; ZGG65XS414 Type of hob Built-in hob Number of gas burners 4 Energy efficiency per gas burner (EE gas burner) Left rear - Semi-rapid 6
867334614-B-082017 WWW.ZANUSSI.